Home
last modified time | relevance | path

Searched +full:3 +full:rd (Results 1 – 25 of 58) sorted by relevance

123

/Documentation/devicetree/bindings/mips/cavium/
Dbootbus.txt40 - cavium,t-rd-hld: A cell specifying the RD_HLD timing (in nS).
50 - cavium,t-rd-dly: A cell specifying the RD_DLY timing (in nS).
53 = 2 bytes, 2 = 4 bytes, 3 = 8 bytes).
79 <3 0 0x10000 0x50000000 0>,
92 cavium,t-rd-hld = <35>;
97 cavium,t-rd-dly = <0>;
112 cavium,t-rd-hld = <100>;
117 cavium,t-rd-dly = <0>;
/Documentation/devicetree/bindings/dma/
Dapm-xgene-dma.txt13 3rd - Descriptor ring command register address space.
16 DMA error reporting interrupt. 2nd, 3rd, 4th and 5th interrupts
Dlpc1850-dmamux.txt6 - #dma-cells: Should be set to <3>.
8 * 2nd cell contain the mux value (0-3) for the peripheral
9 * 3rd cell contain either 1 or 2 depending on the AHB
39 #dma-cells = <3>;
Dfsl-edma.txt17 The 2nd and the 3rd regions are programmable channel multiplexing
74 <GIC_SPI 3 IRQ_TYPE_LEVEL_HIGH>,
/Documentation/admin-guide/
Ddevices.txt8 3 = /dev/null Null device
53 3 = /dev/fd3 Controller 0, drive 3, autodetect
57 131 = /dev/fd7 Controller 1, drive 3, autodetect
82 44 = /dev/fd?u1680 3.5" 1680K High Density(3)
86 116 = /dev/fd?u1840 3.5" 1840K High Density(3)
97 (3) Autodetectable format in a High Density (1440K) drive only
106 3 char Pseudo-TTY slaves
115 3 block First MFM, RLL and IDE hard disk/CD-ROM interface
124 63 = /dev/hd?63 63rd partition
136 63 = /dev/tty63 63rd virtual console
[all …]
/Documentation/devicetree/bindings/media/
Dimg-ir-rev1.txt15 Up to 3 clocks may be specified in the following order:
18 3rd: Power modulation clock.
/Documentation/admin-guide/media/
Dtechnisat.rst37 (except ``Simple tuner support`` for ATSC 3rd generation only -> see case 9 please).
96 - AirStar ATSC card 3rd generation:
/Documentation/devicetree/bindings/net/
Dcalxeda-xgmac.yaml28 Can point to at most 3 xgmac interrupts. The 1st one is the main
30 3rd one is the low power state interrupt.
32 maxItems: 3
Dhisilicon-femac.txt22 The 3rd cell is reset post-delay in micro seconds.
35 resets = <&crg 0xec 0>,<&crg 0xec 3>;
Dhisilicon-hix5hd2-gmac.txt31 The 3rd cell is reset post-delay in micro seconds.
/Documentation/networking/
Dregulatory.rst167 .n_reg_rules = 3,
185 struct ieee80211_regdomain *rd;
193 rd = kzalloc(size_of_regd, GFP_KERNEL);
194 if (!rd)
197 memcpy(rd, &mydriver_jp_regdom, sizeof(struct ieee80211_regdomain));
200 memcpy(&rd->reg_rules[i],
203 regulatory_struct_hint(rd);
Dpacket_mmap.rst11 socket interface on 2.4/2.6/3.x kernels. This type of sockets is used for
28 In Linux 2.4/2.6/3.x if PACKET_MMAP is not enabled, the capture process is very
236 | frame 1 | frame 2 | | frame 3 | frame 4 |
239 block #3 block #4
300 | v block #3
444 #define TP_STATUS_CSUMNOTREADY (1 << 3)
575 3. Set protocol version to 2, set up ring as usual
584 3. Added poll timeout to avoid indefinite user-space wait
716 if (argc != 3) {
813 struct iovec *rd;
[all …]
/Documentation/userspace-api/media/v4l/
Dfourcc.rst30 3rd character: uncompressed bits-per-pixel 0--9, A--
