Searched full:supported (Results 1 – 25 of 1337) sorted by relevance
12345678910>>...54
| /Documentation/admin-guide/ |
| D | ufs.rst | 20 default value, supported as read-only
24 supported as read-write
28 supported as read-write
35 supported as read-write
39 supported as read-write
43 supported as read-only
47 supported as read-only
51 supported as read-only
55 supported as read-only
|
| /Documentation/devicetree/bindings/opp/ |
| D | qcom-nvmem-cpufreq.txt | 45 - opp-supported-hw: A single 32 bit bitmap value, representing compatible HW.
150 opp-supported-hw = <0x77>;
156 opp-supported-hw = <0x70>;
162 opp-supported-hw = <0x7>;
168 opp-supported-hw = <0x70>;
174 opp-supported-hw = <0x7>;
180 opp-supported-hw = <0x70>;
186 opp-supported-hw = <0x7>;
192 opp-supported-hw = <0x70>;
198 opp-supported-hw = <0x7>;
[all …]
|
| /Documentation/devicetree/bindings/regulator/ |
| D | rohm,bd71837-regulator.txt | 38 Supported default DVS states:
43 1 | supported | supported | supported
45 2 | supported | supported | not supported
47 3 | supported | not supported | not supported
49 4 | supported | not supported | not supported
51 rest | not supported | not supported | not supported
56 1 | supported | supported | supported
58 2 | supported | supported | not supported
60 rest | not supported | not supported | not supported
|
| /Documentation/arm/samsung-s3c24xx/ |
| D | s3c2412.rst | 42 The UART hardware is similar to the S3C2440, and is supported by the
49 The NAND hardware is similar to the S3C2440, and is supported by the
57 control. The OHCI portion is supported by the ohci-s3c2410 driver, and
58 the clock control selection is supported by the core clock code.
70 All the standard, and external interrupt sources are supported. The
71 extra sub-sources are not yet supported.
77 The RTC hardware is similar to the S3C2410, and is supported by the
84 The watchdog hardware is the same as the S3C2410, and is supported by
96 The IIC hardware is the same as the S3C2410, and is supported by the
|
| /Documentation/devicetree/bindings/dma/ |
| D | snps-dma.txt | 7 - dma-channels: Number of channels supported by hardware
8 - dma-requests: Number of DMA request lines supported, up to 16
9 - dma-masters: Number of AHB masters supported by the controller
15 - block_size: Maximum block size supported by the controller
16 - data-width: Maximum data width supported by hardware per AHB master
21 - data_width: Maximum data width supported by hardware per AHB master
26 - multi-block: Multi block transfers supported by hardware. Array property with
27 one cell per channel. 0: not supported, 1 (default): supported.
|
| D | snps,dw-axi-dmac.txt | 8 - dma-channels: Number of channels supported by hardware.
9 - snps,dma-masters: Number of AXI masters supported by the hardware.
10 - snps,data-width: Maximum AXI data width supported by hardware.
15 - snps,block-size: Maximum block size supported by the controller channel.
21 supported by DMAC is used. [1:256]
|
| /Documentation/devicetree/bindings/cpufreq/ |
| D | ti-cpufreq.txt | 7 provide the OPP framework with supported hardware information. This is
25 - opp-supported-hw: Two bitfields indicating:
26 1. Which revision of the SoC the OPP is supported by
69 opp-supported-hw = <0x06 0x0010>;
76 opp-supported-hw = <0x01 0x00FF>;
83 opp-supported-hw = <0x06 0x0020>;
90 opp-supported-hw = <0x01 0xFFFF>;
96 opp-supported-hw = <0x06 0x0040>;
102 opp-supported-hw = <0x01 0xFFFF>;
108 opp-supported-hw = <0x06 0x0080>;
[all …]
|
| D | imx-cpufreq-dt.txt | 6 the opp-supported-hw values for each OPP to check if the OPP is allowed.
12 - opp-supported-hw: Two bitmaps indicating:
13 - Supported speed grade mask
14 - Supported market segment mask
28 opp-supported-hw = <0xf>, <0x3>;
35 opp-supported-hw = <0xe>, <0x7>;
|
| /Documentation/input/joydev/ |
| D | joystick.rst | 151 Cyborg 'digital' joysticks are also supported by this driver, because
228 Microsoft 'Digital Overdrive' protocol is supported by the sidewinder.c
229 module. All currently supported joysticks:
248 The SideWinder Standard is not a digital joystick, and thus is supported
254 Logitech ADI protocol is supported by the adi.c module. It should support
275 Logitech Magellan are supported by serial drivers described below. Logitech
276 WingMan Force and Logitech WingMan Formula Force are supported by the
277 I-Force driver described below. Logitech CyberMan is not supported yet.
282 Gravis GrIP protocol is supported by the grip.c module. It currently
294 GrIP MultiPort isn't supported yet. Gravis Stinger is a serial device and is
[all …]
|
| /Documentation/i2c/busses/ |
| D | i2c-amd8111.rst | 5 Supported adapters:
30 Supported.
35 Supported. Both PEC and block process call support is implemented. Slave
42 is supported by this driver, and the SMBus 1.0 adapter is supported by the
|
| D | i2c-amd756.rst | 5 Supported adapters:
28 is supported by this driver, and the SMBus 2.0 adapter is supported by the
|
| /Documentation/features/ |
| D | arch-support.txt | 8 | ok | # feature supported by the architecture
9 |TODO| # feature not yet supported by the architecture
10 | .. | # feature cannot be supported by the hardware
|
| /Documentation/arm64/ |
| D | acpi_object_usage.rst | 24 - Not supported: BOOT, DBGP, DMAR, ETDT, HPET, IBFT, IVRS, LPIT,
41 Microsoft only table, will not be supported.
47 Optional, not currently supported, with no real use-case for an
54 Optional, not currently supported, and not recommended until such
62 Optional, not currently supported.
75 Microsoft only table, will not be supported.
91 x86 only table, will not be supported.
