Searched full:listed (Results 1 – 25 of 448) sorted by relevance
12345678910>>...18
| /Documentation/devicetree/bindings/display/ |
| D | st,stih4xx.txt | 18 - clock-names: names of the clocks listed in clocks property in the same
36 - clock-names: names of the clocks listed in clocks property in the same
40 - reset-names: names of the resets listed in resets property in the same
49 - reg-names: names of the mapped memory regions listed in regs property in
53 - reset-names: names of the resets listed in resets property in the same
61 - reg-names: names of the mapped memory regions listed in regs property in
64 - interrupt-names: names of the interrupts listed in interrupts property in
68 - clock-names: names of the clocks listed in clocks property in the same
77 - reg-names: names of the mapped memory regions listed in regs property in
82 - clock-names: names of the clocks listed in clocks property in the same
[all …]
|
| /Documentation/devicetree/bindings/powerpc/fsl/ |
| D | pmc.txt | 6 "fsl,mpc8349-pmc" should be listed for any chip whose PMC is
7 compatible. "fsl,mpc8313-pmc" should also be listed for any chip
10 "fsl,mpc8548-pmc" should be listed for any chip whose PMC is
11 compatible. "fsl,mpc8536-pmc" should also be listed for any chip
14 "fsl,mpc8641d-pmc" should be listed for any chip whose PMC is
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | lantiq,pinctrl-falcon.txt | 21 Each subnode only affects those parameters that are explicitly listed. In
33 Valid values for these names are listed below.
35 group. Valid values for function names are listed below.
51 Valid values for these names are listed below.
|
| D | fsl,mxs-pinctrl.txt | 18 a group of pins, and only affects those parameters that are explicitly listed.
54 Valid values for these integers are listed below.
122 to be listed in the config nodes.
|
| /Documentation/ABI/testing/ |
| D | sysfs-bus-event_source-devices-hv_gpci | 14 0 or 1. Indicates whether we have access to "GA" events (listed
21 0 or 1. Indicates whether we have access to "EXPANDED" events (listed
28 0 or 1. Indicates whether we have access to "LAB" events (listed
|
| D | sysfs-driver-typec-displayport | 9 All supported configurations are listed as space separated list
32 listed as space separated list with the active one wrapped in
|
| D | sysfs-bus-counter-ftm-quaddec | 6 configuration are listed in this file. Values are delimited by
|
| D | sysfs-driver-hid-logitech-lg4ff | 14 mode is listed as follows:
20 of the wheel not all listed modes might always be selectable.
|
| /Documentation/devicetree/bindings/sound/ |
| D | st,sti-asoc-card.txt | 20 - clock-names: name of the clocks listed in clocks property in the same order
22 - reg: CPU DAI IP Base address and size entries, listed in same
25 - reg-names: names of the mapped memory regions listed in regs property in
28 - interrupts: CPU_DAI interrupt line, listed in the same order than the
31 - dma: CPU_DAI DMA controller phandle and DMA request line, listed in the same
39 - clocks: CPU_DAI IP clock source, listed in the same order than the
|
| /Documentation/devicetree/bindings/iio/accel/ |
| D | bma180.txt | 15 For the bma250 the first interrupt listed must be the one
17 listed must be the one connected to the INT2 pin.
|
| /Documentation/devicetree/bindings/media/ |
| D | st,st-hva.txt | 7 - reg-names: names of the registers listed in registers property in the same
13 - clock-names: names of the clocks listed in clocks property in the same order.
|
| D | qcom,camss.txt | 14 Definition: Register ranges as listed in the reg-names property.
36 Definition: Interrupts as listed in the interrupt-names property.
60 Definition: A list of phandle and clock specifier pairs as listed
|
| D | st,st-delta.txt | 8 - clock-names: names of the clocks listed in clocks property in the same order.
|
| /Documentation/devicetree/bindings/rtc/ |
| D | rtc-sh.txt | 10 - clocks: The functional clock source for the RTC controller must be listed
12 listed.
|
| /Documentation/devicetree/bindings/lpddr2/ |
| D | lpddr2.txt | 7 "ti,jedec-lpddr2-s2" should be listed if the memory part is LPDDR2-S2 type
9 "ti,jedec-lpddr2-s4" should be listed if the memory part is LPDDR2-S4 type
11 "ti,jedec-lpddr2-nvm" should be listed if the memory part is LPDDR2-NVM type
|
| /Documentation/devicetree/bindings/net/ |
| D | qca,ar71xx.txt | 18 - clock-names: the names of the clock listed in the clocks property. These are
21 - reset-names: Should contain the names of reset signal listed in the resets
|
| D | via-rhine.txt | 6 and similar. These are listed as 1106:3106 rev. 0x84 on the
|
| D | mdio-gpio.txt | 6 MDC and MDIO lines connected to GPIO controllers are listed in the
|
| /Documentation/devicetree/bindings/devfreq/event/ |
| D | exynos-ppmu.txt | 21 Example1 : PPMUv1 nodes in exynos3250.dtsi are listed below.
57 Example2 : Events of each PPMU node in exynos3250-rinato.dts are listed below.
111 Example3 : PPMUv2 nodes in exynos5433.dtsi are listed below.
|
| /Documentation/devicetree/bindings/arm/ |
| D | pmu.yaml | 54 the SPIs listed in the interrupts property.
58 a PMU of this type signalling the PPI listed in the
|
| D | spe-pmu.txt | 11 - interrupts : Exactly 1 PPI must be listed. For heterogeneous systems where
|
| /Documentation/devicetree/bindings/pci/ |
| D | hisilicon-histb-pcie.txt | 21 - clocks: List of phandle and clock specifier pairs as listed in clock-names
28 - resets: List of phandle and reset specifier pairs as listed in reset-names
|
| /Documentation/devicetree/bindings/interrupt-controller/ |
| D | renesas,h8300h-intc.txt | 12 - any properties, listed in interrupts.txt, and any standard resource allocation
|
| D | renesas,h8s-intc.txt | 12 - any properties, listed in interrupts.txt, and any standard resource allocation
|
| /Documentation/devicetree/bindings/mfd/ |
| D | da9062.txt | 44 The DA9062 regulators are bound using their names listed below:
55 The DA9061 regulators are bound using their names listed below:
|
12345678910>>...18