Searched full:four (Results 1 – 25 of 317) sorted by relevance
12345678910>>...13
| /Documentation/filesystems/ |
| D | spufs.txt | 77 If a count smaller than four is requested, read returns -1 and
80 When data has been read successfully, four bytes are placed in
81 the data buffer and the value four is returned.
91 If a count smaller than four is requested, read returns -1 and
99 When data has been read successfully, four bytes are placed in
100 the data buffer and the value four is returned.
112 four is requested, write returns -1 and sets errno to EINVAL. If there
120 fully, four bytes are placed in the data buffer and the value four is
138 If a count smaller than four is requested, read returns -1 and
139 sets errno to EINVAL. Otherwise, a four byte value is placed in
[all …]
|
| /Documentation/hwmon/ |
| D | ntc_thermistor.rst | 37 and four circuit models with an option not to use any of the four models.
44 The four circuit models provided are:
94 When one of the four circuit models is used, read_uV, pullup_uV, pullup_ohm,
95 pulldown_ohm, and connect should be provided. When none of the four models
|
| D | lm83.rst | 37 will be reported instead of four.
72 are sufficient, and there is no need for a four temperatures sensor
92 all four sensors. There is no hysteresis mechanism as found on most
|
| D | emc1403.rst | 56 contain up to four temperature sensors. EMC14x2 support two sensors
58 two external), and EMC14x4 support four sensors (one internal, three
|
| D | adt7470.rst | 24 external temperatures. It has four (4) 16-bit counters for measuring fan speed.
25 There are four (4) PWM outputs that can be used to control fan speed.
|
| /Documentation/sound/cards/ |
| D | img-spdif-in.rst | 24 This control is used to attempt acquisition of up to four different sample
31 four sample rates set here.
33 If less than four rates are required, the same rate can be specified more than
|
| D | serial-u16550.rst | 38 all four MIDI Out connectors. Set the A-B switch and the speed module
50 the same data to all four MIDI Out connectors at full MIDI speed.
65 Out for each byte, so the aggregate data rate across all four MIDI Outs is
|
| /Documentation/devicetree/bindings/media/ |
| D | imx.txt | 32 gasket demultiplexes the four virtual channel streams from the host
33 controller's 32-bit output image bus onto four 16-bit parallel busses
48 bus sink endpoint nodes and correspond to the four
|
| /Documentation/devicetree/bindings/timer/ |
| D | samsung,exynos4210-mct.txt | 6 four preset counter values. The CPU local timers are 32-bit free running
21 should be specified after the four global timer interrupts have been
41 in addition to four global timer interrupts.
73 Example 3: In this example, the IP contains four local timers, but using
|
| /Documentation/networking/ |
| D | ila.txt | 30 independent of its location. ILA identifiers are sixty-four
35 locators are sixty-four bit prefixes.
44 four bits) and an identifier (lower sixty-four bits).
50 An IPv6 address composed of a locator (upper sixty-four
51 bits) and an identifier (low order sixty-four bits). ILA
176 unstructured sixty-four bit value.
187 still sixty-four bits.
240 ILA router) or an ILA address (egress ILA router). LOC is the sixty-four
241 bit locator (with format W:X:Y:Z) that overwrites the upper sixty-four
254 sixty-four bits of the destination address. MODE and TYPE have the
|
| /Documentation/ABI/testing/ |
| D | sysfs-class-chromeos-driver-cros-ec-lightbar | 37 The values written to this file are sets of four integers,
39 to select a single segment, or 4 to set all four segments
43 more than one set of four integers.
|
| D | sysfs-driver-wacom | 47 Writing to this file sets which one of the four (for Intuos 4
48 and Intuos 5) or of the right four (for Cintiq 21UX2 and Cintiq
57 Writing to this file sets which one of the left four (for Cintiq 21UX2
|
| /Documentation/media/uapi/v4l/ |
| D | pixfmt-yuv410.rst | 31 belongs to 16 pixels, a four-by-four square of the image. Following the
37 have ¼ as many pad bytes after their rows. In other words, four Cx rows
|
| D | pixfmt-yvyu.rst | 24 In this format each four bytes is two pixels. Each four bytes is two
|
| D | pixfmt-yuyv.rst | 24 In this format each four bytes is two pixels. Each four bytes is two
|
| /Documentation/devicetree/bindings/display/imx/ |
| D | hdmi.txt | 19 - ports: See dw_hdmi.txt. The DWC HDMI shall have between one and four ports,
20 numbered 0 to 3, corresponding to the four inputs of the HDMI multiplexer.
|
| D | ldb.txt | 14 multiplexer in the front to select any of the four IPU display
58 On i.MX6, there should be four input ports (port@[0-3]) that correspond
59 to the four LVDS multiplexer inputs.
|
| /Documentation/admin-guide/ |
| D | vga-softcursor.rst | 37 VGA, the high four bits specify background and the low four the
|
| /Documentation/devicetree/bindings/power/supply/ |
| D | sbs,sbs-manager.txt | 16 four smart battery devices at address 0xb. The driver actually implements this
17 behaviour. So standard i2c-mux nodes can be used to register up to four slave
|
| /Documentation/input/devices/ |
| D | walkera0701.rst | 107 Values for first four channels (analog joystick values) can be found in
112 Next nibbles 12 .. 21 represents four channels (not all channels can be
114 four channels. In nibbles 22 and 23 is a special magic number. Nibble 24 is
|
| /Documentation/devicetree/bindings/leds/ |
| D | leds-lm36274.txt | 3 The LM36274 is an integrated four-channel WLED driver and LCD bias supply.
4 The backlight boost provides the power to bias four parallel LED strings with
|
| /Documentation/devicetree/bindings/dma/ |
| D | snps-dma.txt | 52 described in the dma.txt file, using a four-cell specifier for each channel.
53 The four cells in order are:
|
| D | stm32-dma.txt | 44 described in the dma.txt file, using a four-cell specifier for each
45 channel: a phandle to the DMA controller plus the following four integer cells:
|
| /Documentation/i2c/busses/ |
| D | i2c-mlxcpld.rst | 52 For write transaction address is specified in four first bytes
55 specified in the four first bytes (DATA0 - DATA3). Data is read
|
| /Documentation/ |
| D | DMA-ISA-LPC.txt | 68 A normal ISA DMA controller has 8 channels. The lower four are for
69 8-bit transfers and the upper four are for 16-bit transfers.
73 This means that of the four 16-bits channels only three are usable.)
|
12345678910>>...13