Searched full:during (Results 1 – 25 of 597) sorted by relevance
12345678910>>...24
| /Documentation/driver-api/firmware/ |
| D | firmware_cache.rst | 6 re-initialize devices. During resume there may be a period of time during which
7 firmware lookups are not possible, during this short period of time firmware
14 The firmware cache makes using certain firmware API calls safe during a device
16 the firmware by themselves for dealing with firmware loss during system resume.
44 as the firmware cache is set up during suspend, the timeout is set back to
|
| /Documentation/power/ |
| D | suspend-and-cpuhotplug.rst | 94 execution during resume):
156 in that during regular CPU hotplug, 0 is passed for the 'tasks_frozen'
157 argument. But during suspend, since the tasks are already frozen by the time
205 In the current design of the kernel, whenever a CPU is taken offline during
225 d. Handling microcode update during suspend/hibernate:
227 Strictly speaking, during a CPU hotplug operation which does not involve
229 off during a CPU offline. They are just put to the lowest C-states possible.
232 image during the CPU offline operation.
234 This is the usual scenario encountered during a resume after a suspend.
236 powered off, during restore it becomes necessary to apply the microcode
[all …]
|
| D | suspend-and-interrupts.rst | 12 Device interrupt request lines (IRQs) are generally disabled during system
29 Device IRQs are re-enabled during system resume, right before the "early" phase
37 There are interrupts that can legitimately trigger during the entire system
39 devices as well as during the time when nonboot CPUs are taken offline and
46 expected during the suspend-resume cycle, but does not guarantee that the
67 during system sleep so as to trigger a system wakeup when needed. For example,
83 re-enabled by resume_device_irqs() during the subsequent system resume. Also
|
| D | swsusp.rst | 74 1) During lateinit: If resume=/dev/your_swap_partition is specified on
158 * require half of memory to be free during suspend. That way you can
163 during suspending, but otherwise it would work...
195 kernel threads are controlled during hibernation or system-wide suspend (on some
217 Do selective suspend during runtime power management, that's okay. But
269 What happens to devices during swsusp? They seem to be resumed
270 during system suspend?
336 During suspend a temporary key is created and this key is used to
337 encrypt the data written to disk. When, during resume, the data was
339 means that all data written to disk during suspend are then
[all …]
|
| /Documentation/ABI/stable/ |
| D | sysfs-bus-firewire | 7 Read-only. Mutable during the node device's lifetime.
26 Read-only. Mutable during the node device's lifetime.
59 Read-only. Immutable during the unit device's lifetime.
77 Read-only. Mutable during the node device's lifetime.
78 Immutable during the unit device's lifetime.
125 Read-only attribute, immutable during the target's lifetime.
|
| /Documentation/devicetree/bindings/net/wireless/ |
| D | marvell-8xxx.txt | 20 represent calibration data downloaded to the device during
31 during suspend/resume.
33 this interrupt number. during system suspend, the irq will be enabled
35 during system resume, the irq will be disabled to make sure
|
| /Documentation/x86/ |
| D | microcode.rst | 20 The kernel can update microcode very early during boot. Loading
21 microcode early can fix CPU issues before they are observed during
24 The microcode is stored in an initrd file. During boot, it is read from
29 loader parses the combined initrd image during boot.
38 During BSP (BootStrapping Processor) boot (pre-SMP), the kernel
|
| /Documentation/devicetree/bindings/iio/ |
| D | sensorhub.txt | 10 - ap-mcu-gpios: [out] ap to sensorhub line - used during communication
11 - mcu-ap-gpios: [in] sensorhub to ap - used during communication
|
| /Documentation/ABI/testing/ |
| D | sysfs-bus-iio-frequency-adf4350 | 17 change during runtime. This attribute allows the user to
21 down the PLL and its RFOut buffers during REFin changes.
|
| D | sysfs-class-mic | 47 during OSPM suspend.
68 An Intel MIC device runs a Linux OS during its operation. This
84 An Intel MIC device runs a Linux OS during its operation. Before
111 /lib/firmware/ where the ramdisk image to be used during card
131 An Intel MIC device runs a Linux OS during its operation. For
145 An Intel MIC device runs a Linux OS during its operation. For
|
| D | sysfs-driver-bd9571mwv-regulator | 6 if DDR power rails will be kept powered during system suspend.
