Searched full:alternate (Results 1 – 25 of 74) sorted by relevance
123
| /Documentation/driver-api/usb/ |
| D | typec_bus.rst | 2 API for USB Type-C Alternate Mode drivers 8 Alternate modes require communication with the partner using Vendor Defined 11 every alternate mode, so every alternate mode will need a custom driver. 13 USB Type-C bus allows binding a driver to the discovered partner alternate 16 :ref:`USB Type-C Connector Class <typec>` provides a device for every alternate 17 mode a port supports, and separate device for every alternate mode the partner 18 supports. The drivers for the alternate modes are bound to the partner alternate 19 mode devices, and the port alternate mode devices must be handled by the port 22 When a new partner alternate mode device is registered, it is linked to the 23 alternate mode device of the port that the partner is attached to, that has [all …]
|
| D | typec.rst | 22 the roles and alternate modes of ports, partners and cable plugs when the port 46 If the port, partner or cable plug supports Alternate Modes, every supported 47 Alternate Mode SVID will have their own device describing them. Note that the 48 Alternate Mode devices will not be attached to the typec class. The parent of an 49 alternate mode will be the device that supports it, so for example an alternate 51 Every mode that is supported will have its own group under the Alternate Mode 52 device named "mode<index>", for example /sys/class/typec/port0/<alternate 142 Alternate Modes 145 USB Type-C ports, partners and cable plugs may support Alternate Modes. Each 146 Alternate Mode will have identifier called SVID, which is either a Standard ID [all …]
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | renesas,rza1-pinctrl.txt | 8 function (port mode) or in alternate function mode. 9 Up to 8 different alternate function modes exist for each single pin. 41 (or a single) pin in some desired alternate function mode. 43 A few alternate function require special pin configuration flags to be 44 supplied along with the alternate function configuration number. 103 When a pin has to be configured in alternate function mode, use this 105 alternate function configuration number along with it. 107 alternate function they shall be specified as members of the same 110 (port where it sits on and pin number) and alternate function identifier 140 Pin #0 on port #3 is configured as alternate function #6. [all …]
|
| D | renesas,rza2-pinctrl.txt | 6 function (port mode) or in alternate function mode. 7 Up to 8 different alternate function modes exist for each single pin. 44 (or a single) pin in some desired alternate function mode. 54 When a pin has to be configured in alternate function mode, use this 56 alternate function configuration number along with it. 58 alternate function they shall be specified as members of the same 61 (port where it sits on and pin number) and alternate function identifier
|
| D | renesas,rzn1-pinctrl.txt | 33 (or a single) pin in some desired alternate function mode. 106 When a pin has to be configured in alternate function mode, use this 108 alternate function configuration number along with it. 110 alternate function they shall be specified as members of the same 115 one of the alternate function identifiers defined in:
|
| D | pinctrl-vt8500.txt | 4 either a GPIO in, GPIO out or as an alternate function (I2C, SPI etc). 37 2: alternate
|
| D | st,stm32-pinctrl.yaml | 141 * 1 : Alternate Function 0 142 * 2 : Alternate Function 1 143 * 3 : Alternate Function 2 145 * 16 : Alternate Function 15
|
| D | cirrus,madera-pinctrl.txt | 5 Certain groups of GPIO pins also have an alternate function, normally as an 8 The set of available GPIOs, functions and alternate function groups differs
|
| D | pinctrl-st.txt | 5 and multiple alternate functions(ALT1 - ALTx) that directly connect 119 -mux : Should be alternate function number associated this pin.
|
| /Documentation/ABI/testing/ |
| D | sysfs-bus-typec | 27 Power Delivery command. Depending on the alternate mode, the 30 With some alternate modes (SVIDs), the mode index is assigned 32 alternate mode. 34 With other alternate modes, the mode index values are not 36 the mode index is not assigned, identifying the alternate mode 44 alternate mode.
|
| D | sysfs-class-watchdog | 82 system has booted from the alternate flash chip due to 84 alternate boot function was enabled with 'aspeed,alt-boot' 88 At alternate flash the 'access_cs0' sysfs node provides: 90 chip at CS0 after booting from the alternate 100 For alternate boot mode (booted from CS1 due to wdt2
|
| D | sysfs-driver-hid-logitech-lg4ff | 13 Description: Displays a set of alternate modes supported by a wheel. Each 56 alternate mode the wheel might be switched to.
