Searched full:generic (Results 1 – 25 of 980) sorted by relevance
12345678910>>...40
| /Documentation/networking/ |
| D | devlink-params-bnxt.txt | 1 enable_sriov [DEVICE, GENERIC]
4 ignore_ari [DEVICE, GENERIC]
7 msix_vec_per_pf_max [DEVICE, GENERIC]
10 msix_vec_per_pf_min [DEVICE, GENERIC]
14 Generic Routing Encapsulation (GRE) version check will
|
| D | devlink-params.txt | 4 Each parameter can be generic or driver specific and are device level
7 Note that the driver-specific files should contain the generic params
19 enable_sriov [DEVICE, GENERIC]
24 ignore_ari [DEVICE, GENERIC]
32 msix_vec_per_pf_max [DEVICE, GENERIC]
38 msix_vec_per_pf_min [DEVICE, GENERIC]
44 fw_load_policy [DEVICE, GENERIC]
55 reset_dev_on_drv_probe [DEVICE, GENERIC]
|
| D | ppp_generic.txt | 1 PPP Generic Driver and Channel Interface
8 The generic PPP driver in linux-2.4 provides an implementation of the
21 For sending and receiving PPP frames, the generic PPP driver calls on
25 has a very simple interface with the generic PPP code: it merely has
33 be linked to each ppp network interface unit. The generic layer is
42 functions used to communicate between the generic PPP layer and PPP
45 Each channel has to provide two functions to the generic PPP layer,
48 * start_xmit() is called by the generic layer when it has a frame to
52 later time when it can accept frames again, and the generic layer
62 The generic PPP layer provides seven functions to channels:
[all …]
|
| D | devlink-params-nfp.txt | 1 fw_load_policy [DEVICE, GENERIC]
4 reset_dev_on_drv_probe [DEVICE, GENERIC]
|
| /Documentation/core-api/ |
| D | generic-radix-tree.rst | 2 Generic radix trees/sparse arrays
5 .. kernel-doc:: include/linux/generic-radix-tree.h
6 :doc: Generic radix trees/sparse arrays
8 generic radix tree functions
11 .. kernel-doc:: include/linux/generic-radix-tree.h
|
| D | genericirq.rst | 4 Linux generic IRQ handling
13 The generic interrupt handling layer is designed to provide a complete
16 drivers use generic API functions to request, enable, disable and free
23 generic IRQ handling layer.
68 reveals that most of them can use a generic set of 'irq flow' methods
75 which is normally one of the generic implementations. (This high-level
80 The separation makes the generic interrupt handling layer more flexible
81 and extensible. For example, an (sub)architecture can use a generic
119 into the generic interrupt code by calling :c:func:`desc->handle_irq`. This
155 The generic layer provides a set of pre-defined irq-flow methods:
[all …]
|
| /Documentation/devicetree/bindings/usb/ |
| D | usb-xhci.txt | 6 - "generic-xhci" for generic XHCI device
21 - "renesas,rcar-gen2-xhci" for a generic R-Car Gen2 or RZ/G1 compatible
23 - "renesas,rcar-gen3-xhci" for a generic R-Car Gen3 or RZ/G2 compatible
27 When compatible with the generic version, nodes must list the
29 followed by the generic version.
52 compatible = "generic-xhci";
|
| D | usb-uhci.txt | 1 Generic Platform UHCI Controller
5 - compatible : "generic-uhci" (deprecated: "platform-uhci")
15 compatible = "generic-uhci";
|
| D | generic-ehci.yaml | 4 $id: http://devicetree.org/schemas/usb/generic-ehci.yaml#
18 const: generic-ehci
82 compatible = "ibm,usb-ehci-440epx", "generic-ehci";
91 compatible = "allwinner,sun4i-a10-ehci", "generic-ehci";
|
| /Documentation/devicetree/bindings/ata/ |
| D | sata_rcar.txt | 12 - "renesas,rcar-gen2-sata" for a generic R-Car Gen2 compatible device
13 - "renesas,rcar-gen3-sata" for a generic R-Car Gen3 compatible device
16 When compatible with the generic version nodes
18 to the platform first followed by the generic
|
| /Documentation/devicetree/bindings/display/bridge/ |
| D | ptn3460.txt | 11 | 0 | 1024x768 | NXP Generic |
12 | 1 | 1920x1080 | NXP Generic |
13 | 2 | 1920x1080 | NXP Generic |
16 | 5 | 1366x768 | NXP Generic |
|
| /Documentation/driver-api/driver-model/ |
| D | porting.rst | 21 be embedded in larger, bus-specific objects. Fields in these generic
24 The generic objects must be registered with the driver model core. By
102 struct device dev; /* Generic device interface */
106 It is recommended that the generic device not be the first item in
109 should be created to convert from the generic object type::
128 bus driver should initialize the generic device. The most important
167 Once the generic device has been initialized, it can be registered
244 - Initialize the generic driver structure.
