Searched full:panel (Results 1 – 25 of 237) sorted by relevance
12345678910
| /Documentation/devicetree/bindings/display/panel/ |
| D | ilitek,ili9322.txt | 1 Ilitek ILI9322 TFT panel driver with SPI control bus 4 streams that get adapted and scaled to the panel. The panel output has 9 - compatible: "dlink,dir-685-panel", "ilitek,ili9322" 11 - reg: address of the panel on the SPI bus 23 - pixelclk-active: see display/panel/display-timing.txt 24 - de-active: see display/panel/display-timing.txt 25 - hsync-active: see display/panel/display-timing.txt 26 - vsync-active: see display/panel/display-timing.txt 28 The panel must obey the rules for a SPI slave device as specified in 33 media/video-interfaces.txt. This node should describe panel's video bus. [all …]
|
| D | panel-common.yaml | 4 $id: http://devicetree.org/schemas/display/panel/panel-common.yaml# 18 When referenced from panel device tree bindings the properties defined in this 19 document are defined as follows. The panel device tree bindings are 36 The label property specifies a symbolic name for the panel as a 43 non-descriptive information. For instance an LCD panel in a system that 44 contains a single panel shall not be labelled "LCD" if that name is not 56 panel-timing: 60 require specific display timings. The panel-timing subnode expresses those 63 Documentation/devicetree/bindings/display/panel/display-timing.txt. 73 the nature of those connections is specific to the panel type, the [all …]
|
| D | friendlyarm,hd702e.txt | 1 FriendlyELEC HD702E 800x1280 LCD panel 3 HD702E lcd is FriendlyELEC developed eDP LCD panel with 800x1280 12 - backlight: phandle of the backlight device attached to the panel 15 - Video port for LCD panel input. 17 This binding is compatible with the simple-panel binding, which is specified 18 in simple-panel.txt in this directory. 22 panel { 23 compatible ="friendlyarm,hd702e", "simple-panel";
|
| D | samsung,ld9040.txt | 1 Samsung LD9040 AMOLED LCD parallel RGB panel with SPI control bus 5 - reg: address of the panel on SPI bus 9 - display-timings: timings for the connected panel according to [1] 11 The panel must obey rules for SPI slave device specified in document [2]. 16 - panel-width-mm: physical panel width [mm] 17 - panel-height-mm: physical panel height [mm] 21 node should describe panel's video bus. 23 [1]: Documentation/devicetree/bindings/display/panel/display-timing.txt 40 panel-width-mm = <90>; 41 panel-height-mm = <154>;
|
| D | samsung,s6e8aa0.txt | 1 Samsung S6E8AA0 AMOLED LCD 5.3 inch panel 9 - display-timings: timings for the connected panel as described by [1] 15 - panel-width-mm: physical panel width [mm] 16 - panel-height-mm: physical panel height [mm] 22 node should describe panel's video bus. 24 [1]: Documentation/devicetree/bindings/display/panel/display-timing.txt 29 panel { 38 panel-width-mm = <58>; 39 panel-height-mm = <103>;
|
| D | dlc,dlc1010gig.txt | 1 DLC Display Co. DLC1010GIG 10.1" WXGA TFT LCD Panel 5 - power-supply: See simple-panel.txt 8 - enable-gpios: See simple-panel.txt 9 - backlight: See simple-panel.txt 11 This binding is compatible with the simple-panel binding, which is specified 12 in simple-panel.txt in this directory.
|
| D | evervision,vgg804821.txt | 1 Evervision Electronics Co. Ltd. VGG804821 5.0" WVGA TFT LCD Panel 5 - power-supply: See simple-panel.txt 8 - backlight: See simple-panel.txt 9 - enable-gpios: See simple-panel.txt 11 This binding is compatible with the simple-panel binding, which is specified 12 in simple-panel.txt in this directory.
|
| D | osddisplays,osd070t1718-19ts.txt | 1 OSD Displays OSD070T1718-19TS 7" WVGA TFT LCD panel 5 - power-supply: see simple-panel.txt 8 - backlight: see simple-panel.txt 10 This binding is compatible with the simple-panel binding, which is specified 11 in simple-panel.txt in this directory. No other simple-panel properties than
|
| D | koe,tx31d200vm0baa.txt | 1 Kaohsiung Opto-Electronics. TX31D200VM0BAA 12.3" HSXGA LVDS panel 3 This binding is compatible with the simple-panel binding, which is specified 4 in simple-panel.txt in this directory. 10 - backlight: phandle of the backlight device attached to the panel 13 - Video port for LVDS panel input. 16 panel {
|
| D | boe,hv070wsa-100.txt | 1 BOE HV070WSA-100 7.01" WSVGA TFT LCD panel 6 - enable-gpios: GPIO pin to enable and disable panel (active high) 8 This binding is compatible with the simple-panel binding, which is specified 9 in simple-panel.txt in this directory. 13 node should describe panel's video bus. 19 panel: panel {
|
| D | rocktech,rk070er9427.txt | 1 Rocktech Display Ltd. RK070ER9427 800(RGB)x480 TFT LCD panel 3 This binding is compatible with the simple-panel binding, which is specified 4 in simple-panel.txt in this directory. 10 - backlight: phandle of the backlight device attached to the panel 13 - Video port for LCD panel input. 16 panel {
|
| D | panel-dpi.txt | 1 Generic MIPI DPI Panel 5 - compatible: "panel-dpi" 8 - label: a symbolic name for the panel 9 - enable-gpios: panel enable gpio 15 - "panel-timing" containing video timings 16 (Documentation/devicetree/bindings/display/panel/display-timing.txt) 23 compatible = "samsung,lte430wq-f0c", "panel-dpi"; 34 panel-timing {
|
| D | panel-dsi-cm.txt | 1 Generic MIPI DSI Command Mode Panel 5 - compatible: "panel-dsi-cm" 8 - label: a symbolic name for the panel 9 - reset-gpios: panel reset gpio 10 - te-gpios: panel TE gpio 19 compatible = "tpo,taal", "panel-dsi-cm";
|
| D | innolux,p120zdg-bf1.txt | 1 Innolux P120ZDG-BF1 12.02 inch eDP 2K display panel 3 This binding is compatible with the simple-panel binding, which is specified 4 in simple-panel.txt in this directory. 11 - enable-gpios: GPIO pin to enable or disable the panel 12 - backlight: phandle of the backlight device attached to the panel 16 panel_edp: panel-edp {
|
| D | ti,nspire.yaml | 4 $id: http://devicetree.org/schemas/display/panel/ti,nspire.yaml# 13 - $ref: panel-common.yaml# 18 - ti,nspire-cx-lcd-panel 19 - ti,nspire-classic-lcd-panel 29 panel { 30 compatible = "ti,nspire-cx-lcd-panel";
|
| D | ortustech,com37h3m99dtc.txt | 1 OrtusTech COM37H3M99DTC Blanview 3.7" VGA portrait TFT-LCD panel 7 - enable-gpios: GPIO pin to enable or disable the panel 8 - backlight: phandle of the backlight device attached to the panel 11 This binding is compatible with the simple-panel binding, which is specified 12 in simple-panel.txt in this directory.
