Lines Matching full:temperature
44 The driver implements three temperature sensors, seven fan rotation speed
60 the temperature gets higher than the Overtemperature Shutdown value; it stays
61 on until the temperature falls below the Hysteresis value.
104 Tart will be asserted while target temperature cannot be achieved after 3 minutes
144 range. At first a wanted temperature and interval must be set. This is done
146 interval. The fan speed will be lowered as long as the current temperature
147 remains below the thermal_cruise# +- tolerance# value. Once the temperature
150 with the temperature varying. Three conditions may occur:
152 (1) If the temperature still exceeds the high limit, PWM duty
155 (2) If the temperature goes below the high limit, but still above the low
157 the temperature is in the target range.
159 (3) If the temperature goes below the low limit, PWM duty cycle will decrease
160 slowly to 0 or a preset stop value until the temperature exceeds the low
166 W83792D also provides a special mode for fan. Four temperature points are
167 available. When related temperature sensors detects the temperature in preset
168 temperature region (sf2_point@_fan# +- tolerance#) it will cause fans to run
181 - this file controls mode of fan/temperature control:
193 - Selects the desired temperature for cruise (degC)
197 - four temperature points for each fan for Smart Fan II