Searched full:controlled (Results 1 – 25 of 309) sorted by relevance
12345678910>>...13
| /Documentation/devicetree/bindings/leds/ |
| D | leds-bcm6328.txt | 6 controller), which can either be controlled by software (exporting the 74x164
9 Some of these Serial LEDs are hardware controlled (e.g. ethernet LEDs) and
11 controlled, so the only chance to keep them working is by using this driver.
14 should be controlled by a hardware signal instead of the MODE register value,
19 controlled you are still able to make it blink or light it up if it isn't,
21 reason, hardware controlled LEDs aren't registered as LED class devices.
47 a) Optional properties for sub-nodes related to software controlled LEDs:
56 b) Optional properties for sub-nodes related to hardware controlled LEDs:
57 - brcm,hardware-controlled : Boolean, makes this LED hardware controlled.
98 brcm,hardware-controlled;
[all …]
|
| D | leds-lm3697.txt | 21 - reg : 0 - LED is Controlled by bank A
22 1 - LED is Controlled by bank B
39 HVLED string 1 and 3 are controlled by control bank A and HVLED 2 string is
40 controlled by control bank B.
|
| D | leds-lm3532.txt | 53 - reg : Indicates control bank the LED string is controlled by
55 - ti,led-mode : Defines if the LED strings are manually controlled or
56 if the LED strings are controlled by the ALS.
57 0x00 - LED strings are I2C controlled via full scale
59 0x01 - LED strings are ALS controlled
|
| D | leds-lm36274.txt | 6 the I2C bus and/or controlled via a logic level PWM input from 60 uA to 30 mA.
31 HVLED string 1 and 3 are controlled by control bank A and HVLED 2 string is
32 controlled by control bank B.
|
| D | leds-aat1290.txt | 3 The device is controlled through two pins: FL_EN and EN_SET. The pins when,
7 of the flash chip. The switch is controlled with pin control.
|
| /Documentation/devicetree/bindings/dma/ |
| D | qcom_bam_dma.txt | 16 - qcom,controlled-remotely : optional, indicates that the bam is controlled by
19 remotely controlled bam.
21 in a remotely controlled bam.
|
| /Documentation/leds/ |
| D | leds-lm3556.rst | 26 LM3556 Flash can be controlled through sys/class/leds/flash/brightness file
29 ON / OFF will be controlled by STROBE pin.
54 LM3556 torch can be controlled through sys/class/leds/torch/brightness file.
56 and ON / OFF will be controlled by TORCH pin.
98 Indicator brightness can be controlled through
|
| D | leds-lp5521.rst | 15 LP5521 can drive up to 3 channels. Leds can be controlled directly via
19 All three channels can be also controlled using the engine micro programs.
|
| /Documentation/devicetree/bindings/pwm/ |
| D | google,cros-ec-pwm.txt | 1 * PWM controlled by ChromeOS EC
4 (EC) and controlled via a host-command interface.
|
| /Documentation/devicetree/bindings/sound/ |
| D | google,cros-ec-codec.txt | 1 * Audio codec controlled by ChromeOS EC
4 Embedded Controller (EC) and is controlled via a host-command interface.
|
| /Documentation/fault-injection/ |
| D | notifier-error-inject.rst | 16 This feature is controlled through debugfs interface
35 This feature is controlled through debugfs interface
53 This feature is controlled through debugfs interface
66 This feature is controlled through debugfs interface
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | pinctrl-zx.txt | 37 controlled by TOP_PMM block only, and this type of pins are meant by term
38 'TOP pins'. For pins like KEY_ROW2, the pinmux is controlled by both
42 types of pins. Both are controlled by auxiliary controller, i.e. AON_IOCFG
|
| /Documentation/devicetree/bindings/interrupt-controller/ |
| D | st,sti-irq-syscfg.txt | 1 STMicroelectronics STi System Configuration Controlled IRQs
5 and PL310 L2 Cache IRQs are controlled using System Configuration registers.
|
| /Documentation/devicetree/bindings/thermal/ |
| D | rockchip-thermal.txt | 30 - rockchip,hw-tshut-temp : The hardware-controlled shutdown temperature value.
31 - rockchip,hw-tshut-mode : The hardware-controlled shutdown mode 0:CRU 1:GPIO.
32 - rockchip,hw-tshut-polarity : The hardware-controlled active polarity 0:LOW
|
| /Documentation/devicetree/bindings/regulator/ |
| D | as3722-regulator.txt | 36 1: Rail is controlled by ENABLE1 input pin.
37 2: Rail is controlled by ENABLE2 input pin.
38 3: Rail is controlled by ENABLE3 input pin.
|
| D | tps65090.txt | 18 If DCDCs are externally controlled then this property should be there.
20 If DCDCs are externally controlled and if it is from GPIO then GPIO
21 number should be provided. If it is externally controlled and no GPIO
|
| D | gpio-regulator.yaml | 7 title: GPIO controlled regulators
29 controlled solely by the presence of "enable-active-high" DT property.
|
| /Documentation/devicetree/bindings/clock/ |
| D | maxim,max77686.txt | 10 The MAX77686 contains three 32.768khz clock outputs that can be controlled
15 The MAX77802 contains two 32.768khz clock outputs that can be controlled
19 The MAX77686 contains one 32.768khz clock outputs that can be controlled
|
| /Documentation/hwmon/ |
| D | amc6821.rst | 24 The pwm can be controlled either from software or automatically.
53 pwm1_enable rw regulator mode, 1=open loop, 2=fan controlled
54 by remote temperature, 3=fan controlled by
|
| D | lm85.rst | 247 in this case actually affects all PWMs controlled by zone '#'.
260 1 Controlled by Zone 1
261 2 Controlled by Zone 2
262 3 Controlled by Zone 3
263 23 Controlled by higher temp of Zone 2 or 3
264 123 Controlled by highest temp of Zone 1, 2 or 3
|
| /Documentation/admin-guide/laptops/ |
| D | lg-laptop.rst | 77 The keyboard backlight is also controlled by the key combination FN-F8
84 On the F5 key. Controlled by led device names tpad_led.
|
| /Documentation/devicetree/bindings/display/ti/ |
| D | ti,omap5-dss.txt | 56 - RFBI controlled peripherals
74 - DSI controlled peripherals
|
| /Documentation/devicetree/bindings/net/ |
| D | micrel-ks8995.txt | 1 Micrel KS8995 SPI controlled Ethernet Switch families
|
| /Documentation/cpu-freq/ |
| D | cpufreq-nforce2.txt | 5 can be controlled independently from the PCI/AGP clock.
|
| /Documentation/networking/ |
| D | net_failover.rst | 24 datapath. It also enables hypervisor controlled live migration of a VM with
31 net_failover enables hypervisor controlled accelerated datapath to virtio-net
79 net_failover also enables hypervisor controlled live migration to be supported
|
12345678910>>...13