|
| /Documentation/arm/pxa/ |
| D | mfp.rst | 14 Unlike the GPIO alternate function settings on PXA25x and PXA27x, a new MFP 47 To better understand the change from PXA25x/PXA27x GPIO alternate function 56 2. Alternate function configuration is removed from this GPIO controller, 174 Bit 15: PULL_SEL - pull state controlled by selected alternate function 177 Bit 0 - 2: AF_SEL - alternate function selection, 8 possibilities, from 0-7 241 * bit 10..12 - Alternate Function Selection 250 * alternate function = 0, 255 * MFP_CFG - default MFPR value with alternate function 256 * MFP_CFG_DRV - default MFPR value with alternate function and 258 * MFP_CFG_LPM - default MFPR value with alternate function and [all …]
|
| /Documentation/ABI/obsolete/ |
| D | sysfs-class-typec | 9 alternate mode. 40 with the port alternate modes it can be used for disabling 41 support for specific alternate modes. Entering/exiting modes is
|
| /Documentation/devicetree/bindings/phy/ |
| D | phy-cpcap-usb.txt | 14 pinctrl: Optional alternate pin modes for the PHY 16 mode-gpios: Optional GPIOs for configuring alternate modes
|
| /Documentation/media/v4l-drivers/ |
| D | cpia2.rst | 71 alternate USB Alternate (2-7, default 7) 98 The maximum image size depends on the alternate you choose, and the 108 At low alternate settings, the compression engine may not be able to 113 any alternate at frame rates down to 15fps. For lower frame rates, it may 118 Alternate bytes/ms 15fps 30fps
|
| /Documentation/admin-guide/ |
| D | devices.rst | 101 /dev/scd? sr? hard Alternate SCSI CD-ROM name 126 (the use of the alternate callout devices is deprecated). 205 names, the primary or callin device and the alternate or callout one. 216 The alternate devices provide for kernel-based exclusion and somewhat 230 that a lock file be installed with the corresponding alternate 236 3. The alternate device name (``/var/lock/LCK..cua2``) 243 to create lock files for the corresponding alternate device names 245 port TTY, for which no alternate device would exist.
|
| /Documentation/driver-api/soundwire/ |
| D | stream.rst | 260 alternate bank (bank currently unused). Port(s) are enabled for the 261 already active stream(s) on the alternate bank (bank currently unused). 264 (4) Once all the values are programmed, Bus initiates switch to alternate 289 in alternate bank (bank currently unused). It includes programming of 293 enabled on alternate bank (bank currently unused) by programming 296 (3) Once all the values are programmed, Bus initiates switch to alternate 318 disabled on alternate bank (bank currently unused) by programming 322 into alternate bank (bank currently unused). 324 (3) Once all the values are programmed, Bus initiates switch to alternate
|
| /Documentation/devicetree/bindings/soc/fsl/ |
| D | guts.txt | 5 I/O signal configuration, alternate function selection for multiplexed
|
| /Documentation/devicetree/bindings/clock/ |
| D | artpec6.txt | 12 - "i2s_refclk": Alternate audio reference clock (optional).
|
| D | qcom,spmi-clkdiv.txt | 4 These clocks are typically wired through alternate functions on
|
| D | pistachio-clock.txt | 14 - "audio_clk_in": Alternate audio reference clock (optional) 15 - "enet_clk_in": Alternate ethernet PHY clock (optional)
|
| /Documentation/devicetree/bindings/cpufreq/ |
| D | cpufreq-qcom-hw.txt | 21 Definition: must be "xo", "alternate". 168 clock-names = "xo", "alternate";
|
| /Documentation/devicetree/bindings/watchdog/ |
| D | aspeed-wdt.txt | 37 - aspeed,alt-boot: If property is present then boot from alternate block.
|
| /Documentation/arm/sa1100/ |
| D | serial_uart.rst | 25 > 205 char Low-density serial ports (alternate device)
|
123