Searched full:thus (Results 1 – 25 of 438) sorted by relevance
12345678910>>...18
| /Documentation/hwmon/ |
| D | pwm-fan.rst | 5 generic PWM interface thus it is hardware independent. It can be used on
15 a PWM output. It uses the generic PWM interface, thus it can be used with
|
| D | abituguru3.rst | 16 firmware and thus effectivly many different revisions of the uGuru.
41 detection to be skipped, and thus the insmod to
43 driver will not load and thus no hwmon device will get
|
| D | abituguru.rst | 20 firmware and thus effectivly many different revisions of the uGuru.
56 detection to be skipped, and thus the insmod to
58 driver will not load and thus no hwmon device will get
|
| /Documentation/devicetree/bindings/clock/ |
| D | dove-divider-clock.txt | 5 the PMU, and thus this node should be a child of the PMU node.
20 Core PLL and Clock Divider Control 1 register. Thus, it will have
|
| /Documentation/devicetree/bindings/regulator/ |
| D | ltc3676.txt | 21 412.5mV to 800mV in 12.5 mV steps. The output voltage thus ranges between
24 Regulators ldo1, ldo2, and ldo4 have a fixed 0.725 V reference and thus output
26 regulator can not be disabled and thus should have the regulator-always-on
|
| D | ltc3589.txt | 21 0.3625 V to 0.75 V in 12.5 mV steps. The output voltage thus ranges between
23 have a fixed 0.8 V reference and thus output 0.8 * (1 + R1/R2) V. The ldo3
27 be disabled and thus should have the regulator-always-on property set.
|
| /Documentation/networking/device_drivers/toshiba/ |
| D | spider_net.txt | 44 marks it full, and advances the GDACTDPA by one. Thus, when there is
53 and advance the tail pointer. Thus, when there is flowing RX traffic,
65 then mark the descr as "empty", ready to receive data. Thus, when there
72 Thus, in an idle system, the GDACTDPA, tail and head pointers will
155 marked xa... which is "empty". Thus, from the OS point of view, there
162 Since its already full, the hardware can do nothing more, and thus has
165 descr 254, since tail was at 255.) Thus, the system is deadlocked,
|
| /Documentation/ |
| D | static-keys.txt | 63 functionality. Thus, it is highly desirable to reduce their impact as much as
85 Thus, by default the 'printk' will not be emitted. And the code generated will
89 out-of-line true branch. Thus, changing branch direction is expensive but
144 Thus, 'static_branch_inc()' means 'make the branch true', and
161 thus a sure deadlock recipe. In order to still allow use of the
275 Thus, the disable jump label case adds a 'mov', 'test' and 'jne' instruction
277 to a 5 byte atomic no-op instruction at boot-time.) Thus, the disabled jump
284 function is 80 bytes long. Thus, we have saved 20% of the instruction
|
| D | crc32.txt | 17 subtract, we just xor. Thus, we tend to get a bit sloppy about
58 32 bits later. Thus, the first 32 cycles of this are pretty boring.
153 takes barely longer than a single table look-up and thus performs almost
164 been completed. Thus, the processor's load/store unit is sometimes idle.
170 on the previous CRC at all. Thus, those 4 table look-ups may commence
179 of a polynomial produces a larger multiple of that polynomial. Thus,
|
| /Documentation/filesystems/ |
| D | inotify.txt | 17 the file and thus, worse, pins the mount. Dnotify is therefore infeasible
29 spaces is thus sensible. The current design is what user-space developers
64 juggle more than one queue and thus more than one associated fd. There
|
| /Documentation/devicetree/bindings/iio/adc/ |
| D | renesas,gyroadc.txt | 37 on the chip and thus for 4-channel operation, single
47 ADC channel with data, thus for 8-channel operation,
56 ADC channel with data, thus for 8-channel operation,
|
| /Documentation/virt/kvm/ |
| D | halt-polling.txt | 16 invoked. Thus halt polling is especially useful on workloads with very short
42 Thus this is a per vcpu (or vcore) value.
46 received during the polling interval (and thus schedule is invoked) there are
125 the host will always poll for the entire block time and thus cpu utilisation
135 schedule will be invoked to allow that other task to run. Thus this doesn't
|
| /Documentation/timers/ |
| D | timers-howto.rst | 59 driving each of these calls varies, thus there are
87 wakeup will be very precise (ish), thus a simple
100 tolerances here are very situation specific, thus it
|
| /Documentation/ABI/obsolete/ |
| D | sysfs-firmware-acpi | 8 enabling this knob is not safe and thus unsupported.
|
| /Documentation/devicetree/bindings/gpio/ |
| D | nvidia,tegra186-gpio.txt | 32 a number of GPIOs. Thus, each GPIO is named according to an alphabetical port
49 represents the aggregate status for all GPIOs within a set of ports. Thus, the
57 signal to be routed to a different CPU, thus allowing different CPUs to each
59 per-port-set signals is reported via a separate register. Thus, a driver needs
|
| D | gpio-pcf857x.txt | 10 thus to do it explicitly.
44 The I/O expander can detect input state changes, and thus optionally act as
|
| /Documentation/ABI/testing/ |
| D | sysfs-bus-pci-devices-aer_stats | 18 be reported using a single ERR_COR message, thus
40 be reported using a single ERR_FATAL message, thus
71 may be reported using a single ERR_FATAL message, thus
103 device, so these counters include them and are thus cumulative of all the error
|
| D | sysfs-class-led-driver-sc27xx | 21 Thus the format of the hardware pattern values should be:
|
| /Documentation/devicetree/bindings/pci/ |
| D | arm,juno-r1-pcie.txt | 4 and thus inherits all the common properties defined in plda,xpressrich3-axi.txt
|
| /Documentation/vm/ |
| D | zsmalloc.rst | 7 This allocator is designed for use with zram. Thus, the allocator is
23 worst case, page is incompressible and is thus stored "as-is" i.e. in
|
| /Documentation/filesystems/nfs/ |
| D | knfsd-stats.txt | 44 and thus this file will have a single line with a pool id of "0".
67 thus introducing a small delay in servicing NFS calls. The ideal
112 counted, but can be inferred from the other counters thus:
|
| /Documentation/devicetree/bindings/spi/ |
| D | spi-sprd-adi.txt | 16 Thus we introduce one property named "sprd,hw-channels" to configure hardware
30 thus change the hardware spinlock support to be optional to keep backward
|
| /Documentation/ide/ |
| D | ide-tape.rst | 63 driven and thus has much less CPU overhead.
66 devices, including new ATAPI cdroms, and thus provides us
|
| /Documentation/sound/hd-audio/ |
| D | notes.rst | 117 Thus, if the second error message appears, try to narrow the probed
140 thus we disabled MSI for them.
192 Thus, if you have a newer machine with a slightly different PCI SSID
206 Thus, the first thing you can do for any brand-new, unsupported and
225 the external amplifier bits. Thus a headphone output has a slightly
267 Thus, before submitting a bug report, make sure that you set up the
286 Most of modern laptops have no analog CD-input connection. Thus, the
317 will give you far more messages. Thus turn this on only when you are
322 the controller chip. Thus, even if lspci shows the Nvidia controller,
332 Thus, it'd be better to turn this on always.
[all …]
|
| /Documentation/scsi/ |
| D | link_power_management_policy.txt | 17 state, thus improving latency over min_power setting.
|
12345678910>>...18