| /drivers/rtc/ |
| D | rtc-coh901331.c | 57 clk_enable(rtap->clk); in coh901331_interrupt()
80 clk_enable(rtap->clk); in coh901331_read_time()
95 clk_enable(rtap->clk); in coh901331_set_mmss()
106 clk_enable(rtap->clk); in coh901331_read_alarm()
121 clk_enable(rtap->clk); in coh901331_set_alarm()
133 clk_enable(rtap->clk); in coh901331_alarm_irq_enable()
226 clk_enable(rtap->clk); in coh901331_suspend()
243 clk_enable(rtap->clk); in coh901331_resume()
257 clk_enable(rtap->clk); in coh901331_shutdown()
|
| D | rtc-pic32.c | 81 clk_enable(pdata->clk); in pic32_rtc_alarm_clk_enable()
97 clk_enable(pdata->clk); in pic32_rtc_alarmirq()
111 clk_enable(pdata->clk); in pic32_rtc_setaie()
129 clk_enable(pdata->clk); in pic32_rtc_setfreq()
146 clk_enable(pdata->clk); in pic32_rtc_gettime()
196 clk_enable(pdata->clk); in pic32_rtc_settime()
215 clk_enable(pdata->clk); in pic32_rtc_getalarm()
249 clk_enable(pdata->clk); in pic32_rtc_setalarm()
270 clk_enable(pdata->clk); in pic32_rtc_proc()
296 clk_enable(pdata->clk); in pic32_rtc_enable()
|
| /drivers/watchdog/ |
| D | coh901327_wdt.c | 93 clk_enable(clk); in coh901327_enable()
132 clk_enable(clk); in coh901327_disable()
168 clk_enable(clk); in coh901327_ping()
180 clk_enable(clk); in coh901327_settimeout()
194 clk_enable(clk); in coh901327_gettimeleft()
224 clk_enable(clk); in coh901327_interrupt()
|
| /drivers/video/fbdev/omap/ |
| D | sossi.c | 231 clk_enable(sossi.fck); in _set_timing()
419 clk_enable(sossi.fck); in sossi_setup_tearsync()
460 clk_enable(sossi.fck); in sossi_write_command()
475 clk_enable(sossi.fck); in sossi_write_data()
496 clk_enable(sossi.fck); in sossi_transfer_area()
532 clk_enable(sossi.fck); in sossi_read_data()
614 clk_enable(sossi.fck); in sossi_init()
|
| /drivers/pinctrl/nomadik/ |
| D | pinctrl-nomadik.c | 558 clk_enable(chip->clk); in nmk_gpio_glitch_slpm_init()
620 clk_enable(nmk_chip->clk); in nmk_gpio_irq_ack()
693 clk_enable(nmk_chip->clk); in nmk_gpio_irq_maskunmask()
728 clk_enable(nmk_chip->clk); in nmk_gpio_irq_set_wake()
762 clk_enable(nmk_chip->clk); in nmk_gpio_irq_set_type()
795 clk_enable(nmk_chip->clk); in nmk_gpio_irq_startup()
831 clk_enable(nmk_chip->clk); in nmk_gpio_irq_handler()
854 clk_enable(nmk_chip->clk); in nmk_gpio_get_dir()
867 clk_enable(nmk_chip->clk); in nmk_gpio_make_input()
881 clk_enable(nmk_chip->clk); in nmk_gpio_get_input()
[all …]
|
| /drivers/pwm/ |
| D | pwm-mtk-disp.c | 109 err = clk_enable(mdp->clk_main); in mtk_disp_pwm_config()
113 err = clk_enable(mdp->clk_mm); in mtk_disp_pwm_config()
146 err = clk_enable(mdp->clk_main); in mtk_disp_pwm_enable()
150 err = clk_enable(mdp->clk_mm); in mtk_disp_pwm_enable()
|
| D | pwm-ep93xx.c | 86 ret = clk_enable(ep93xx_pwm->clk); in ep93xx_pwm_config()
132 ret = clk_enable(ep93xx_pwm->clk); in ep93xx_pwm_polarity()
151 ret = clk_enable(ep93xx_pwm->clk); in ep93xx_pwm_enable()
|
| D | pwm-spear.c | 124 ret = clk_enable(pc->clk); in spear_pwm_config()
143 rc = clk_enable(pc->clk); in spear_pwm_enable()
206 ret = clk_enable(pc->clk); in spear_pwm_probe()
|
| D | pwm-meson.c | 231 u32 value, clk_shift, clk_enable, enable; in meson_pwm_enable() local
237 clk_enable = MISC_A_CLK_EN; in meson_pwm_enable()
244 clk_enable = MISC_B_CLK_EN; in meson_pwm_enable()
256 value |= clk_enable; in meson_pwm_enable()
|
| D | pwm-atmel.c | 143 ret = clk_enable(atmel_pwm->clk); in atmel_pwm_config()
225 ret = clk_enable(atmel_pwm->clk); in atmel_pwm_set_polarity()
243 ret = clk_enable(atmel_pwm->clk); in atmel_pwm_enable()
|
| D | pwm-rockchip.c | 148 ret = clk_enable(pc->clk); in rockchip_pwm_get_state()
