| /tools/pci/ |
| D | pcitest.c | 52 fprintf(stdout, "BAR%d:\t\t", test->barnum); in run_test()
54 fprintf(stdout, "TEST FAILED\n"); in run_test()
56 fprintf(stdout, "%s\n", result[ret]); in run_test()
61 fprintf(stdout, "SET IRQ TYPE TO %s:\t\t", irq[test->irqtype]); in run_test()
63 fprintf(stdout, "FAILED\n"); in run_test()
65 fprintf(stdout, "%s\n", result[ret]); in run_test()
70 fprintf(stdout, "GET IRQ TYPE:\t\t"); in run_test()
72 fprintf(stdout, "FAILED\n"); in run_test()
74 fprintf(stdout, "%s\n", irq[ret]); in run_test()
79 fprintf(stdout, "LEGACY IRQ:\t"); in run_test()
[all …]
|
| /tools/gpio/ |
| D | gpio-hammer.c | 48 fprintf(stdout, "Hammer lines ["); in hammer_device()
50 fprintf(stdout, "%d", lines[i]); in hammer_device()
52 fprintf(stdout, ", "); in hammer_device()
54 fprintf(stdout, "] on %s, initial states: [", device_name); in hammer_device()
56 fprintf(stdout, "%d", data.values[i]); in hammer_device()
58 fprintf(stdout, ", "); in hammer_device()
60 fprintf(stdout, "]\n"); in hammer_device()
78 fprintf(stdout, "[%c] ", swirr[j]); in hammer_device()
83 fprintf(stdout, "["); in hammer_device()
85 fprintf(stdout, "%d: %d", lines[i], data.values[i]); in hammer_device()
[all …]
|
| D | lsgpio.c | 62 fprintf(stdout, " "); in print_flags()
63 fprintf(stdout, "%s", flagnames[i].name); in print_flags()
95 fprintf(stdout, "GPIO chip: %s, \"%s\", %u GPIO lines\n", in list_device()
111 fprintf(stdout, "\tline %2d:", linfo.line_offset); in list_device()
113 fprintf(stdout, " \"%s\"", linfo.name); in list_device()
115 fprintf(stdout, " unnamed"); in list_device()
117 fprintf(stdout, " \"%s\"", linfo.consumer); in list_device()
119 fprintf(stdout, " unused"); in list_device()
121 fprintf(stdout, " ["); in list_device()
123 fprintf(stdout, "]"); in list_device()
[all …]
|
| D | gpio-event-mon.c | 75 fprintf(stdout, "Monitoring line %d on %s\n", line, device_name); in monitor_device()
76 fprintf(stdout, "Initial line value: %d\n", data.values[0]); in monitor_device()
99 fprintf(stdout, "GPIO EVENT %llu: ", event.timestamp); in monitor_device()
102 fprintf(stdout, "rising edge"); in monitor_device()
105 fprintf(stdout, "falling edge"); in monitor_device()
108 fprintf(stdout, "unknown event"); in monitor_device()
110 fprintf(stdout, "\n"); in monitor_device()
|
| /tools/bpf/bpftool/ |
| D | netlink_dumper.h | 19 fprintf(stdout, "%s {", name); \
28 fprintf(stdout, "{"); \
36 fprintf(stdout, "}"); \
50 fprintf(stdout, "\n"); \
59 fprintf(stdout, fmt_str, name); \
68 fprintf(stdout, "%s", endstr); \
76 fprintf(stdout, fmt_str, val); \
84 fprintf(stdout, fmt_str, str); \
92 fprintf(stdout, "%s ", str); \
|
| /tools/testing/selftests/prctl/ |
| D | disable-tsc-test.c | 47 fflush(stdout); in sigsegv_cb()
54 fflush(stdout); in sigsegv_cb()
69 fflush(stdout); in main()
77 fflush(stdout); in main()
84 fflush(stdout); in main()
90 fflush(stdout); in main()
92 fflush(stdout); in main()
|
| /tools/perf/lib/include/internal/ |
