Lines Matching full:test

46 	    5.2.1 Diagnostic Self-Test
47 	    5.2.2 Diagnostic Network Test
383 the CS8900/20 Setup Utility can be used to test the functionality of the
384 adapter and its network connection.  Use the diagnostics 'Self Test' option to
385 test the functionality of the adapter with the hardware configuration you have
386 assigned. You can use the diagnostics 'Network Test' to test the ability of the
406        * Select 'Self-Test' to test the adapter's basic functionality.
407        * Select 'Network Test' to test the network connection and cabling.
410 5.2.1. Diagnostic Self-test
413 The diagnostic self-test checks the adapter's basic functionality as well as
417    * IO Register Read/Write Test
419      The IO Register Read/Write test insures that the CS8900/20 can be
422    * Shared Memory Test
424      The Shared Memory test insures the CS8900/20 can be accessed in memory
428    * Interrupt Test
430      The Interrupt test insures there are no conflicts with the assigned IRQ
433    * EEPROM Test
435      The EEPROM test insures the EEPROM can be read.
437    * Chip RAM Test
439      The Chip RAM test insures the 4K of memory internal to the CS8900/20 is
442    * Internal Loop-back Test
444      The Internal Loop Back test insures the adapter's transmitter and
445      receiver are operating properly.  If this test fails, make sure the
449    * Boot PROM Test
451      The Boot PROM  test insures the Boot PROM is present, and can be read.
454      assignment. (Test only applies if the adapter is configured to use the
457 Failure of a test item indicates a possible system resource conflict with
463 5.2.2. Diagnostic Network Test
466 The Diagnostic Network Test verifies a working network connection by
468 on the same network. (Note: the diagnostic network test should not be run
471 This test requires that each of the two PCs have a CS8900/20-based adapter
479 transmitted OK or in error.  The test can be terminated anytime by the user at
482 To setup the Diagnostic Network Test:
486 	and select 'Diagnostics -> Network Test -> Responder' from the main
489     2.  Return to the PC with the CS8900/20-based adapter you want to test and
492     3.  From the main menu, Select 'Diagnostic -> Network Test -> Initiator'.
493 	Hit ENTER to start the test.
495 You may stop the test on the Initiator at any time while allowing the Responder
496 to continue running.  In this manner, you can move to additional PCs and test
535 diagnostic self-test.  Normally, the ISA resource in conflict will fail the
536 self-test.  If so, reconfigure the adapter selecting another choice for the
543 diagnostics self-test to ensure the new configuration is free of conflicts