Searched full:increased (Results 1 – 25 of 82) sorted by relevance
1234
| /Documentation/ABI/stable/ |
| D | sysfs-devices-system-xen_memory | 17 increased to. The default value is 32 seconds.
37 increased, 'schedule_delay' is increased (until
|
| /Documentation/media/uapi/dvb/ |
| D | frontend-stat-properties.rst | 114 This measurement is monotonically increased, as the frontend gets more
142 This measurement is monotonically increased, as the frontend gets more
171 This measurement is monotonically increased, as the frontend gets more
199 This measurement is monotonically increased, as the frontend gets more
220 This measurement is monotonically increased, as the frontend gets more
|
| /Documentation/scsi/ |
| D | link_power_management_policy.txt | 8 sacrifice some performance due to increased latency
|
| /Documentation/bpf/ |
| D | prog_cgroup_sockopt.rst | 30 Note, that ``optlen`` can not be increased beyond the user-supplied
47 has been increased above initial ``getsockopt`` value (i.e. userspace
|
| /Documentation/networking/ |
| D | snmp_counter.rst | 21 IpExtInOctets. It will be increased even if the packet is dropped
77 Defined in `RFC1213 ipInAddrErrors`_. It will be increased in two
93 Defined in `RFC1213 ipInUnknownProtos`_. It will be increased if the
96 and this counter won't be increased.
137 would be increased even if the ICMP packet has an invalid type. The
227 is increased, IcmpInErrors would always be increased too.
528 TcpExtTCPAbortFailed will be increased.
1064 IcmpOutMsgs, IcmpOutEchos and IcmpMsgOutType8 were increased 1. The
1066 IcmpInEchoReps and IcmpMsgInType0 were increased 1. The ICMP Echo Reply
1068 increased 1. The default ping data size is 48, so an ICMP Echo packet
[all …]
|
| D | netif-msg.txt | 16 level ranged from 0 to 7, and monotonically increased in verbosity.
|
| /Documentation/devicetree/bindings/iio/adc/ |
| D | ti-adc12138.txt | 22 For high source impedances, this value can be increased to 18 or 34.
|
| /Documentation/virtual/ |
| D | guest-halt-polling.txt | 54 be increased from 10000, to avoid misses during the initial
|
| /Documentation/filesystems/ |
| D | qnx6.txt | 39 serial of the new master superblock is increased (old superblock serial + 1)
171 superblock atomically is increased and the fs switches over to that - then
|
| /Documentation/virt/kvm/ |
| D | halt-polling.txt | 32 as the halt polling interval, is increased and decreased based on the perceived
52 the global max polling interval then the polling interval can be increased in
|
| /Documentation/hwmon/ |
| D | nct6775.rst | 215 milliseconds before fan speed is increased
265 milliseconds before fan speed is increased
|
| /Documentation/admin-guide/device-mapper/ |
| D | dm-uevent.rst | 8 is the event contains environment attributes providing increased context for
|
| D | cache-policies.rst | 51 improved performance and increased adaptability in the face of changing
|
| D | switch.rst | 37 increased network bandwidth. An initiator could use a simple round
|
| /Documentation/devicetree/bindings/mmc/ |
| D | sdhci-cadence.txt | 26 and it is increased by 2.5ns in each step.
|
| /Documentation/devicetree/bindings/spi/ |
| D | spi-controller.yaml | 32 increased automatically with max(cs-gpios, hardware chip selects).
|
| /Documentation/networking/device_drivers/intel/ |
| D | e1000e.rst | 54 increased CPU utilization, though it may help throughput in some circumstances.
85 to the increased CPU utilization of the higher interrupt rate.
95 increased stepwise to 20000. This default mode is suitable for most
|
| D | e1000.rst | 131 latency" or "Lowest latency" class, the InterruptThrottleRate is increased
137 the same as mode 3, the InterruptThrottleRate will be increased stepwise to
194 incoming packets, at the expense of increased system memory utilization.
|
| /Documentation/ABI/testing/ |
| D | sysfs-class-scsi_host | 43 performance due to increased latency when coming out of lower
|
| /Documentation/admin-guide/acpi/ |
| D | initrd_table_override.rst | 91 # reboot with increased acpi debug level, e.g. boot params:
|
| /Documentation/devicetree/bindings/powerpc/fsl/ |
| D | msi-pic.txt | 8 version is 4.3, the number of MSI registers is increased to 16, MSIIR1 is
|
| /Documentation/devicetree/bindings/sound/ |
| D | cs35l33.txt | 80 The reference voltage starts at 3000mV with a value of 0x3 and is increased
|
| /Documentation/networking/device_drivers/amazon/ |
| D | ena.txt | 148 - Increased process-level parallelism when handling received packets.
149 - Increased data cache hit rate, by steering kernel processing of
|
| /Documentation/media/kapi/ |
| D | v4l2-device.rst | 122 increased whenever :c:func:`video_register_device` is called and it is
|
| /Documentation/admin-guide/ |
| D | svga.rst | 121 (as presented to INT 10, function 00) increased by 0x0100.
123 0x0200 to 0x08ff - VESA BIOS modes. The ID is a VESA mode ID increased by
|
1234