Lines Matching +full:0 +full:xf
22 0, then VBST = VP. If greater than 0, the boost voltage will be 3300mV with
31 20ms. If this property is set to 0,1,2,3 then ramp times would be 40ms,
39 ADC data word. This property can be set as a value of 0 for bits 15 down
40 to 0, 6 for 21 down to 6, 7, for 22 down to 7, 8 for 23 down to 8.
54 LRCLK cycles. If this property is set to 0, 1, 2, or 3 then the memory
64 0xF).
72 from 0 to 7 for delays of 5ms, 10ms, 50ms, 100ms, 200ms, 500ms, 1000ms.
80 The reference voltage starts at 3000mV with a value of 0x3 and is increased
85 tracking. This property can be set to values from 0 to 3 with rates of 128
90 using VPMON. This property can be set to values from 0 to 6 starting at
98 reg = <0x40>;
106 reset-gpios = <&cs47l91 34 0>;
108 cirrus,ramp-rate = <0x0>;
109 cirrus,boost-ctl = <0x30>; /* VBST = 8000mV */
110 cirrus,boost-ipk = <0xE0>; /* 3600mA */
111 cirrus,imon-adc-scale = <0> /* Bits 15 down to 0 */
114 cirrus,mem-depth = <0x3>;
115 cirrus,release-rate = <0x3>;
116 cirrus,ldo-thld = <0x1>;
117 cirrus,ldo-path-disable = <0x0>;
118 cirrus,ldo-entry-delay=<0x4>;
120 cirrus,vp-hg=<0xF>;
121 cirrus,vp-hg-rate=<0x2>;
122 cirrus,vp-hg-va=<0x0>;