Lines Matching +full:0 +full:x2e

10     Addresses scanned: I2C 0x2c-0x2e
18     Addresses scanned: I2C 0x2c-0x2e
33   Set to non-zero to force some initializations (default is 0).
35   A "0" allows SMBus block data transactions if the host supports them.  A "1"
36   disables SMBus block data transactions.  The default is 0.
38   Configures in7 and in8 limit type, where 0 means absolute and non-zero
44   is "0,0".
46   A "0" configures the VID pins for V(ih) = 2.1V min, V(il) = 0.8V max.
50   inputs are not working, try changing this.  The default value is "0".
90 from 0-255 where 0 indicates no throttling, and 255 indicates > 99.6%.
116 the override function is enabled.  This value ranges from 0 to 15, with 0
124 which 1 indicates #VRD_HOT is asserted and 0 indicates it is negated. These
147 where 0 disables and 1 enables the manual control mode.  The sysfs files pwm1
148 and pwm2 are used to set the manual duty cycle; each is an integer (0-255)
149 where 0 is 0% duty cycle, and 255 is 100%.  Note that the duty cycle values
178 a "0" disables it. The h/w default is 0x0f (all temperatures bound).
181 	0x01   Temp 1
182 	0x02   Temp 2
183 	0x04   Temp 3
184 	0x08   Temp 4
185 	0x10   #PROCHOT 1
186 	0x20   #PROCHOT 2
187 	0x40   #VRDHOT 1
188 	0x80   #VRDHOT 2
202 	 1		0		-		 25.00%
203 	 2		0		-		 28.57%
217 Valid offsets are in the range 0C <= x <= 7.5C in 0.5C increments.
238 A spin-up cycle occurs when a PWM output is commanded from 0% duty cycle to
239 some value > 0%.  The LM93 supports a minimum duty cycle during spin-up.  These
249 	0 (disabled, h/w default), 0.1, 0.25, 0.4, 0.7, 1.0, 2.0, 4.0
262 	0 (disabled, h/w default) to 0.75 in 0.05 second intervals
298 vrdhot<n>		    0 means negated, 1 means asserted