Lines Matching full:phy
7 - phy-mode : See ethernet.txt file in the same directory
10 - phy-supply : regulator that powers the Ethernet PHY.
11 - phy-handle : phandle to the PHY device connected to this device.
13 Use instead of phy-handle.
44 - mdio : specifies the mdio bus in the FEC, used as a container for phy nodes
45 according to phy.txt in the same directory
48 To avoid these, create a phy node according to phy.txt in the same
49 directory, and point the fec's "phy-handle" property to it. Then use
50 the phy's reset binding, again described by phy.txt.
51 - phy-reset-gpios : Should specify the gpio for phy reset
52 - phy-reset-duration : Reset duration in milliseconds. Should present
53 only if property "phy-reset-gpios" is available. Missing the property
56 - phy-reset-active-high : If present then the reset sequence using the GPIO
57 specified in the "phy-reset-gpios" property is reversed (H=reset state,
59 - phy-reset-post-delay : Post reset delay in milliseconds. If present then
60 a delay of phy-reset-post-delay milliseconds will be observed after the
61 phy-reset-gpios has been toggled. Can be omitted thus no delay is
70 phy-mode = "mii";
71 phy-reset-gpios = <&gpio2 14 GPIO_ACTIVE_LOW>; /* GPIO2_14 */
73 phy-supply = <®_fec_supply>;
76 Example with phy specified:
82 phy-mode = "mii";
83 phy-reset-gpios = <&gpio2 14 GPIO_ACTIVE_LOW>; /* GPIO2_14 */
85 phy-supply = <®_fec_supply>;
86 phy-handle = <ðphy>;
89 ethphy: ethernet-phy@6 {
90 compatible = "ethernet-phy-ieee802.3-c22";