11 PMIC will be configured only during system suspend.
|
| D | sysfs-bus-iio-health-afe440x | 33 Transimpedance Amplifier during the associated stage.
40 Get and set the LED current for the specified LED active during
|
| D | sysfs-class-net-phydev | 25 by the device during bus enumeration, encoded in hexadecimal.
35 Ethernet driver during bus enumeration, encoded in string.
|
| /Documentation/devicetree/bindings/iio/adc/ |
| D | adi,ad7780.yaml | 47 specified, it will be asserted during driver probe. As the
54 the ad778x chips. If specified, it will be asserted during
63 during driver probe. As the line is active low, it should be
|
| /Documentation/driver-api/thermal/ |
| D | intel_powerclamp.rst | 92 kidle_inject/cpu. During idle injection, it runs monitor/mwait idle
96 The NOHZ schedule tick is disabled during idle time, but interrupts
142 During scalability testing, it is observed that synchronized actions
160 When an excessive amount of wakeups occurs during idle, an
202 Calibration occurs during runtime. No offline method is available.
206 collected during a period without extra interrupts is considered
209 To compensate for excessive amounts of wakeup during idle, additional
233 percent. As mentioned earlier, since interrupts are allowed during
244 with the changes. During this time, idle injection is out of sync,
|
| /Documentation/devicetree/bindings/regulator/ |
| D | max77802.txt | 52 the consumers during normal operation while others only support to change the
53 mode during system suspend. The standard regulator suspend states binding can
57 changing their mode during normal operation are: LDOs 1, 3, 20 and 21.
67 support changing their mode to Low Power Mode during suspend. These regulators
|
| /Documentation/driver-api/pm/ |
| D | notifiers.rst | 37 error occurred during hibernation. Device restore callbacks have been
46 An error occurred during restore from hibernation. Device restore
53 The system has just resumed or an error occurred during suspend. Device
|
| /Documentation/virt/kvm/ |
| D | halt-polling.txt | 14 dependant. In the event that no wakeup source arrives during the polling
44 During polling if a wakeup source is received within the halt polling interval,
46 received during the polling interval (and thus schedule is invoked) there are
53 the hope that next time during the longer polling interval the wake up source
61 max) to wakeup during the polling interval so it may as well be shrunk in order
123 wakeups during which very little work is done and which are quite far apart, if
|
| /Documentation/devicetree/bindings/clock/ |
| D | silabs,si570.txt | 29 frequency set during boot. It can be reprogrammed during
|
| /Documentation/devicetree/bindings/net/ |
| D | marvell-bt-8xxx.txt | 16 - marvell,cal-data: Calibration data downloaded to the device during
31 During system suspend, the irq will be enabled so that the
33 conditions. During system resume, the irq will be disabled
|
| D | btusb.txt | 24 request this interrupt for wakeup. During system suspend, the
26 platform out of band. During system resume, the irq will be
|
| /Documentation/driver-api/soundwire/ |
| D | error_handling.rst | 23 slots) or electrical issues during the transmit/receive transition cannot
50 Errors during global reconfiguration sequences are extremely difficult to
53 1. BankSwitch: An error during the last command issuing a BankSwitch is
|
| /Documentation/powerpc/ |
| D | firmware-assisted-dump.rst | 45 Power firmware for dump preservation during OS initialization.
47 kernel during early boot.
76 there is crash data available from a previous boot. During
126 During boot, a check is made to see if firmware supports
129 then everything but boot memory size of RAM is reserved during
154 o Memory Reservation during first kernel
183 o Memory Reservation during second kernel after crash
272 This file is available only when FADump is active during
289 active during capture kernel. This is used to release the memory
310 Contents when FADump is registered during first kernel::
[all …]
|
| /Documentation/media/uapi/dvb/ |
| D | fe-read-uncorrected-blocks.rst | 44 device driver during its lifetime. For meaningful measurements, the
45 increment in block count during a specific time interval should be
|
| /Documentation/devicetree/bindings/sound/ |
| D | davinci-mcasp-audio.txt | 33 - dismod : Specify the drive on TX pin during inactive slots
38 - sram-size-playback : size of sram to be allocated during playback
39 - sram-size-capture : size of sram to be allocated during capture
|
12345678910>>...24