Searched full:pdif (Results 1 – 25 of 25) sorted by relevance
| /Documentation/devicetree/bindings/sound/ |
| D | imx-audio-spdif.txt | 1 Freescale i.MX audio complex with S/PDIF transceiver
9 - spdif-controller : The phandle of the i.MX S/PDIF controller
15 transmitting function of S/PDIF will be enabled,
16 indicating there's a physical S/PDIF out connector
22 function of S/PDIF will be enabled, indicating there
23 is a physical S/PDIF in connector/jack on the board.
|
| D | uniphier,aio.txt | 3 The Socionext UniPhier audio subsystem consists of I2S and S/PDIF blocks in
12 - interrupts : should contain I2S or S/PDIF interrupt.
27 The soc-glue is used for changing mode of S/PDIF signal pin
|
| D | st,stm32-spdifrx.txt | 1 STMicroelectronics STM32 S/PDIF receiver (SPDIFRX).
3 The SPDIFRX peripheral, is designed to receive an S/PDIF flow compliant with
9 - clocks: must contain an entry for kclk (used as S/PDIF signal reference)
|
| D | armada-370db-audio.txt | 17 2/ the S/PDIF transceiver
18 3/ the S/PDIF receiver
|
| D | fsl,spdif.txt | 1 Freescale Sony/Philips Digital Interface Format (S/PDIF) Controller
3 The Freescale S/PDIF audio block is a stereo transceiver that allows the
|
| D | ak4118.txt | 1 AK4118 S/PDIF transceiver
|
| D | ak4104.txt | 1 AK4104 S/PDIF transmitter
|
| D | renesas,fsi.txt | 13 - fsia,spdif-connection : FSI is connected by S/PDIF
|
| D | rockchip-spdif.txt | 3 The S/PDIF audio block is a stereo transceiver that allows the
|
| D | fsl,esai.txt | 5 standard codecs, Sony/Phillips Digital Interface (S/PDIF) transceivers, and
|
| D | allwinner,sun4i-a10-spdif.yaml | 7 title: Allwinner A10 S/PDIF Controller Device Tree Bindings
|
| D | fsl-asoc-card.txt | 18 AC'97/I2S/PCM type sound cards, such as S/PDIF audio and HDMI audio, as
|
| D | simple-card.txt | 164 simple-audio-card,dai-link@1 { /* S/PDIF - HDMI */
174 simple-audio-card,dai-link@2 { /* S/PDIF - S/PDIF */
|
| D | davinci-mcasp-audio.txt | 15 - op-mode : I2S/DIT ops mode. 0 for I2S mode. 1 for DIT mode used for S/PDIF,
|
| D | st,stm32-sai.txt | 52 - st,iec60958: support S/PDIF IEC6958 protocol for playback
|
| /Documentation/sound/cards/ |
| D | maya44.rst | 39 - Channel 3+4 analogue - S/PDIF input switching
40 - S/PDIF output
118 * hw:0,1 input - stereo, analog input 3+4 OR S/PDIF input
153 switch for S/PDIF output.
156 S/PDIF should output the same signal as channel 3+4. [untested!]
177 Possibly some of these control S/PDIF output(s).
|
| D | sb-live-mixer.rst | 15 IEC958 (S/PDIF) raw PCM
55 S/PDIF
235 If this switch is on, then the samples for the IEC958 (S/PDIF) digital
|
| D | multisound.sh | 30 # the digital daughterboard (see the section on using the S/PDIF port
250 # digital Specify digital=1 to enable the S/PDIF input
323 # non-PnP mode, and setdigital can be used to set the S/PDIF input on
345 # Using Digital I/O with the S/PDIF Port
352 # during compiled-in kernel operation). Upon selection of the S/PDIF
355 # There is something to note about using the S/PDIF port. Digital
|
| D | audigy-mixer.rst | 41 S/PDIF
220 If this switch is on, then the samples for the IEC958 (S/PDIF) digital
|
| D | cmipci.rst | 138 so-called S/PDIF). Then you'll see the red light on from the card so
|
| /Documentation/devicetree/bindings/display/ |
| D | amlogic,meson-dw-hdmi.yaml | 41 HDMI TX IP version 2.01a with HDCP and I2C & S/PDIF
|
| /Documentation/devicetree/bindings/display/bridge/ |
| D | adi,adv7511.txt | 6 S/PDIF, CEC and HDCP. ADV7533 supports the DSI interface for input pixels, while
|
| /Documentation/sound/designs/ |
| D | control-names.rst | 128 IEC958 (S/PDIF) interface
|
| /Documentation/sound/ |
| D | alsa-configuration.rst | 272 S/PDIF transfer over AC-link (default = 1)
1174 reset timeout for the CS8427 chip (S/PDIF transceiver) in msec
1285 Use S/PDIF over AC-link instead of direct connection from the
|
| /Documentation/sound/kernel-api/ |
| D | writing-an-alsa-driver.rst | 3453 IEC958 (S/PDIF)
|