Searched full:according (Results 1 – 25 of 316) sorted by relevance
12345678910>>...13
| /Documentation/devicetree/bindings/serial/ |
| D | samsung_uart.txt | 19 according to interrupt bindings documentation [1].
24 according to SoC User's Manual (only N = 0 is allowedfor SoCs without
27 property, in the same order, according to clock bindings documentation [2].
36 "aliases" node, according to serialN format, where N is the port number
|
| /Documentation/sound/designs/ |
| D | tracepoints.rst | 92 decided as a fixed number, this value is also calculated according to
98 decided as a single value, this value is also calculated according to
105 also calculated according to it. Else, zero. But this behaviour depends
115 Parameters in the buffer are changed according to
118 dependencies on which a parameter is decided according to several parameters.
127 :c:type:`struct snd_pcm_hardware` type in the runtime, according to
139 ``hw_interval_param`` event is probed according to type of the changed parameter.
162 fields are different according to type of the parameter. For parameters of mask
|
| /Documentation/devicetree/bindings/gpu/ |
| D | samsung-rotator.txt | 13 - interrupts : Interrupt specifier for rotator interrupt, according to format
16 - clocks : Clock specifier for rotator clock, according to generic clock
|
| D | samsung-scaler.txt | 11 - interrupts : Interrupt specifier for scaler interrupt, according to format
14 - clocks : Clock specifier for scaler clock, according to generic clock
|
| /Documentation/ABI/stable/ |
| D | sysfs-bus-firewire | 83 actually contains according entries.
99 Mandatory in unit directories according to IEEE 1212.
103 Mandatory in the root directory according to IEEE 1212.
110 Mandatory in unit directories according to IEEE 1212.
|
| /Documentation/devicetree/bindings/pci/ |
| D | uniphier-pcie.txt | 14 According to the reg-names, appropriate register sets are required.
23 - interrupts: A list of interrupt specifiers. According to the
30 - phys: A phandle to generic PCIe PHY. According to the phy-names, appropriate
|
| /Documentation/devicetree/bindings/iio/adc/ |
| D | vf610-adc.txt | 15 - fsl,adck-max-frequency: Maximum frequencies according to datasheets operating
21 to be chosen according to the conversion mode and the connected analog
|
| /Documentation/leds/ |
| D | leds-lp3944.rst | 34 Setting a led in DIM0 or DIM1 mode makes it blink according to the pattern.
47 according to include/linux/leds-lp3944.h, set the i2c board info::
|
| /Documentation/devicetree/bindings/regulator/ |
| D | uniphier-regulator.txt | 22 According to the clock-names, appropriate clocks are required.
27 According to the reset-names, appropriate resets are required.
|
| /Documentation/devicetree/bindings/phy/ |
| D | uniphier-usb3-ssphy.txt | 17 According to the clock-names, appropriate clocks are required.
23 According to the reset-names, appropriate resets are required.
|
| D | uniphier-usb3-hsphy.txt | 17 According to the clock-names, appropriate clocks are required.
23 According to the reset-names, appropriate resets are required.
|
| /Documentation/devicetree/bindings/display/panel/ |
| D | samsung,ld9040.txt | 9 - display-timings: timings for the connected panel according to [1]
20 'endpoint' node, according to the bindings defined in [3]. This
|
| D | sharp,ld-d5116z01b.txt | 10 'endpoint' node, according to the bindings defined in [1]. This
|
| D | samsung,s6d16d0.txt | 11 'endpoint' node, according to the bindings defined in
|
| /Documentation/devicetree/bindings/iommu/ |
| D | mediatek,iommu.txt | 51 video decode local arbiter, all these ports are according to the video HW.
76 according to the local arbiter index, like larb0, larb1, larb2...
77 - iommu-cells : must be 1. This is the mtk_m4u_id according to the HW.
|
| /Documentation/devicetree/bindings/sound/ |
| D | st,stm32-sai.txt | 55 configured according to protocol defined in related DAI link node,
59 is a master clock provider, according to clocks bindings, described in
63 node, according to the bindings defined in Documentation/devicetree/bindings/
|
| D | ics43432.txt | 5 frequency (460 kHz to 3.379 MHz according to the data sheet) there must be
|
| /Documentation/devicetree/bindings/media/ |
| D | samsung-s5k5baf.txt | 16 according to common clock bindings for the
27 node, according to the bindings defined in Documentation/devicetree/bindings/
|
| /Documentation/media/uapi/v4l/ |
| D | selection-api-configuration.rst | 48 according to hardware limitations.
68 adjustments according to hardware limitations. The application can
107 further adjust the requested size and/or position according to hardware
119 driver can perform other adjustments according to hardware limitations.
|
| /Documentation/devicetree/bindings/net/ |
| D | micrel-ks8995.txt | 3 Required properties (according to spi-bus.txt):
|
| D | fsl-enetc.txt | 10 Number of the ENETC endpoint device, according
60 Number of the ENETC endpoint device, according
|
| /Documentation/ABI/testing/ |
| D | sysfs-bus-iio-magnetometer-hmc5843 | 14 according to the device. For exact documentation
|
| /Documentation/devicetree/bindings/display/exynos/ |
| D | exynos_dsim.txt | 23 according to DSI host bindings (see MIPI DSI bindings [1])
35 Device node can contain following video interface port nodes according to [2]:
|
| /Documentation/devicetree/bindings/power/reset/ |
| D | nvmem-reboot-mode.txt | 5 can read it and take different action according to the magic
|
| /Documentation/devicetree/bindings/clock/ |
| D | silabs,si544.txt | 12 - compatible: One of "silabs,si514a", "silabs,si514b" "silabs,si514c" according
|
12345678910>>...13