| D | tests.h | 7 #define __T_START fprintf(stdout, "- running %s...", __FILE__)
8 #define __T_OK fprintf(stdout, "OK\n")
9 #define __T_FAIL fprintf(stdout, "FAIL\n")
|
| /tools/testing/selftests/bpf/ |
| D | test_progs.c | 45 if (stdout == env.stdout) in dump_test_log()
48 fflush(stdout); /* exports env.log_buf & env.log_cnt */ in dump_test_log()
53 fprintf(env.stdout, "%s", env.log_buf); in dump_test_log()
55 fprintf(env.stdout, "\n"); in dump_test_log()
59 fseeko(stdout, 0, SEEK_SET); /* rewind */ in dump_test_log()
83 fprintf(env.stdout, "#%d/%d %s:%s\n", in test__end_subtest()
492 env.stdout = stdout; in stdio_hijack()
501 fflush(stdout); in stdio_hijack()
503 stdout = open_memstream(&env.log_buf, &env.log_cnt); in stdio_hijack()
504 if (!stdout) { in stdio_hijack()
[all …]
|
| /tools/perf/scripts/python/ |
| D | compaction-times.py | 192 sys.stdout.write("%d[%s].%d: %s\n" % (self.pid, self.comm, i+1, pelem))
202 sys.stdout.write("%d[%s]: %s\n" % (self.pid, self.comm, self.val))
206 sys.stdout.write("total: %s\n" % chead.str())
249 sys.stdout.write(usage)
250 sys.stdout.write("\n")
251 sys.stdout.write("-h display this help\n")
252 sys.stdout.write("-p display by process\n")
253 sys.stdout.write("-pv display by process (verbose)\n")
254 sys.stdout.write("-t display stall times only\n")
255 sys.stdout.write("-m display stats for migration\n")
[all …]
|
| /tools/perf/util/ |
| D | arm-spe.c | 58 color_fprintf(stdout, color, in arm_spe_dump()
69 color_fprintf(stdout, color, " %08x: ", pos); in arm_spe_dump()
71 color_fprintf(stdout, color, " %02x", buf[i]); in arm_spe_dump()
73 color_fprintf(stdout, color, " "); in arm_spe_dump()
78 color_fprintf(stdout, color, " %s\n", desc); in arm_spe_dump()
80 color_fprintf(stdout, color, " Bad packet!\n"); in arm_spe_dump()
188 fprintf(stdout, arm_spe_info_fmts[ARM_SPE_PMU_TYPE], arr[ARM_SPE_PMU_TYPE]); in arm_spe_print_info()
|
| D | s390-sample-raw.c | 101 color_fprintf(stdout, color, " [%#08zx] Trailer:%c%c%c%c%c" in s390_cpumcfdg_dumptrail()
107 color_fprintf(stdout, color, "\t\t1:%lx 2:%lx 3:%lx TOD-Base:%#llx" in s390_cpumcfdg_dumptrail()
182 color_fprintf(stdout, color, " [%#08zx] Counterset:%d" in s390_cpumcfdg_dump()
187 color_fprintf(stdout, color, in s390_cpumcfdg_dump()
|
| /tools/perf/ |
| D | perf-read-vdso.c | 24 written = fwrite(start, 1, size, stdout); in main()
31 if (fflush(stdout)) in main()
|
| D | builtin-buildid-list.c | 65 if (filename__fprintf_build_id(input_name, stdout) > 0) in perf_session__list_build_ids()
87 perf_session__fprintf_dsos_buildid(session, stdout, dso__skip_buildid, with_hits); in perf_session__list_build_ids()
115 return !(sysfs__fprintf_build_id(stdout) > 0); in cmd_buildid_list()
|
| D | builtin-version.c | 35 color_fprintf(stdout, PERF_COLOR_RED, "%-3s", status); in on_off_print()
37 color_fprintf(stdout, PERF_COLOR_GREEN, "%-3s", status); in on_off_print()
|
| D | builtin-top.c | 333 color_fprintf(stdout, PERF_COLOR_RED, in perf_top__print_sym_table()
