Lines Matching full:slave

5 The 1-wire bus is a simple master-slave bus that communicates via a single
14 All w1 slave devices must be connected to a w1 bus master device.
30  - the w1 bus is periodically searched for new slave devices
33 and check if it is loaded. If so, the family driver is attached to the slave.
45 and slave device will be even removed, but in this case 0xff will
52 Slave devices are handled by a driver written for a family of w1 devices.
93 w1_master_add             (rw) manually register a slave device
98 w1_master_remove          (rw) manually remove a slave device
110 set to zero, then manually add the slave device serial numbers by
122 w1 slave sysfs interface
131 rw		    (optional) created for slave devices which do not have