Searched full:counting (Results 1 – 25 of 69) sorted by relevance
123
| /Documentation/ABI/testing/ |
| D | sysfs-bus-iio-timer-stm32 | 89 When counting up the counter starts from 0 and fires an
91 When counting down the counter start from preset value
105 counting direction is set by in_count0_count_direction
111 Counting is enabled when connected trigger signal
112 level is high else counting is disabled.
115 Counting is enabled on rising edge of the connected
130 counting direction is set by in_count0_count_direction
|
| D | sysfs-bus-iio-counter-104-quad-8 | 25 Counting is continuous in either direction.
31 counter freezes at count = preset when counting up, and
32 at count = 0 when counting down. At either of these
33 limits, the counting is resumed only when the count
45 counting up, while the counter is set to the preset
46 value at count = 0 when counting down; the counter does
|
| D | sysfs-bus-counter | 30 Counting is continuous in either direction.
37 count = ceiling when counting up, and at count = floor
38 when counting down. At either of these limits, the
39 counting is resumed only when the count direction is
52 counting up, while the counter is set to the Count Y
53 ceiling value at count = floor when counting down; the
76 their counting. For example, quadrature encoding counters can
|
| D | sysfs-class-net | 286 32-bit unsigned integer counting the number of times the link has
294 32-bit unsigned integer counting the number of times the link has
302 32-bit unsigned integer counting the number of times the link has
|
| D | sysfs-bus-iio-lptimer-stm32 | 43 In quadrature mode, encoder counting scenarios are as follows:
|
| /Documentation/arm64/ |
| D | perf.txt | 58 must enable/disable counting on the entry and exit to the guest. This is
80 able to eliminate counters counting host events on the boundaries of guest
81 entry/exit when counting guest events by filtering out EL2 for
|
| /Documentation/devicetree/bindings/arc/ |
| D | archs-pct.txt | 3 The ARC HS can be configured with a pipeline performance monitor for counting
|
| D | pct.txt | 3 The ARC700 can be configured with a pipeline performance monitor for counting
|
| /Documentation/devicetree/bindings/perf/ |
| D | nds32v3-pmu.txt | 3 NDS32 core have a PMU for counting cpu and cache events like cache misses.
|
| /Documentation/misc-devices/ |
| D | apds990x.txt | 52 RW - enable / disable chip. Uses counting logic
95 RW - enable / disable proximity - uses counting logic
|
| D | bh1770glc.txt | 51 RW - enable / disable chip. Uses counting logic
93 RW - enable / disable proximity - uses counting logic
|
| /Documentation/devicetree/bindings/rtc/ |
| D | rtc-sh.txt | 11 first (if exists). Additionally, potential clock counting sources are to be
|
| /Documentation/devicetree/bindings/watchdog/ |
| D | gpio-wdt.txt | 11 - level: Low or high level starts counting WDT timeout,
|
| D | atmel-sama5d4-wdt.txt | 18 watchdog not counting when the CPU is in idle state, therefore the
|
| D | atmel-wdt.txt | 31 watchdog not counting when the CPU is in idle state, therefore the
|
| /Documentation/admin-guide/perf/ |
| D | arm_dsu_pmu.rst | 7 allows counting the various events related to the L3 cache, Snoop Control Unit
|
| D | imx-ddr.rst | 13 interrupt is raised. If any other counter overflows, it continues counting, and
|
| D | hisi-pmu.rst | 18 Each device PMU has separate registers for event counting, control and
|
| /Documentation/RCU/ |
| D | rcuref.txt | 12 Reference counting on elements of lists which are protected by traditional
150 reference counting of struct pid, while the pattern in listing B is used by
|
| /Documentation/admin-guide/device-mapper/ |
| D | dm-flakey.rst | 56 Counting starts at 1, to replace the first byte.
|
| /Documentation/devicetree/bindings/arm/ |
| D | pmu.yaml | 14 ARM cores often have a PMU for counting cpu and cache events like cache misses
|
| /Documentation/admin-guide/sysctl/ |
| D | user.rst | 33 This recursive counting of created objects ensures that creating a
|
| /Documentation/core-api/ |
| D | local_ops.rst | 98 Counting chapter
101 Counting is done on all the bits of a signed long.
|
| /Documentation/filesystems/nfs/ |
| D | pnfs.txt | 1 Reference counting in pnfs:
|
| /Documentation/cpu-freq/ |
| D | core.txt | 41 Reference counting of the cpufreq policies is done by cpufreq_cpu_get
|
123