Searched full:ioport (Results 1 – 9 of 9) sorted by relevance
/Documentation/driver-api/media/drivers/ |
D | radiotrack.rst | 53 CONTROLLING THE CARD WITH IOPORT 56 The RadioTrack (base) ioport is configurable for 0x30c or 0x20c. Only one 57 ioport seems to be involved. The ioport decoding circuitry must be pretty 58 simple, as individual ioport bits are directly matched to specific functions 60 parallel with one write to the ioport. The only feedback available through 63 The bits of the ioport are arranged as follows: 91 Results available by reading ioport >60 msec after last port write. 151 x <-- BASE (read ioport)
|
/Documentation/scsi/ |
D | aha152x.rst | 26 IOPORT base io address (0x340/0x140) 48 - DSETUP0="{ IOPORT, IRQ, SCSI_ID, RECONNECT, PARITY, SYNCHRONOUS, DELAY, EXT_TRANS }" 51 - DSETUP1="{ IOPORT, IRQ, SCSI_ID, RECONNECT, PARITY, SYNCHRONOUS, DELAY, EXT_TRANS }" 66 …aha152x=<IOPORT>[,<IRQ>[,<SCSI-ID>[,<RECONNECT>[,<PARITY>[,<SYNCHRONOUS>[,<DELAY> [,<EXT_TRANS]]]]… 82 aha152x=IOPORT,IRQ,SCSI_ID,RECONNECT,PARITY,SYNCHRONOUS,DELAY,EXT_TRANS 88 aha152x1=IOPORT,IRQ,SCSI_ID,RECONNECT,PARITY,SYNCHRONOUS,DELAY,EXT_TRANS 95 IOPORT for first and second controller
|
/Documentation/pcmcia/ |
D | driver-changes.rst | 17 - CONF_AUTO_SET_IO : set ioport resources (->resource[0,1]) 28 `struct pcmcia_device *p_dev->resource[2,3,4,5]` for up to four ioport 35 `struct pcmcia_device *p_dev->resource[0,1]` for up to two ioport
|
/Documentation/devicetree/bindings/pinctrl/ |
D | st,stm32-pinctrl.yaml | 98 st,bank-ioport: 100 Should correspond to the EXTI IOport selection (EXTI line used
|
/Documentation/i2c/busses/ |
D | i2c-piix4.rst | 66 option is 'force_addr=<IOPORT>'. This will not only enable the PIIX4 like
|
/Documentation/devicetree/bindings/pci/ |
D | host-generic-pci.yaml | 22 accessed via an ioport) and laid out with a direct correspondence to the
|
/Documentation/input/ |
D | gameport-programming.rst | 31 gameport. Although only one ioport is really used, the gameport usually
|
/Documentation/driver-api/ |
D | uio-howto.rst | 185 Since these ioport regions can not be mapped, they will not appear under
|
/Documentation/admin-guide/ |
D | kernel-parameters.txt | 4059 Override pmtimer IOPort with a hex value.
|