Searched full:55 (Results 1 – 25 of 139) sorted by relevance
123456
| /Documentation/devicetree/bindings/pinctrl/ |
| D | marvell,dove-pinctrl.txt | 81 - i2s1/spdifo : audio1 i2s on pins 52-55 and spdifo on 57, no gpios
82 - i2s1 : audio1 i2s on pins 52-55, gpio on pins 56,57
83 - spdifo : spdifo on pin 57, gpio on pins 52-55
84 - twsi : twsi on pins 56,57, gpio on pins 52-55
85 - ssp/spdifo : ssp on pins 52-55, spdifo on pin 57, no gpios
86 - ssp : ssp on pins 52-55, gpio on pins 56,57
87 - ssp/twsi : ssp on pins 52-55, twsi on pins 56,57, no gpios
|
| D | pinctrl-mt7622.txt | 145 PIN 55: "MDI_TP_P1"
208 "esw" "eth" 51, 52, 53, 54, 55, 56,
212 "esw_p0_p1" "eth" 51, 52, 53, 54, 55, 56,
224 "i2c1_0" "i2c" 55, 56
304 "tdm_1_out_data" "tdm" 55
307 "uart1_0_tx_rx" "uart" 55, 56
388 PIN 55: "GPIO_2"
435 "pcie_wake" "pcie" 55
447 "uart1_1_cts_rts" "uart" 55, 56
|
| D | pinctrl-mt65xx.txt | 116 bias-pull-up = <55>;
136 bias-pull-up = <55>;
143 bias-pull-up = <55>;
|
| /Documentation/devicetree/bindings/media/spi/ |
| D | sony-cxd2880.txt | 6 - spi-max-frequency: Maximum bus speed, should be set to <55000000> (55MHz).
17 spi-max-frequency = <55000000>; /* 55MHz */
|
| /Documentation/core-api/ |
| D | packing.rst | 55 63 62 61 60 59 58 57 56 55 54 53 52 51 50 49 48 47 46 45 44 43 42 41 40 39 38 37 36 35 34 33 32
71 56 57 58 59 60 61 62 63 48 49 50 51 52 53 54 55 40 41 42 43 44 45 46 47 32 33 34 35 36 37 38 39
84 39 38 37 36 35 34 33 32 47 46 45 44 43 42 41 40 55 54 53 52 51 50 49 48 63 62 61 60 59 58 57 56
98 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63
110 63 62 61 60 59 58 57 56 55 54 53 52 51 50 49 48 47 46 45 44 43 42 41 40 39 38 37 36 35 34 33 32
125 56 57 58 59 60 61 62 63 48 49 50 51 52 53 54 55 40 41 42 43 44 45 46 47 32 33 34 35 36 37 38 39
136 39 38 37 36 35 34 33 32 47 46 45 44 43 42 41 40 55 54 53 52 51 50 49 48 63 62 61 60 59 58 57 56
147 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63
|
| /Documentation/devicetree/bindings/phy/ |
| D | mxs-usb-phy.txt | 17 - fsl,tx-cal-45-dn-ohms: Integer [30-55]. Resistance (in ohms) of switchable
20 - fsl,tx-cal-45-dp-ohms: Integer [30-55]. Resistance (in ohms) of switchable
|
| /Documentation/devicetree/bindings/net/can/ |
| D | c_can.txt | 45 interrupts = <55>;
56 interrupts = <55>;
|
| /Documentation/devicetree/bindings/net/ |
| D | ezchip_enet.txt | 14 mac-address = [ 00 11 22 33 44 55 ];
|
| D | allwinner,sun4i-a10-emac.yaml | 48 interrupts = <55>;
|
| /Documentation/devicetree/bindings/timer/ |
| D | digicolor-timer.txt | 16 interrupts = <19>, <31>, <34>, <35>, <52>, <53>, <54>, <55>;
|
| /Documentation/devicetree/bindings/input/touchscreen/ |
| D | sitronix-st1232.txt | 20 touchscreen@55 {
|
| /Documentation/devicetree/bindings/iio/dac/ |
| D | vf610-dac.txt | 17 interrupts = <55 IRQ_TYPE_LEVEL_HIGH>;
|
| /Documentation/devicetree/bindings/clock/ |
| D | silabs,si514.txt | 20 si514: clock-generator@55 {
|
| D | silabs,si544.txt | 21 si544: clock-controller@55 {
|
| /Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,wcnss.txt | 100 /* BD address 00:11:22:33:44:55 */
101 local-bd-address = [ 55 44 33 22 11 00 ];
|
| /Documentation/devicetree/bindings/pci/ |
| D | tango-pcie.txt | 28 <55 IRQ_TYPE_LEVEL_HIGH>; /* MSI */
|
| /Documentation/devicetree/bindings/mmc/ |
| D | marvell,xenon-sdhci.txt | 82 Only available when bus frequency lower than 55MHz in SDR mode.
128 interrupts = <GIC_SPI 55 IRQ_TYPE_LEVEL_HIGH>
164 interrupts = <GIC_SPI 55 IRQ_TYPE_LEVEL_HIGH>
|
| /Documentation/hwmon/ |
| D | tmp102.rst | 25 operating temperature has a minimum of -55 C and a maximum of +150 C.
|
| D | ds620.rst | 24 into non-volatile on-chip registers). Temperature range is -55 degree Celsius
|
| D | tmp108.rst | 28 operating temperature has a minimum of -55 C and a maximum of +150 C.
|
| /Documentation/devicetree/bindings/watchdog/ |
| D | alphascale-asm9260.txt | 30 interrupts = <55>;
|
| D | fsl-imx7ulp-wdt.yaml | 53 interrupts = <GIC_SPI 55 IRQ_TYPE_LEVEL_HIGH>;
|
| /Documentation/ABI/testing/ |
| D | sysfs-class-power-wilco | 40 percentages. The valid range is [55, 100].
|
| /Documentation/devicetree/bindings/gpio/ |
| D | nvidia,tegra20-gpio.txt | 33 0 55 0x04
|
| /Documentation/devicetree/bindings/crypto/ |
| D | inside-secure-safexcel.txt | 33 <GIC_SPI 55 IRQ_TYPE_LEVEL_HIGH>,
|
123456