Lines Matching full:method

67 The RapidIO subsystem defines the format and initialization method for subsystem
121 An enumeration/discovery method implementation and available input parameters
122 define how any given method can be attached to available RapidIO mports:
130   parameters. This was the original method used since introduction of RapidIO
131   subsystem. Now this method relies on enumerator module parameter which is
132   'rio-scan.scan' for existing basic enumeration/discovery method.
144   a command from user space. This initiation method provides more flexibility
175   to the method shown above, the host destination ID(s) can be specified using
204 Automatic enumeration/discovery start method is applicable only to built-in
206 enumeration/discovery start by existing basic enumerator method set use boot
216 When automatic enumeration/discovery start is selected, basic method's
221 enumeration/discovery start method may be difficult to use due to the
239 4.4 Basic Enumeration Method
242 This is an original enumeration/discovery method which is available since
247 This method can be configured as statically linked or loadable module.
248 The method's single parameter "scan" allows to trigger the enumeration/discovery
251 This enumeration/discovery method can be started only once and does not support
307 4.5 Adding New Enumeration/Discovery Method
314 A new enumeration/discovery method has to be attached to one or more mport
316 method's module initialization routine calls rio_register_scan() to attach