97 Optional, not currently supported.
103 Optional, not currently supported, but could be used on ARM if and
131 Obsolete table, will not be supported.
[all …]
|
| D | hugetlbpage.rst | 9 - size of entries supported by the TLBs
17 block of memory. Regardless of the supported size of entries in TLB, block
29 pte (last) level. The number of supported contiguous entries varies by page size
33 The following hugepage sizes are supported -
|
| /Documentation/devicetree/bindings/mmc/ |
| D | mmc-controller.yaml | 117 When specified, denotes that 1.8V card voltage is not supported
123 SD high-speed timing is supported.
128 MMC high-speed timing is supported.
133 SD UHS SDR12 speed is supported.
138 SD UHS SDR25 speed is supported.
143 SD UHS SDR50 speed is supported.
148 SD UHS SDR104 speed is supported.
153 SD UHS DDR50 speed is supported.
163 eMMC hardware reset is supported
173 Full power cycle of the card is supported.
[all …]
|
| /Documentation/devicetree/bindings/phy/ |
| D | apm-xgene-phy.txt | 20 supported link speed on the host. Range from 0 to
26 supported link speed on the host. Default is 0.
29 (up to 3) supported link speed on the host. Range is
32 each (up to 3) supported link speed on the host.
36 3-tuple setting for each (up to 3) supported link
40 3-tuple setting for each (up to 3) supported link
47 supported link speed on the host.
|
| /Documentation/ABI/testing/ |
| D | rtc-cdev | 7 Following actions are supported:
36 The ioctl() calls supported by the older /dev/rtc interface are
37 also supported by the newer RTC class framework. However,
41 by the RTC class framework, but can't be supported by the older
|
| D | sysfs-devices-soc | 12 It has been agreed that if an SoC device exists, its supported
33 Read-only attribute supported by most SoCs. Contains the SoC's
40 Read-only attribute supported by most SoCs. In the case of
47 Read-only attribute supported by most SoCs. Contains the SoC's
54 Read-only attribute supported ST-Ericsson's silicon. Contains the
|
| D | sysfs-class-typec | 7 The supported USB data roles. This attribute can be used for
8 requesting data role swapping on the port. Swapping is supported
22 The supported power roles. This attribute can be used to request
24 Delivery. Swapping is supported as synchronous operation, so
39 supported as a synchronous operation, so write(2) to the
55 Swapping is supported as synchronous operation, so write(2) to
102 Revision number of the supported USB Power Delivery
103 specification, or 0 when USB Power Delivery is not supported.
109 Revision number of the supported USB Type-C specification.
135 delivery is supported, for example when USB power delivery
[all …]
|
| /Documentation/devicetree/bindings/mtd/ |
| D | nvidia-tegra20-nand.txt | 19 only one NAND chip supported.
26 "hw" is supported.
28 Supported values with "hw" ECC mode are: "rs", "bch".
32 per ECC step (always 512). Supported strength using HW ECC
37 - nand-is-boot-medium: Makes sure only ECC strengths supported by the boot ROM
|
| /Documentation/spi/ |
| D | spi-sc18is602.rst | 5 Supported chips:
21 The driver does not probe for supported chips, since the SI18IS602/603 does not
30 adapter drivers which can only handle the SMBus protocol are not supported.
32 The maximum SPI message size supported by SC18IS602/603 is 200 bytes. Attempts
|
| /Documentation/admin-guide/pm/ |
| D | intel_pstate.rst | 20 may not be supported. [To understand ``intel_pstate`` it is necessary to know
24 For the processors supported by ``intel_pstate``, the P-state concept is broader
117 Energy-Performance Preference (EPP) knob (if supported) or its
132 Energy-Performance Preference (EPP) knob (if supported) or its
209 maximum and minimum operating frequencies supported by the hardware (including
246 supported one as it sees fit.
266 supported one overall.
268 The maximum supported turbo P-state, the turbo threshold (the maximum supported
269 non-turbo P-state) and the minimum supported P-state are specific to the
296 * The minimum supported P-state.
[all …]
|
| /Documentation/devicetree/bindings/hwmon/ |
| D | jc42.txt | 5 manufacturer and the name of the chip. A list of supported
10 Supported chip names:
39 This is not supported on all chips.
|
| /Documentation/media/v4l-drivers/ |
| D | qcom_camss.rst | 18 Camera sensor using V4L2 subdev interface in the kernel is supported.
27 The Camera Subsystem hardware found on 8x16 / 8x96 processors and supported by
47 Supported functionality
58 Supported formats:
74 Supported input formats:
78 Supported output formats:
86 Supported input formats:
91 Supported output formats:
127 supported by the hardware;
159 not required to implement the currently supported functionality. The complete
|
| /Documentation/hwmon/ |
| D | pc87427.rst | 4 Supported chips:
25 6 temperature sensors. Only the fans and temperatures are supported at
29 which are partly supported by this driver.
50 always off, always on, manual and automatic. The latter isn't supported
|
12345678910>>...54