Searched full:regulators (Results 1 – 25 of 140) sorted by relevance
123456
| /Documentation/devicetree/bindings/regulator/ |
| D | qcom,rpmh-regulator.txt | 1 Qualcomm Technologies, Inc. RPMh Regulators
11 switches, and LDO/SMPS regulators which have a fixed voltage and mode.
17 RPMh regulators must be described in two levels of device nodes. The first
18 level describes the PMIC containing the regulators and must reside within an
20 which is to be used on the board. Each of these regulators maps to a single
40 "qcom,pm8005-rpmh-regulators"
41 "qcom,pm8009-rpmh-regulators"
42 "qcom,pm8150-rpmh-regulators"
43 "qcom,pm8150l-rpmh-regulators"
44 "qcom,pm8998-rpmh-regulators"
[all …]
|
| D | tps65217.txt | 1 TPS65217 family of regulators
6 - regulators: list of regulators provided by this controller, must be named
8 - regulators: This is the list of child nodes that specify the regulator
9 initialization data for defined regulators. Not all regulators for the given
11 using the standard binding for regulators found at
17 The valid names for regulators are:
20 Each regulator is defined using the standard binding for regulators.
28 regulators {
|
| D | tps65023.txt | 1 TPS65023 family of regulators
9 - regulators: list of regulators provided by this controller, must be named
11 - regulators: This is the list of child nodes that specify the regulator
12 initialization data for defined regulators. The definition for each of
13 these nodes is defined using the standard binding for regulators found at
16 Each regulator is defined using the standard binding for regulators.
24 regulators {
|
| D | mt6311-regulator.txt | 6 - regulators: List of regulators provided by this controller. It is named
9 for regulators at Documentation/devicetree/bindings/regulator/regulator.txt.
11 The valid names for regulators are:
22 regulators {
|
| D | st,stpmic1-regulator.txt | 1 STMicroelectronics STPMIC1 Voltage regulators
5 Available Regulators in STPMIC1 device are:
21 Switches are fixed voltage regulators with only enable/disable capability.
27 if set, all regulators are switched off in case of over-current detection
36 regulators {
37 compatible = "st,stpmic1-regulators";
|
| D | max77686.txt | 1 Binding for Maxim MAX77686 regulators
7 regulators that can be controlled over I2C.
12 - voltage-regulators : The regulators of max77686 have to be instantiated
13 under subnode named "voltage-regulators" using the following format.
29 Regulators which can be turned off during system suspend:
49 voltage-regulators {
|
| D | slg51000.txt | 7 These entries are required if regulators are enabled for a device.
24 - regulators : This node defines the settings for the regulators.
26 for regulators; see regulator.txt.
28 The SLG51000 regulators are bound using their names listed below:
37 Optional properties for regulators:
45 regulators {
|
| D | qcom,spmi-regulator.txt | 1 Qualcomm SPMI Regulators
7 "qcom,pm8005-regulators"
8 "qcom,pm8841-regulators"
9 "qcom,pm8916-regulators"
10 "qcom,pm8941-regulators"
11 "qcom,pm8994-regulators"
12 "qcom,pmi8994-regulators"
13 "qcom,pms405-regulators"
165 The content of each sub-node is defined by the standard binding for regulators -
173 regulators.
[all …]
|
| D | max77802.txt | 1 Binding for Maxim MAX77802 regulators
7 regulators that can be controlled over I2C.
33 - regulators : The regulators of max77802 have to be instantiated
34 under subnode named "regulators" using the following format.
51 Power Mode. Some regulators support the modes to be changed at startup or by
56 The regulators that support the standard "regulator-initial-mode" property,
66 The standard "regulator-mode" property can only be used for regulators that
67 support changing their mode to Low Power Mode during suspend. These regulators
84 regulators {
|
| D | tps65218.txt | 1 TPS65218 family of regulators
7 - List of regulators provided by this controller, must be named
10 initialization data for defined regulators. Not all regulators for the given
12 using the standard binding for regulators found at ./regulator.txt.
14 The valid names for regulators are:
17 Each regulator is defined using the standard binding for regulators.
|
| D | sprd,sc2731-regulator.txt | 1 Spreadtrum SC2731 Voltage regulators
11 List of regulators provided by this controller. It is named according to
13 of these nodes is defined using the standard binding for regulators at
16 The valid names for regulators are:
25 regulators {
|
| D | tps65132-regulator.txt | 1 TPS65132 regulators
8 Device supports two regulators OUTP and OUTN. A sub node within the
9 device node describe the properties of these regulators. The sub-node
14 -enable-gpios:(active high, output) Regulators are controlled by the input pins.
