Searched full:representing (Results 1 – 25 of 217) sorted by relevance
123456789
| /Documentation/devicetree/bindings/power/ |
| D | domain-idle-state.txt | 16 Definition: u32 value representing worst case latency in
24 Definition: u32 value representing worst case latency
30 Definition: u32 value representing minimum residency duration
|
| /Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,smd.txt | 36 - phandle to a syscon node representing the apcs registers
37 - u32 representing offset to the register within the syscon
38 - u32 representing the ipc bit within the register
74 The following example represents a smd node, with one edge representing the
|
| D | qcom,smsm.txt | 20 - phandle to a syscon node representing the apcs registers
21 - u32 representing offset to the register within the syscon
22 - u32 representing the ipc bit within the register
29 matrix representing the local processor
|
| D | qcom,smp2p.txt | 31 - phandle to a syscon node representing the apcs registers
32 - u32 representing offset to the register within the syscon
33 - u32 representing the ipc bit within the register
|
| /Documentation/ABI/testing/ |
| D | sysfs-devices-resource_in_use | 6 for device objects representing ACPI power resources.
8 If present, it contains a number (0 or 1) representing the
|
| D | sysfs-devices-power_resources_D0 | 6 present for device objects representing ACPI device nodes that
10 representing ACPI power resources that need to be turned on for
|
| D | sysfs-devices-power_resources_wakeup | 6 present for device objects representing ACPI device nodes that
10 representing ACPI power resources that need to be turned on for
|
| D | sysfs-devices-power_resources_D1 | 6 present for device objects representing ACPI device nodes that
11 representing ACPI power resources that need to be turned on for
|
| D | sysfs-devices-power_resources_D2 | 6 present for device objects representing ACPI device nodes that
11 representing ACPI power resources that need to be turned on for
|
| D | sysfs-devices-power_resources_D3hot | 6 present for device objects representing ACPI device nodes that
11 representing ACPI power resources that need to be turned on for
|
| D | sysfs-devices-power_state | 6 device objects representing ACPI device nodes that provide power
9 If present, it contains a string representing the current ACPI
|
| D | sysfs-driver-intel-rapid-start | 5 Description: An integer representing a set of wakeup events as follows:
19 Description: An integer representing the length of time the system will
|
| D | sysfs-devices-real_power_state | 6 for device objects representing ACPI device nodes that provide
10 If present, it contains a string representing the real ACPI
|
| D | sysfs-bus-acpi | 8 This file is not present for device objects representing
42 objects representing devices having standard enumeration
67 The return value is a decimal integer representing the device's
|
| D | sysfs-bus-pci-drivers-janz-cmodio | 6 Value representing the HEX switch S2 of the janz carrier board CMOD-IO or CAN-PCI2
|
| /Documentation/devicetree/bindings/crypto/ |
| D | fsl-sec2.txt | 11 - fsl,num-channels : An integer representing the number of channels
13 - fsl,channel-fifo-len : An integer representing the number of
15 - fsl,exec-units-mask : The bitmask representing what execution units
33 - fsl,descriptor-types-mask : The bitmask representing what descriptors
|
| /Documentation/devicetree/bindings/gpio/ |
| D | netxbig-gpio-ext.txt | 6 - addr-gpios: GPIOs representing the address register (LSB -> MSB).
7 - data-gpios: GPIOs representing the data register (LSB -> MSB).
|
| /Documentation/devicetree/bindings/usb/ |
| D | usb-device.txt | 8 representing USB host controllers, "device nodes" representing USB devices,
9 "interface nodes" representing USB interfaces and "combined nodes"
10 representing simple USB devices.
|
| D | ulpi.txt | 6 that node shall have one enabled node underneath it representing the ulpi
|
| /Documentation/devicetree/bindings/spmi/ |
| D | spmi.txt | 5 each representing a unique slave on the bus.
13 An SPMI controller node can contain zero or more child nodes representing slave
|
| /Documentation/driver-api/pm/ |
| D | cpuidle.rst | 91 |struct cpuidle_state| objects representing idle states that the
172 representing it. Going forward this array will represent the list of available
200 Flags representing idle state properties. Currently, governors only use
217 representing the logical CPU running this callback and the
218 |struct cpuidle_driver| object representing the driver itself, respectively,
220 :c:member:`states` array representing the idle state to ask the processor to
231 |struct cpuidle_driver| object representing the driver. Moreover, if any
267 |struct cpuidle_device| objects representing CPUs handled by the given
272 along with all of the |struct cpuidle_device| objects representing CPUs handled
281 all of the |struct cpuidle_device| objects representing CPUs affected by that
|
| /Documentation/devicetree/bindings/interrupt-controller/ |
| D | arm,versatile-fpga-irq.txt | 15 - clear-mask: a u32 number representing the mask written to clear all IRQs
17 - valid-mask: a u32 number representing a bit mask determining which of
|
| /Documentation/power/ |
| D | interface.rst | 51 To select an option, write the string representing it to /sys/power/disk.
55 It can be written a string representing a non-negative integer that will be
79 representing a nonzero integer into it.
|
| /Documentation/devicetree/bindings/iio/temperature/ |
| D | temperature-bindings.txt | 6 thermocouple-type: A single cell representing the type of the thermocouple
|
| /Documentation/devicetree/bindings/mtd/ |
| D | nvidia-tegra20-nand.txt | 22 - reg: An integer ranging from 1 to 6 representing the CS line to use.
31 - nand-ecc-strength: integer representing the number of bits to correct
|
123456789