349 top->min_percent, stdout, !symbol_conf.use_callchain); in perf_top__print_sym_table()
358 fprintf(stdout, "\n%s: ", msg); in prompt_integer()
401 fprintf(stdout, "\n%s: ", msg); in perf_top__prompt_symbol()
438 fprintf(stdout, "\nMapped keys:\n"); in perf_top__print_mapped_keys()
439 fprintf(stdout, "\t[d] display refresh delay. \t(%d)\n", top->delay_secs); in perf_top__print_mapped_keys()
440 fprintf(stdout, "\t[e] display entries (lines). \t(%d)\n", top->print_entries); in perf_top__print_mapped_keys()
443 …fprintf(stdout, "\t[E] active event counter. \t(%s)\n", perf_evsel__name(top->sym… in perf_top__print_mapped_keys()
445 fprintf(stdout, "\t[f] profile display filter (count). \t(%d)\n", top->count_filter); in perf_top__print_mapped_keys()
447 …fprintf(stdout, "\t[F] annotate display filter (percent). \t(%d%%)\n", top->annotation_opts.mi… in perf_top__print_mapped_keys()
[all …]
|
| D | builtin-report.c | 488 fprintf(stdout, "#\n# Total Lost Samples: %" PRIu64 "\n#\n", in perf_evlist__tty_browse_hists()
500 hists__fprintf_nr_sample_events(hists, rep, evname, stdout); in perf_evlist__tty_browse_hists()
501 hists__fprintf(hists, !quiet, 0, 0, rep->min_percent, stdout, in perf_evlist__tty_browse_hists()
504 fprintf(stdout, "\n\n"); in perf_evlist__tty_browse_hists()
508 fprintf(stdout, "#\n# (%s)\n#\n", help); in perf_evlist__tty_browse_hists()
512 perf_read_values_display(stdout, &rep->show_threads_values, in perf_evlist__tty_browse_hists()
518 branch_type_stat_display(stdout, &rep->brtype_stat); in perf_evlist__tty_browse_hists()
682 perf_session__fprintf_nr_events(session, stdout); in stats_print()
886 return tasks_print(rep, stdout); in __cmd_report()
895 perf_session__fprintf(session, stdout); in __cmd_report()
[all …]
|
| /tools/memory-model/scripts/ |
| D | checkghlitmus.sh | 51 if scripts/runlitmushist.sh < $T/list-C-needed > $T/run.stdout 2> $T/run.stderr
59 sh > $T/judge.stdout 2> $T/judge.stderr
65 grep '!!!' $T/judge.stdout
|
| /tools/testing/selftests/x86/ |
| D | syscall_numbering.c | 23 fflush(stdout); in check_enosys()
77 fflush(stdout); in main()
|
| /tools/testing/selftests/timers/ |
| D | leapcrash.c | 65 setbuf(stdout, NULL); in main()
104 fflush(stdout); in main()
|
| D | set-tz.c | 68 fflush(stdout); in main()
80 fflush(stdout); in main()
|
| D | posix_timers.c | 94 fflush(stdout); in check_itimer()
153 fflush(stdout); in check_timer_create()
|
| /tools/power/cpupower/bench/ |
| D | benchmark.c | 17 if (config->output != stdout) { \
18 fprintf(stdout, "Progress: %02lu %%\r", \
20 fflush(stdout); \
|
| /tools/testing/selftests/tc-testing/plugin-lib/ |
| D | buildebpfPlugin.py | 55 stdout=subprocess.PIPE,
65 proc.stdout.close()
|
| /tools/thermal/tmon/ |
| D | tmon.c | 75 fflush(stdout); in tmon_cleanup()
107 fflush(stdout); in tmon_sig_handler()
111 fflush(stdout); in tmon_sig_handler()
115 fflush(stdout); in tmon_sig_handler()
|
| /tools/testing/selftests/powerpc/tm/ |
| D | tm-resched-dscr.c | 45 fflush(stdout); in test_body()
|