24 Each regulator is defined using the standard binding for regulators.
|
| D | 88pm800.txt | 6 - regulators: A node that houses a sub-node for each regulator within the
10 regulators; see regulator.txt.
12 The valid names for regulators are:
23 regulators {
|
| D | da9211.txt | 9 - regulators: A node that houses a sub-node for each regulator within the
12 standard binding for regulators; see regulator.txt.
25 regulators {
43 regulators {
69 regulators {
87 regulators {
105 regulators {
131 regulators {
157 regulators {
183 regulators {
|
| D | st,stm32mp1-pwr-reg.txt | 1 STM32MP1 PWR Regulators
4 Available Regulators in STM32MP1 PWR block are:
12 initialization data for defined regulators. The definition for each of
13 these nodes is defined using the standard binding for regulators found at
|
| D | twl-regulator.txt | 1 TWL family of regulators
4 For twl6030 regulators/LDOs
21 For twl6032 regulators/LDOs
35 For twl4030 regulators/LDOs
60 For twl4030 regulators/LDOs:
75 For twl6030 regulators/LDOs:
|
| D | hisilicon,hi655x-regulator.txt | 1 Hisilicon Hi655x Voltage regulators
11 The valid names for regulators are:
20 regulators {
|
| /Documentation/devicetree/bindings/mfd/ |
| D | max77802.txt | 4 efficiency Buck regulators, 32 Low-DropOut (LDO) regulators used to power
7 regulators, clocks outputs and the RTC.
10 regulators are defined in ../clk/maxim,max77802.txt and
|
| D | tps6507x.txt | 6 - regulators: This is the list of child nodes that specify the regulator
7 initialization data for defined regulators. Not all regulators for the
9 is defined using the standard binding for regulators found at
16 These entries are required if regulators are enabled for a device.
28 - defdcdc_default: It's property of DCDC2 and DCDC3 regulators.
43 regulators {
|
| D | lp87565.txt | 11 populated under regulators node. xxx should match
24 regulators: regulators {
57 populated under regulators node. xxx should match
69 regulators: regulators {
|
| D | max8998.txt | 4 regulators, real time clock, battery charging controller and several
11 The PMIC sub-block contains a number of voltage and current regulators,
51 Regulators: All the regulators of MAX8998 to be instantiated shall be
52 listed in a child node named 'regulators'. Each regulator is represented
53 by a child node of the 'regulators' node.
59 Following regulators of the MAX8998 PMIC block are supported. Note that
100 /* Regulators to instantiate */
101 regulators {
|
| D | brcm,bcm59056.txt | 12 Voltage Regulators
16 - regulators: container node for regulators following the generic
31 regulators {
|
| /Documentation/ABI/testing/ |
| D | sysfs-class-regulator | 8 regulators which can report that input value.
34 regulators which can report that output value.
98 measured in microvolts (i.e. E-6 Volts), for regulators
113 setting measured in microamps (i.e. E-6 Amps), for regulators
128 for regulators which can report that control input value.
154 for regulators which support voltage constraints.
169 for regulators which support voltage constraints.
184 microamps, for regulators which support current constraints.
199 microamps, for regulators which support current constraints.
256 the system is suspended to memory, for voltage regulators
[all …]
|
| /Documentation/devicetree/bindings/hwmon/ |
| D | ltc2978.txt | 22 - regulators: A node that houses a sub-node for each regulator controlled by
25 standard binding for regulators; see regulator.txt.
27 Valid names of regulators depend on number of supplies supported per device:
40 regulators {
|
| /Documentation/driver-api/ |
| D | regulator.rst | 18 control voltage and current regulators.
22 both voltage regulators (where voltage output is controllable) and
36 Electronic device that supplies power to other devices. Most regulators
54 An IC which contains numerous regulators and often also other
64 regulators. Functions are provided to `enable <#API-regulator-enable>`__
68 When requesting regulators consumers use symbolic names for their
79 regulators. Consumer devices use the :c:func:`regulator_enable()` and
81 regulators. Calls to the two functions must be balanced.
114 Drivers for regulator chips register the regulators with the regulator
125 This interface provides a way to define how regulators are connected to
|
123456