Searched full:disabling (Results 1 – 25 of 133) sorted by relevance
123456
| /Documentation/ |
| D | preempt-locking.txt | 35 protect these situations by disabling preemption around them.
72 Data protection under preemption is achieved by disabling preemption for the
93 disabling preemption - any cond_resched() or cond_resched_lock() might trigger
95 reschedule. So use this implicit preemption-disabling property only if you
125 Preventing preemption using interrupt disabling
132 in doubt, rely on locking or explicit preemption disabling.
134 Note in 2.5 interrupt disabling is now only per-CPU (e.g. local).
|
| /Documentation/devicetree/bindings/powerpc/fsl/ |
| D | pmc.txt | 41 supports disabling and resuming devices at any time.
46 This sleep controller only supports disabling devices during system
53 disabling. This sleep controller does not support configuring devices
|
| /Documentation/devicetree/bindings/leds/backlight/ |
| D | gpio-backlight.txt | 5 - gpios: describes the gpio that is used for enabling/disabling the backlight.
|
| /Documentation/admin-guide/hw-vuln/ |
| D | l1tf.rst | 238 scenario. Disabling SMT might be a viable alternative for particular
279 completely. Disabling SMT can have a significant performance impact, but
281 The impact of disabling SMT needs also to be weighted against the impact
348 5. Disabling EPT
351 Disabling EPT for virtual machines provides full mitigation for L1TF even
353 managed and sanitized by the hypervisor. Though disabling EPT has a
360 address the performance impact of disabling SMT or EPT.
531 - Disabling SMT:
533 Disabling SMT and enforcing the L1D flushing provides the maximum
543 - Disabling EPT:
[all …]
|
| /Documentation/devicetree/bindings/clock/ |
| D | gpio-gate-clock.txt | 10 - enable-gpios : GPIO reference for enabling and disabling the clock.
|
| /Documentation/devicetree/bindings/net/nfc/ |
| D | s3fwrn5.txt | 7 - s3fwrn5,en-gpios: Output GPIO pin used for enabling/disabling the chip
|
| D | pn544.txt | 8 - enable-gpios: Output GPIO pin used for enabling/disabling the PN544
|
| D | nxp-nci.txt | 8 - enable-gpios: Output GPIO pin used for enabling/disabling the chip
|
| D | st21nfca.txt | 7 - enable-gpios: Output GPIO pin used for enabling/disabling the ST21NFCA
|
| /Documentation/devicetree/bindings/ata/ |
| D | ahci-da850.txt | 9 for enabling/disabling the SATA clock receiver
|
| /Documentation/devicetree/bindings/powerpc/opal/ |
| D | sensor-groups.txt | 26 sensor groups like clearing min/max, enabling/disabling sensor
|
| /Documentation/devicetree/bindings/gpio/ |
| D | intel,ixp4xx-gpio.txt | 8 actual enabling/disabling of the interrupt line is done in the
|
| /Documentation/networking/device_drivers/chelsio/ |
| D | cxgb.txt | 50 After disabling adaptive-rx, the timer latency value will be set to 50us.
51 You may set the timer latency after disabling adaptive-rx:
59 You may also provide a timer latency value while disabling adaptive-rx:
117 Disabling TCP timestamp:
120 Disabling SACK:
|
| /Documentation/devicetree/bindings/arm/firmware/ |
| D | sdei.txt | 10 and enabling/disabling events. Functions are invoked by trapping to the
|
| /Documentation/driver-api/mmc/ |
| D | mmc-tools.rst | 18 - Set the eMMC data sector size to 4KB by disabling emulation.
|
| /Documentation/devicetree/bindings/input/rmi4/ |
| D | rmi_f01.txt | 16 and 2 will enable nosleep (disabling sleep).
|
| D | rmi_2d_sensor.txt | 36 - syna,disable-report-mask: Mask for disabling posiiton reporting. Used to
|
| /Documentation/devicetree/bindings/mips/ |
| D | mscc.txt | 32 the CPU: 8 general purpose registers, reset control, CPU en/disabling, CPU
|
| /Documentation/x86/ |
| D | usb-legacy-support.rst | 41 can currently only be solved by either disabling HIGHMEM64G
|
| /Documentation/driver-api/usb/ |
| D | usb3-debug-port.rst | 76 [ 1815.999595] usb 4-3: LPM exit latency is zeroed, disabling LPM.
144 [ 79.475003] usb 2-2.1: LPM exit latency is zeroed, disabling LPM.
|
| /Documentation/driver-api/ |
| D | regulator.rst | 75 Enabling and disabling
78 The regulator API provides reference counted enabling and disabling of
|
| /Documentation/networking/device_drivers/3com/ |
| D | 3c509.txt | 93 collisions. This is one of very rare circumstances where disabling auto-
134 - some other device or device driver hogging the bus or disabling interrupts.
156 with all. This can be fixed by disabling PnP support using the 3Com-supplied
|
| /Documentation/devicetree/bindings/clock/ti/ |
| D | interface.txt | 31 - ti,bit-shift : bit shift for the bit enabling/disabling the clock (default 0)
|
| /Documentation/arm64/ |
| D | legacy_instructions.rst | 33 enabling/disabling of hardware support for the execution of these
|
| /Documentation/media/uapi/rc/ |
| D | lirc-set-wideband-receiver.rst | 43 allows enabling or disabling it.
|
123456