Home
last modified time | relevance | path

Searched full:cause (Results 1 – 25 of 343) sorted by relevance

12345678910>>...14

/Documentation/devicetree/bindings/watchdog/
Dmen-a021-wdt.txt9 4: Watchdog reset cause bit 0
10 5: Watchdog reset cause bit 1
11 6: Watchdog reset cause bit 2
/Documentation/ABI/stable/
Dsysfs-driver-mlxreg-io97 Description: These files show the system reset cause, as following: power
101 this is reset cause, 0 - otherwise. Only one of the above
103 reset cause.
115 Description: These files show the system reset cause, as following: ComEx
118 Value 1 in file means this is reset cause, 0 - otherwise.
120 the last reset cause.
136 Description: These files show the system reset cause, as following:
140 reload. Value 1 in file means this is reset cause, 0 - otherwise.
142 only last reset cause.
/Documentation/ABI/testing/
Dsysfs-devices-lpss_ltr19 is not "active", attempts to read from this attribute cause
31 is not "active", attempts to read from this attribute cause
43 is not "active", attempts to read from this attribute cause
Dsysfs-bus-fsl-mc5 Writing a device location to this file will cause
16 Writing a device location to this file will cause the
Dsysfs-class-zram14 RO attribute. Read operation will cause zram to add a new
Dsysfs-platform-hidma-mgmt65 can also cause performance reduction to other peripherals
86 can also cause performance reduction to other peripherals
/Documentation/
Dunaligned-memory-access.txt15 unaligned accesses, why you need to write code that doesn't cause them,
73 platforms and will cause performance problems on others.
76 Code that does not cause unaligned access
95 not be unreasonable to expect that accessing field2 would cause an unaligned
111 will never cause an unaligned access, because all memory addresses are evenly
139 the memory access in a way that does not cause unaligned access. Of course,
140 the extra instructions obviously cause a loss in performance compared to the
149 that can cause an unaligned memory access. The following function taken
183 Here is another example of some code that could cause unaligned accesses::
192 This code will cause unaligned accesses every time the data parameter points
Dio_ordering.txt32 which could cause problems. Fixing it is easy enough though::
49 Here, the reads from safe_register will cause the I/O chipset to flush any
/Documentation/hwmon/
Dtc654.rst32 Setting pwm1_mode to 1 will cause the pwm output to be driven based on
33 the pwm1 value. Setting pwm1_mode to 0 will cause the pwm output to be
Dadc128d818.rst25 When the HOT Temperature Limit is crossed, this will cause an alarm that will
39 is read at least once. This means that the cause for the alarm may
Dlm80.rst45 this will cause an alarm that will be reasserted until the temperature
67 is read at least once. This means that the cause for the alarm may
/Documentation/admin-guide/
Dxfs.rst96 cause problems for some applications that cannot handle
273 OR together the tags which represent errors which should cause panics:
300 Setting this to "1" will cause the "sync" flag set
305 Setting this to "1" will cause the "nodump" flag set
310 Setting this to "1" will cause the "noatime" flag set
315 Setting this to "1" will cause the "nosymlinks" flag set
320 Setting this to "1" will cause the "nodefrag" flag set
370 for a specific class will cause the error to be propagated rather than reset and
374 dependent - it may cause a shut down in the case of an unrecoverable error,
429 a single error, the first retry configuration that expires will cause the error
[all …]
/Documentation/devicetree/bindings/interrupt-controller/
Dmarvell,orion-intc.txt7 - reg: base address(es) of interrupt registers starting with CAUSE register
30 - reg: base address of bridge interrupt registers starting with CAUSE register
/Documentation/driver-api/md/
Draid5-cache.rst26 shutdown can cause data in some stripes to not be in consistent state, eg, data
41 doesn't cause data loss. Of course cache disk failure means the array is
63 disks later after specific conditions met. So cache disk failure will cause
67 the same data stored on cache disk, so a power loss doesn't cause data loss.
/Documentation/devicetree/bindings/power/reset/
Dkeystone-reset.txt8 block. The Reset Mux block can be configured to cause reset or not.
29 - ti,wdt-list: WDT list that can cause SoC reset. It's not related
/Documentation/networking/
Dxfrm_sync.txt64 XFRM_AE_CR=16, /* Event cause is replay update */
65 XFRM_AE_CE=32, /* Event cause is timer expiry */
66 XFRM_AE_CU=64, /* Event cause is policy update */
69 message (kernel<->user) as well the cause (config, query or event).
/Documentation/sound/cards/
Dvia82xx-mixer.rst6 Setting it to ``Input2`` on such boards will cause recording to hang, or fail
/Documentation/devicetree/bindings/i2c/
Di2c-rk3x.txt39 300 ns for Fast-mode) which might cause slightly slower communication.
42 be the maximum the specification allows (300 ns) which might cause
/Documentation/powerpc/
Dtransactional_memory.rst61 abort handler can check the cause of the failure, and retry.
92 give the appearance of success) or perform operations that cause transaction
174 Failure cause codes used by kernel
223 transaction when tm suspend occurs. So tsuspend will cause a
225 cause the transaction to be aborted and rolled back and the exception
/Documentation/security/
Dsak.rst86 These commands cause **all** daemons which are launched by the
89 delete these lines, but this may cause system management
/Documentation/arm/
Dmem_alignment.rst28 space, and might cause programs to fail unexpectedly.
37 will cause the kernel to print a message indicating
/Documentation/filesystems/
Dlocks.txt20 This should not cause problems for anybody, since everybody using a
35 over time, or under a very heavy mail load, would eventually cause the kernel
/Documentation/x86/x86_64/
Dmachinecheck.rst8 by the CPU. Uncorrected errors typically cause a machine check
9 (often with panic), corrected ones cause a machine check log entry.
/Documentation/x86/
Dpti.rst144 kernel entry code. In general, old kernels might cause these tests
164 Bugs in PTI cause a few different signatures of crashes
170 in the trampoline code or mappings cause these.
178 careful and can be the cause of crashes that show up when
/Documentation/networking/device_drivers/ti/
Dtlan.txt56 2. You can append aui=1 to the end of the insmod line to cause
61 cause it to not function correctly.)

12345678910>>...14