203 ret = clk_enable(pc->clk); in rockchip_pwm_enable()
227 ret = clk_enable(pc->clk); in rockchip_pwm_apply()
|
| D | pwm-sti.c | 199 ret = clk_enable(pc->pwm_clk); in sti_pwm_config()
203 ret = clk_enable(pc->cpt_clk); in sti_pwm_config()
267 ret = clk_enable(pc->pwm_clk); in sti_pwm_enable()
271 ret = clk_enable(pc->cpt_clk); in sti_pwm_enable()
|
| /drivers/pinctrl/stm32/ |
| D | pinctrl-stm32.c | 132 clk_enable(bank->clk); in __stm32_gpio_set()
154 clk_enable(bank->clk); in stm32_gpio_get()
545 clk_enable(bank->clk); in stm32_pmx_set_mode()
570 clk_enable(bank->clk); in stm32_pmx_get_mode()
644 clk_enable(bank->clk); in stm32_pconf_set_driving()
662 clk_enable(bank->clk); in stm32_pconf_get_driving()
680 clk_enable(bank->clk); in stm32_pconf_set_speed()
698 clk_enable(bank->clk); in stm32_pconf_get_speed()
716 clk_enable(bank->clk); in stm32_pconf_set_bias()
734 clk_enable(bank->clk); in stm32_pconf_get_bias()
[all …]
|
| /drivers/input/serio/ |
| D | at32psif.c | 160 retval = clk_enable(psif->pclk); in psif_open()
198 clk_enable(psif->pclk); in psif_set_prescaler()
251 ret = clk_enable(pclk); in psif_probe()
340 clk_enable(psif->pclk); in psif_resume()
|
| /drivers/fpga/ |
| D | zynq-fpga.c | 187 err = clk_enable(priv->clk); in zynq_fpga_ops_write_init()
305 err = clk_enable(priv->clk); in zynq_fpga_ops_write()
352 err = clk_enable(priv->clk); in zynq_fpga_ops_write_complete()
388 err = clk_enable(priv->clk); in zynq_fpga_ops_state()
|
| /drivers/thermal/ |
| D | spear_thermal.c | 82 ret = clk_enable(stdev->clk); in spear_thermal_resume()
129 ret = clk_enable(stdev->clk); in spear_thermal_probe()
|
| /drivers/i2c/busses/ |
| D | i2c-sirf.c | 244 clk_enable(siic->clk); in i2c_sirfsoc_xfer()
298 err = clk_enable(clk); in i2c_sirfsoc_probe()
428 clk_enable(siic->clk); in i2c_sirfsoc_suspend()
441 clk_enable(siic->clk); in i2c_sirfsoc_resume()
|
| /drivers/input/keyboard/ |
| D | spear-keyboard.c | 110 error = clk_enable(kbd->clk); in spear_kbd_open()
301 clk_enable(kbd->clk); in spear_kbd_suspend()
359 clk_enable(kbd->clk); in spear_kbd_resume()
|
| D | st-keyscan.c | 66 error = clk_enable(keypad->clk); in keyscan_start()
184 error = clk_enable(keypad_data->clk); in keyscan_probe()
|
| /drivers/usb/host/ |
| D | ehci-sh.c | 133 clk_enable(priv->fclk); in ehci_hcd_sh_probe()
134 clk_enable(priv->iclk); in ehci_hcd_sh_probe()
|
| /drivers/usb/musb/ |
| D | am35x.c | 494 ret = clk_enable(phy_clk); in am35x_probe()
500 ret = clk_enable(clk); in am35x_probe()
600 ret = clk_enable(glue->phy_clk); in am35x_resume()
606 ret = clk_enable(glue->clk); in am35x_resume()
|
| /drivers/usb/dwc3/ |
| D | dwc3-exynos.c | 271 clk_enable(exynos->clk); in dwc3_exynos_resume()
272 clk_enable(exynos->axius_clk); in dwc3_exynos_resume()
|
| /drivers/thermal/samsung/ |
| D | exynos_tmu.c | 360 clk_enable(data->clk); in exynos_tmu_initialize()
362 clk_enable(data->clk_sec); in exynos_tmu_initialize()
399 clk_enable(data->clk); in exynos_tmu_control()
897 clk_enable(data->clk); in exynos_get_temp()
980 clk_enable(data->clk); in exynos_tmu_set_emulation()
1026 clk_enable(data->clk_sec); in exynos_tmu_work()
1038 clk_enable(data->clk); in exynos_tmu_work()
|
| /drivers/gpu/host1x/ |
| D | mipi.c | 153 err = clk_enable(mipi->clk); in tegra_mipi_power_up()
179 err = clk_enable(mipi->clk); in tegra_mipi_power_down()
320 err = clk_enable(device->mipi->clk); in tegra_mipi_calibrate()
|
| /drivers/base/regmap/ |
| D | regmap-mmio.c | 131 ret = clk_enable(ctx->clk); in regmap_mmio_write()
188 ret = clk_enable(ctx->clk); in regmap_mmio_read()
|