/Documentation/devicetree/bindings/memory-controllers/
Domap-gpmc.txt42 3 - GPMC_WAIT1 pin edge, and so on.
59 - gpmc,cs-rd-off-ns: Read deassertion time
64 - gpmc,adv-rd-off-ns: Read deassertion time
67 - gpmc,adv-aad-mux-rd-off-ns: Read deassertion time for AAD
84 - gpmc,rd-cycle-ns: Total read cycle time
/Documentation/ia64/
Derr_inject.rst111 #define ERR_DATA_BUFFER_SIZE 3 // Three 8-byte.
152 u64 mode : 3, /* 0-2 */
153 err_inj : 3, /* 3-5 */
156 struct_hier : 3, /* 13-15 */
166 cl_p : 3, /* 3-5 */
167 cl_id : 3, /* 6-8 */
172 trigger_pl : 3, /* 37-39 */
178 tc_tr : 2, /* 3-4 */
183 trigger_pl : 3, /* 37-39 */
193 trigger_pl : 3, /* 37-39 */
[all …]
/Documentation/devicetree/bindings/mtd/
Dgpmc-nand.txt85 gpmc,cs-rd-off-ns = <44>;
88 gpmc,adv-rd-off-ns = <34>;
93 gpmc,rd-cycle-ns = <82>;
131 '3' for HAM1_xx ecc schemes
/Documentation/hwmon/
Dabituguru3.rst5 * Abit uGuru revision 3 (Hardware Monitor part, reading only)
29 motherboards use the abituguru (without the 3 !) driver.
59 The 3rd revision of the uGuru chip in reality is a Winbond W83L951G.
63 Despite Abit not releasing any information regarding the uGuru revision 3,
/Documentation/usb/
Dmisc_usbsevseg.rst39 3. Set the textmode:
50 For example, to set the 0th and 3rd decimal place
/Documentation/devicetree/bindings/phy/
Dapm-xgene-phy.txt11 1 (SGMII), 2 (PCIe), 3 (USB), and 4 (XFI).
19 Two set of 3-tuple setting for each (up to 3)
25 Two set of 3-tuple setting for each (up to 3)
27 - apm,tx-boost-gain : Frequency boost AC (LSB 3-bit) and DC (2-bit)
28 gain control. Two set of 3-tuple setting for each
29 (up to 3) supported link speed on the host. Range is
30 between 0 to 31 in unit of dB. Default is 3.
31 - apm,tx-amplitude : Amplitude control. Two set of 3-tuple setting for
32 each (up to 3) supported link speed on the host.
36 3-tuple setting for each (up to 3) supported link
[all …]
/Documentation/devicetree/bindings/interrupt-controller/
Dmarvell,icu.txt87 - #interrupt-cells: The value was 3.
95 The 3rd cell was the type of the interrupt. See arm,gic.txt for
104 #interrupt-cells = <3>;
/Documentation/devicetree/bindings/remoteproc/
Dst,stm32-rproc.yaml25 maxItems: 3
72 maxItems: 3
80 maxItems: 3
96 3rd cell: register bitmask for the deep sleep bit
/Documentation/driver-api/soundwire/
Dsummary.rst20 (3) Clock scaling and optional multiple data lanes to give wide flexibility
64 3rd-party vendors to enable implementation-defined functionality while
88 prefix commonly used by SoC designers and 3rd party vendors.
/Documentation/virt/kvm/
Dppc-pv.rst46 r5 3rd parameter 2nd output value
47 r6 4th parameter 3rd output value
157 mfsprg rX, 3 ld rX, magic_page->sprg3
167 mtsprg 3, rX std rX, magic_page->sprg3
194 3) patch that code to return to the original pc + 4
217 3) OSI hypercalls
/Documentation/process/
D8.Conclusion.rst34 Linux Device Drivers, 3rd Edition (Jonathan Corbet, Alessandro
/Documentation/translations/it_IT/process/
D8.Conclusion.rst41 Linux Device Drivers, 3rd Edition (Jonathan Corbet, Alessandro

123