Lines Matching full:when

13   appears only when the surround channels are available.
23   When there are only either headphones or line-out jacks, it gives
24   "Disabled" and "Enabled" state.  When enabled, the speaker is muted
25   automatically when a jack is plugged.
27   When both headphone and line-out jacks are present, it gives
28   "Disabled", "Speaker Only" and "Line-Out+Speaker".  When
30   mutes the speakers, but not line-outs.  When line-out+speaker is
40   appears only when "loopback" is set to true in a codec hint
42   and the normal PCM playback are exclusive, i.e. when this is on, you
47   corresponds to the center and the right to the LFE.  When this is
51   When this control is ON, treat the headphone jacks as line-out
59   when the pin is a multi-I/O jack for surround channels.
67   When it's ON, the corresponding input jacks (usually a line-in and a
71   When this enum control is enabled, the headphone output is routed
79   enabled or not.  When it's enabled, the analog-loopback is mixed to
81   and speaker outputs.  As a side-effect, when this mode is set, the
88   detection is enabled or not.  When enabled, the widgets power state
96   unsolicited event per jack plug.  When this is on, the driver polls
113   appears only when the surround channels are available.
119   When this enum control is enabled, the headphone output is routed