|
| D | ortustech,com37h3m05dtc.txt | 1 OrtusTech COM37H3M05DTC Blanview 3.7" VGA portrait TFT-LCD panel 7 - enable-gpios: GPIO pin to enable or disable the panel 8 - backlight: phandle of the backlight device attached to the panel 11 This binding is compatible with the simple-panel binding, which is specified 12 in simple-panel.txt in this directory.
|
| D | sharp,lq035q7db03.txt | 1 Sharp LQ035Q7DB03 3.5" QVGA TFT LCD panel 8 - enable-gpios: GPIO pin to enable or disable the panel 9 - backlight: phandle of the backlight device attached to the panel 11 This binding is compatible with the simple-panel binding, which is specified 12 in simple-panel.txt in this directory.
|
| D | sharp,lq070y3dg3b.txt | 1 Sharp LQ070Y3DG3B 7.0" WVGA landscape TFT LCD panel 7 - enable-gpios: GPIO pin to enable or disable the panel 8 - backlight: phandle of the backlight device attached to the panel 11 This binding is compatible with the simple-panel binding, which is specified 12 in simple-panel.txt in this directory.
|
| D | mitsubishi,aa104xd12.yaml | 4 $id: http://devicetree.org/schemas/display/panel/mitsubishi,aa104xd12.yaml# 7 title: Mitsubishi AA104XD12 10.4" XGA LVDS Display Panel 20 - {} # panel-lvds, but not listed here to avoid false select 23 description: Reference to the regulator powering the panel VCC pins. 34 panel-timing: true 46 panel { 47 compatible = "mitsubishi,aa104xd12", "panel-lvds"; 55 panel-timing {
|
| D | mitsubishi,aa121td01.yaml | 4 $id: http://devicetree.org/schemas/display/panel/mitsubishi,aa121td01.yaml# 7 title: Mitsubishi AA121TD01 12.1" WXGA LVDS Display Panel 20 - {} # panel-lvds, but not listed here to avoid false select 23 description: Reference to the regulator powering the panel VCC pins. 34 panel-timing: true 45 panel { 46 compatible = "mitsubishi,aa121td01", "panel-lvds"; 54 panel-timing {
|
| D | sgd,gktw70sdae4se.yaml | 4 $id: http://devicetree.org/schemas/display/panel/sgd,gktw70sdae4se.yaml# 7 title: Solomon Goldentek Display GKTW70SDAE4SE 7" WVGA LVDS Display Panel 20 - {} # panel-lvds, but not listed here to avoid false select 31 panel-timing: true 41 panel { 42 compatible = "sgd,gktw70sdae4se", "panel-lvds"; 49 panel-timing {
|
| D | winstar,wf35ltiacd.txt | 1 Winstar Display Corporation 3.5" QVGA (320x240) TFT LCD panel 7 This binding is compatible with the simple-panel binding, which is specified 8 in simple-panel.txt in this directory. 26 panel: panel { 27 compatible = "winstar,wf35ltiacd", "simple-panel"; 45 regulator-name = "panel-power-supply";
|
| D | arm,versatile-tft-panel.txt | 10 - compatible: should be "arm,versatile-tft-panel" 13 - port: see display/panel/panel-common.yaml, graph.txt 22 panel: display@0 { 23 compatible = "arm,versatile-tft-panel";
|
| /Documentation/devicetree/bindings/display/tilcdc/ |
| D | panel.txt | 1 Device-Tree bindings for tilcdc DRM generic panel output driver 4 - compatible: value should be "ti,tilcdc,panel". 5 - panel-info: configuration info to configure LCDC correctly for the panel 15 - display-timings: typical videomode of lcd panel. Multiple video modes 16 can be listed if the panel supports multiple timings, but the 'native-mode' 18 Documentation/devicetree/bindings/display/panel/display-timing.txt for display 22 - backlight: phandle of the backlight device attached to the panel 23 - enable-gpios: GPIO pin to enable or disable the panel 33 compatible = "ti,tilcdc,panel"; 39 panel-info {
|
12345678910