Lines Matching full:drive

15 interface.  If your drive uses one of those proprietary interfaces,
18 attach to the parallel port.  In addition, there is at least one drive
72 3. The CDROM drive should be connected to the host on an IDE
77    where each device can be a hard drive, a CDROM drive, a floppy drive,
78    or a tape drive.  The two devices on an interface are called `master`
79    and `slave`; this is usually selectable via a jumper on the drive.
87    If you want your CDROM drive to be found automatically by the
90    the CDROM drive is the only device on the IDE interface, it should
97 4. Boot the system.  If the drive is recognized, you should see a
100      hdb: NEC CD-ROM DRIVE:260, ATAPI CDROM drive
110    drive is installed.
119 An ISO 9660 CDROM can be mounted by putting the disc in the drive and
149 such as cdda2wav.  The only types of drive which I've heard support
151 use this function on a drive which does not support it.
155 drive should be unmounted before attempting this.  The program takes
157 to change.  If the slot number is -1, the drive is unloaded.
173 a. Drive is not detected during booting.
179    - If your drive is the only device on an IDE interface, it should
187    - If the autoprobing is not finding your drive, you can tell the
189      form `hdX=cdrom`, where X is the drive letter corresponding to
190      where your drive is installed.  Note that if you do this and you
196      the drive; rather, it means that the driver has not detected a
197      drive, but is assuming there's one there anyway because you told
198      it so.  If you actually try to do I/O to a drive defined at a
221   - If you always get timeout errors, interrupts from the drive are
226     means that the system did not see an interrupt from the drive when
229     it was expecting to receive just one from the CDROM drive.
249     the standard Linux ATA disk drive probe. If you own one of these drives,
252     lilo (again where X is the drive letter corresponding to where your drive
278   - Make sure there's a CDROM loaded in the drive, and that's it's an
281   - With the CDROM in the drive and unmounted, try something like::
285     If you see a dump, then the drive and driver are probably working
346    * information about the changer status.  The drive should be unmounted before
448 		printf ("Drive status: ");
460 			printf ("Drive Not Ready.\n");
483 				printf ("CD-ROM drive not ready.\n");