Searched full:pullups (Results 1 – 11 of 11) sorted by relevance
| /Documentation/devicetree/bindings/gpio/ |
| D | gpio-twl4030.txt | 17 - ti,pullups : if n-th bit is set, set a pullup on GPIO-n
|
| /Documentation/devicetree/bindings/iio/imu/ |
| D | st_lsm6dsx.txt | 22 - st,pullups : enable/disable internal i2c controller pullup resistors.
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | pinctrl-sirf.txt | 10 - sirf,pullups : if n-th bit of m-th bank is set, set a pullup on GPIO-n of bank m
|
| D | pinctrl-mt6797.txt | 28 configuration, pullups, drive strength, input enable/disable and input schmitt.
|
| D | pinctrl-mt65xx.txt | 48 configuration, pullups, drive strength, input enable/disable and input schmitt.
|
| D | pinctrl-mt8183.txt | 31 configuration, pullups, drive strength, input enable/disable and input schmitt.
|
| D | allwinner,sunxi-pinctrl.txt | 73 configuration, drive strength and pullups. If one of these options is
|
| D | st,stm32-pinctrl.yaml | 126 configuration, pullups, drive, output high/low and output speed.
|
| /Documentation/spi/ |
| D | butterfly.rst | 43 (a) flash new firmware that disables SPI (set PRR.2, and disable pullups
|
| /Documentation/driver-api/gpio/ |
| D | legacy.rst | 159 and configure pullups/pulldowns appropriately.)
495 Related to multiplexing is configuration and enabling of the pullups or
498 pullups (or pulldowns) so that the on-chip ones should not be used.
|
| /Documentation/input/devices/ |
| D | joystick-parport.rst | 261 gamepads the pullups are not needed.
|