Searched full:performed (Results 1 – 25 of 243) sorted by relevance
12345678910
| /Documentation/virtual/ |
| D | guest-halt-polling.txt | 9 1) The POLL flag is set while polling is performed, which allows
15 The downside of guest side polling is that polling is performed
33 performed before halting.
|
| /Documentation/watchdog/ |
| D | mlx-wdt.rst | 36 The last 2 actions are performed without a system reset.
50 initial timeout, performed action in expiration and configuration flags.
56 Access to HW registers is performed through a generic regmap interface.
|
| /Documentation/powerpc/ |
| D | syscall64-abi.rst | 50 The syscall is performed with the sc instruction, and returns with execution
59 will be performed as normal, and will return as normal. The syscall will be
60 performed in suspended state, so its side effects will be persistent according
69 be performed and the transaction will be doomed by the kernel with the
104 The vsyscall is performed with a branch-with-link instruction to the vsyscall
|
| D | transactional_memory.rst | 53 performed. Even though the normal ld/std instructions are used (note no
78 Syscalls made from within an active transaction will not be performed and the
82 Syscalls made from within a suspended transaction are performed as normal and
85 by the hardware. The syscall is performed in suspended mode so any side
|
| /Documentation/ABI/testing/ |
| D | sysfs-bus-counter-104-quad-8 | 28 is performed directly on the active level of the index
35 preset_enable) is performed synchronously with the
|
| D | configfs-usb-gadget-tcm | 6 is performed in the "target" subsystem of configfs.
|
| D | sysfs-bus-iio-counter-104-quad-8 | 124 set_to_preset_on_index) is performed directly on the
131 set_to_preset_on_index) is performed synchronously with
|
| /Documentation/networking/ |
| D | checksum-offloads.rst | 52 No offloading of the IP header checksum is performed; it is always done in
107 LCO is performed by the stack when constructing an outer UDP header for an
111 It is also performed when constructing an IPv4 GRE header, in
112 net/ipv4/ip_gre.c:build_header(). It is *not* currently performed when
|
| /Documentation/driver-api/serial/ |
| D | cyclades_z.rst | 6 operate. This operation should be performed during system startup,
|
| /Documentation/driver-api/md/ |
| D | raid5-ppl.rst | 21 contents. PPL recovery is also performed when starting an array after an
37 performed for this stripe (parity is not updated). So it is possible to have
|
| /Documentation/usb/ |
| D | mtouchusb.rst | 19 Performed multiple successful tests with an EXII-5010UC
54 the controller. This means calibration must be performed within the
|
| /Documentation/driver-api/soundwire/ |
| D | stream.rst | 139 to be performed like prepare, enable, disable, de-prepare etc.
186 of the stream. Operations performed before entering in this state:
189 runtime is used as a reference for all the operations performed
212 Configuration state of stream. Operations performed before entering in
247 Prepare state of stream. Operations performed before entering in this state:
286 Operations performed before entering in this state:
315 Operations performed before entering in this state:
343 De-prepare state of stream. Operations performed before entering in this
368 Release state of stream. Operations performed before entering in this state:
|
| /Documentation/virt/kvm/ |
| D | s390-diag.txt | 39 are performed.
80 If the function code specifies 0x501, breakpoint functions may be performed.
|
| /Documentation/driver-api/firmware/ |
| D | lookup-order.rst | 13 * The ''Direct filesystem lookup'' is performed next, if found we
|
| D | direct-fs-lookup.rst | 5 Direct filesystem lookup is the most common form of firmware lookup performed
|
| /Documentation/devicetree/bindings/rtc/ |
| D | rtc-cmos.txt | 16 instance). If this is not done, it can be performed by the driver.
|
| /Documentation/x86/ |
| D | tlb.rst | 21 1. The size of the flush being performed. A flush of the entire
22 address space is obviously better performed by flushing the
|
| /Documentation/devicetree/bindings/mmc/ |
| D | mmc-pwrseq-emmc.txt | 5 performed just after MMC core enabled power to the given mmc host (to
|
| /Documentation/devicetree/bindings/power/reset/ |
| D | syscon-poweroff.txt | 4 The poweroff is generally performed with a write to the poweroff register
|
| D | syscon-reboot.txt | 4 The reset is generally performed with a write to the reset register
|
| /Documentation/hwmon/ |
| D | mcp3021.rst | 35 Communication to the MCP3021/MCP3221 is performed using a 2-wire I2C
|
| /Documentation/devicetree/bindings/net/ |
| D | broadcom-bcm87xx.txt | 14 value of zero, no read of the existing value is performed.
|
| /Documentation/devicetree/bindings/sound/ |
| D | wm8962.txt | 21 performed. And note that only the value within [0x0, 0xffff] is valid.
|
| /Documentation/devicetree/bindings/mfd/ |
| D | syscon.txt | 18 performed on the device.
|
| /Documentation/media/uapi/v4l/ |
| D | pixfmt-bayer.rst | 20 performed on the image. The formats contain green, red and blue components, with
|
12345678910