253 After the generic driver has been initialized, call::
281 Step 4: Define Generic Methods for Drivers.
[all …]
|
| /Documentation/devicetree/bindings/spi/ |
| D | spi-ath79.txt | 8 - #address-cells: <1>, as required by generic SPI binding.
9 - #size-cells: <0>, also as required by generic SPI binding.
11 Child nodes as per the generic SPI binding.
|
| D | spi-bcm63xx.txt | 9 - #address-cells: <1>, as required by generic SPI binding.
10 - #size-cells: <0>, also as required by generic SPI binding.
16 Child nodes as per the generic SPI binding.
|
| D | spi-bcm63xx-hsspi.txt | 9 - #address-cells: <1>, as required by generic SPI binding.
10 - #size-cells: <0>, also as required by generic SPI binding.
16 Child nodes as per the generic SPI binding.
|
| D | spi-octeon.txt | 7 - #address-cells : <1>, as required by generic SPI binding.
8 - #size-cells : <0>, also as required by generic SPI binding.
10 Child nodes as per the generic SPI binding.
|
| /Documentation/hwmon/ |
| D | pwm-fan.rst | 5 generic PWM interface thus it is hardware independent. It can be used on
7 the generic PWM API.
15 a PWM output. It uses the generic PWM interface, thus it can be used with
|
| /Documentation/driver-api/memory-devices/ |
| D | ti-gpmc.rst | 20 GPMC generic timing calculation:
29 generic timing routine was developed to achieve above requirements.
31 Generic routine provides a generic method to calculate gpmc timings
40 field as required by peripheral, educate generic timing routine to
45 Generic timing routine has been verified to work properly on
48 A word of caution: generic timing routine has been developed based
|
| /Documentation/devicetree/bindings/i2c/ |
| D | renesas,iic.txt | 22 - "renesas,rcar-gen2-iic" (generic R-Car Gen2 or RZ/G1
24 - "renesas,rcar-gen3-iic" (generic R-Car Gen3 or RZ/G2
26 - "renesas,rmobile-iic" (generic device)
28 When compatible with a generic R-Car version, nodes
30 the platform first followed by the generic R-Car
|
| D | renesas,i2c.txt | 25 "renesas,rcar-gen1-i2c" for a generic R-Car Gen1 compatible device.
26 "renesas,rcar-gen2-i2c" for a generic R-Car Gen2 or RZ/G1 compatible
28 "renesas,rcar-gen3-i2c" for a generic R-Car Gen3 or RZ/G2 compatible
32 When compatible with the generic version, nodes must list the
34 by the generic version.
|
| /Documentation/devicetree/bindings/watchdog/ |
| D | sbsa-gwdt.txt | 1 * SBSA (Server Base System Architecture) Generic Watchdog
3 The SBSA Generic Watchdog Timer is used to force a reset of the system
18 Peripheral Interrupt) number of SBSA Generic Watchdog.
|
| /Documentation/devicetree/bindings/sound/ |
| D | fsl-asoc-card.txt | 1 Freescale Generic ASoC Sound Card with ASRC support
3 The Freescale Generic ASoC Sound Card can be used, ideally, for all Freescale
6 The idea of this generic sound card is a bit like ASoC Simple Card. However,
12 So having this generic sound card allows all Freescale SoC users to benefit
22 The compatible list for this generic sound card currently:
|
| /Documentation/driver-api/ |
| D | generic-counter.rst | 4 Generic Counter Interface
14 drivers by introducing a generic counter interface for consumption. The
15 Generic Counter interface enables drivers to support and expose a common
25 the Generic Counter interface.
41 A Count represents the count data for a set of Signals. The Generic
48 for the count data. The Generic Counter interface provides the following
98 The Generic Counter interface provides the following available signal
120 count data. The Generic Counter interface provides the following
139 context of the Generic Counter interface, a counter consists of Counts
233 Several sysfs attributes are generated by the Generic Counter interface,
[all …]
|
| /Documentation/media/dvb-drivers/ |
| D | technisat.rst | 58 #) => ``Generic I2C PLL based tuners``
63 #) => ``Generic I2C PLL based tuners``
80 #) => ``Generic I2C PLL based tuners``
85 #) => ``Generic I2C PLL based tuners``
94 #) => ``Generic I2C PLL based tuners``
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | mscc,ocelot-pinctrl.txt | 16 The ocelot-pinctrl driver uses the generic pin multiplexing and generic pin
19 The following generic properties are supported:
|
12345678910>>...40