Home
last modified time | relevance | path

Searched refs:AP (Results 1 – 12 of 12) sorted by relevance

/drivers/net/wireless/intersil/hostap/
DKconfig2 tristate "IEEE 802.11 for Host AP (Prism2/2.5/3 and WEP/TKIP/CCMP)"
20 Host AP mode that allows the card to act as an IEEE 802.11
24 Host AP driver configuration and tools. This site includes
28 This option includes the base Host AP driver code that is shared by
36 bool "Support downloading firmware images with Host AP driver"
39 Configure Host AP driver to include support for firmware image
52 Allow Host AP driver to write firmware images to the non-volatile
61 tristate "Host AP driver for Prism2/2.5/3 in PLX9052 PCI adaptors"
64 Host AP driver's version for Prism2/2.5/3 PC Cards in PLX9052 based
67 "Host AP support for Prism2/2.5/3 IEEE 802.11b" is required for this
[all …]
/drivers/ide/
Dpdc202xx_old.c30 u8 AP = 0, BP = 0, CP = 0; in pdc202xx_set_mode() local
33 pci_read_config_byte(dev, drive_pci, &AP); in pdc202xx_set_mode()
60 AP &= ~0x3f; in pdc202xx_set_mode()
62 AP |= 0x20; /* set IORDY_EN bit */ in pdc202xx_set_mode()
64 AP |= 0x10; /* set Prefetch_EN bit */ in pdc202xx_set_mode()
67 pci_write_config_byte(dev, drive_pci, AP | TA); in pdc202xx_set_mode()
/drivers/staging/rtl8188eu/
DKconfig13 bool "Realtek RTL8188EU AP mode"
17 will never be used as an AP, or the target system has limited memory,
/drivers/net/wireless/marvell/mwifiex/
DREADME45 The above command can be used to connect to an AP with a particular SSID.
46 Ap's operating frequency can be specified or even the bssid. If the AP is using
48 …Note: Every time before connecting to an AP scan command (iw dev mlan0 scan) should be used by use…
51 This command will be used to disconnect from an AP.
/drivers/clk/versatile/
DKconfig9 - Integrator/AP and Integrator/CP
/drivers/staging/wilc1000/
Dwilc_wlan_if.h90 AP, enumerator
/drivers/firmware/
DKconfig17 Cores(AP) and the System Control Processor(SCP). The MHU peripheral
19 and AP.
/drivers/staging/greybus/Documentation/
Dsysfs-bus-greybus224 The AP interface ID, a 1-byte non-zero integer which
225 defines the position of the AP module on the frame.
/drivers/net/wireless/marvell/libertas/
DREADME172 echo "LINKSYS-AP" > extscan
/drivers/staging/greybus/Documentation/firmware/
Dfirmware-management11 Firmware Management Protocol. To support Firmware Management by the AP, the
/drivers/input/serio/
DKconfig266 tristate "OLPC AP-SP input support"
/drivers/tty/serial/
DKconfig27 an Integrator/AP or Integrator/PP2 platform, or if you have a