Searched full:applied (Results 1 – 25 of 193) sorted by relevance
12345678
| /Documentation/devicetree/ |
| D | changesets.txt | 3 will be applied, or none of them will be. If an error occurs partway
6 applied.
8 When a changeset is applied, all of the changes get applied to the tree
25 entire changeset will get applied, or if there is an error the tree will
30 If a successfully applied changeset needs to be removed, it can be done
|
| /Documentation/devicetree/bindings/input/touchscreen/ |
| D | iqs5xx.txt | 45 - touchscreen-inverted-x : See [2]. Inversion is applied relative to that
49 - touchscreen-inverted-y : See [2]. Inversion is applied relative to that
53 - touchscreen-swapped-x-y : See [2]. Swapping is applied relative to that
|
| /Documentation/devicetree/bindings/pwm/ |
| D | pwm-stm32.txt | 17 should be applied.
20 "filter" gives the filtering value to be applied.
|
| /Documentation/media/uapi/mediactl/ |
| D | request-api.rst | 36 Another is support of stateless codecs, which require controls to be applied
53 applied when needed to get the expected result. Configuration values at the time
79 fact that the ioctl is part of said request, and is not to be applied
82 instead of being immediately applied, and buffers queued to a request do not
99 may synchronize so the requested pipeline's topology is applied before the
112 Controls can still be set without a request and are applied immediately,
157 be applied by the driver for the OUTPUT buffer, allowing user-space
|
| /Documentation/devicetree/bindings/dma/ |
| D | qcom_hidma_mgmt.txt | 32 applied back to back while writing to the destination before yielding
35 applied back to back while reading the source before yielding the bus.
37 Once a reset is applied to the HW, HW starts a timer for reset operation
|
| D | apm-xgene-dma.txt | 1 Applied Micro X-Gene SoC DMA nodes
|
| /Documentation/media/uapi/v4l/ |
| D | ext-ctrls-fm-rx.rst | 51 being broadcasted. RDS Radio Text can be applied when broadcaster
79 is applied to the broadcast to accentuate the high audio
91 - No de-emphasis is applied.
|
| D | ext-ctrls-fm-tx.rst | 58 applied when broadcaster wishes to transmit longer PS names,
158 filter is applied to the broadcast to accentuate the high audio
170 - No pre-emphasis is applied.
|
| /Documentation/devicetree/bindings/iio/light/ |
| D | us5182d.txt | 15 fractional bits - Q4.4) applied when light > threshold
18 fractional bits - Q4.4) applied when light < threshold
|
| /Documentation/process/ |
| D | applying-patches.rst | 16 one of the many trees/branches should be applied to. Hopefully this document
57 To revert a previously applied patch, use the -R argument to patch.
58 So, if you applied a patch like this::
134 it'll tell you about it by saying the patch applied with **fuzz**.
141 read this file to see exactly what change couldn't be applied, so you can
144 If you don't have any third-party patches applied to your kernel source, but
158 applied with ``-p0`` instead of ``-p1`` (reading the patch file should reveal if
174 patch could not be applied correctly and the patch program was unable to
179 If you get ``Reversed (or previously applied) patch detected! Assume -R? [n]``
183 If you actually did apply this patch previously and you just re-applied it
[all …]
|
| D | stable-kernel-rules.rst | 62 in the sign-off area. Once the patch is merged it will be applied to
73 why you think it should be applied, and what kernel version you wish it to
74 be applied to.
84 it to be applied to.
88 worthy at the time it is applied to a public git tree (for instance, because
|
| /Documentation/translations/ |
| D | index.rst | 39 applied to the English documents first. Afterwards and when possible, the
40 same change should be applied to translations. Translations' maintainers
|
| /Documentation/ABI/testing/ |
| D | sysfs-driver-hid-wiimote | 57 Calibration data is already applied by the kernel to all input
71 Calibration data is already applied by the kernel to all input
|
| D | sysfs-bus-iio-temperature-max31856 | 17 is protected from excessive voltages applied to the thermocouple
|
| /Documentation/networking/device_drivers/microsoft/ |
| D | netvsc.txt | 67 Network state (addresses, firewall, etc) should be applied only to the
70 flow direction is desired, these should be applied directly to the
|
| /Documentation/devicetree/bindings/iio/potentiostat/ |
| D | lmp91000.txt | 22 - ti,rload-ohm: ohm value of the internal resistor load applied to the gas
|
| /Documentation/power/powercap/ |
| D | powercap.rst | 29 fine grained control is required, it can be applied through the subzones.
156 to be applied (the constraints in the 'package' power zones apply to the whole
171 with two different time windows to be applied to each power zone. Thus for
|
| /Documentation/devicetree/bindings/phy/ |
| D | rockchip-emmc-phy.txt | 18 If not set, the default value of 50 will be applied.
|
| /Documentation/x86/ |
| D | microcode.rst | 40 CPU is found, it will be applied in the BSP and later on in all APs
44 Thus, the cached microcode patch is applied when CPUs resume from a
|
| /Documentation/networking/ |
| D | ipsec.txt | 22 Therefore, a numeric threshold should be applied before compression,
|
| /Documentation/arm/samsung-s3c24xx/ |
| D | smdk2440.rst | 30 applied to this board.
|
| /Documentation/devicetree/bindings/sound/ |
| D | davinci-evm-audio.txt | 14 - ti,codec-clock-rate : The Codec Clock rate (in Hz) applied to the Codec.
|
| /Documentation/media/uapi/dvb/ |
| D | video-set-display-format.rst | 61 applied by the MPEG chip on the video.
|
| /Documentation/media/v4l-drivers/ |
| D | sh_mobile_ceu_camera.rst | 62 (5) to (5') - reverse sensor scale applied to CEU cropped width or height
63 (2) to (5) - reverse sensor scale applied to CEU cropped left or top
|
| /Documentation/devicetree/bindings/ |
| D | example-schema.yaml | 29 # 'select' is a schema applied to a DT node to determine if this binding
30 # schema should be applied to the node. It is optional and by default the
|
12345678