Lines Matching refs:at

57 	  you may take a look at "Serial ATA (prod) and Parallel ATA
131 	  If you say Y here, the CD-ROM drive will be identified at boot time
162 	  If you say Y here, the tape drive will be identified at boot time
211 	  and the controller is located at legacy ports, this driver
333 	  Please read the comments at the top of <file:drivers/ide/opti621.c>.
345 	  Linux. This may slow disk throughput by a few percent, but at least
370 	  Please read the comments at the top of
480 	  should use the fore mentioned option and call at LILO.
483 	  ide-probe at boot. It is reported to support DVD II drives, by the
536 	  Please read the comments at the top of <file:drivers/ide/ns87415.c>.
551 	  at boot-time for max-speed.  Ultra33 BIOS 1.25 or newer is required
554 	  Please read the comments at the top of
592 	  Please read the comments at the top of <file:drivers/ide/sis5513.c>.
614 	  Please read the comments at the top of
624 	  Please read the comments at the top of <file:drivers/ide/trm290.c>.
728 	  the Amiga's on-board IDE interface. The feature is enabled at kernel
799 	  of I/O ports at 0x1f0 to control up to four drives, instead of the
800 	  customary two drives per port. Support for this can be enabled at
809 	  This driver is enabled at runtime using the "ali14xx.probe" kernel
821 	  This driver is enabled at runtime using the "dtc2278.probe" kernel
832 	  This driver is enabled at runtime using the "ht6560b.probe" kernel
843 	  This driver is enabled at runtime using the "qd65xx.probe" kernel
853 	  This driver is enabled at runtime using the "umc8672.probe" kernel