Searched full:receiver (Results 1 – 25 of 147) sorted by relevance
123456
| /Documentation/admin-guide/media/ |
| D | siano-cardlist.rst | 29 * - ONDA Data Card Digital Receiver
31 * - Siano Denver (ATSC-M/H) Digital Receiver
33 * - Siano Denver (TDMB) Digital Receiver
35 * - Siano Ming Digital Receiver
37 * - Siano Nice Digital Receiver
39 * - Siano Nova A Digital Receiver
41 * - Siano Nova B Digital Receiver
43 * - Siano Pele Digital Receiver
45 * - Siano Rio Digital Receiver
47 * - Siano Stellar Digital Receiver
[all …]
|
| D | dvb-usb-gp8psk-cardlist.rst | 15 * - Genpix 8PSK-to-USB2 Rev.1 DVB-S receiver
17 * - Genpix 8PSK-to-USB2 Rev.2 DVB-S receiver
19 * - Genpix SkyWalker-1 DVB-S receiver
21 * - Genpix SkyWalker-2 DVB-S receiver
|
| D | dvb-usb-dtt200u-cardlist.rst | 15 * - WideView WT-220U PenType Receiver (Miglia)
17 * - WideView WT-220U PenType Receiver (Typhoon/Freecom)
19 * - WideView WT-220U PenType Receiver (based on ZL353)
|
| D | si470x.rst | 30 - Si4700: FM radio receiver
31 - Si4701: FM radio receiver, RDS Support
32 - Si4702: FM radio receiver
33 - Si4703: FM radio receiver, RDS Support
34 - Si4704: FM radio receiver, no external antenna required
35 - Si4705: FM radio receiver, no external antenna required, RDS support, Dig I/O
36 - Si4706: Enhanced FM RDS/TMC radio receiver, no external antenna required, RDS
38 - Si4707: Dedicated weather band radio receiver with SAME decoder, RDS Support
53 - 06e1:a155: ADS/Tech FM Radio Receiver (formerly Instant FM Music) (RDX-155-EF)
|
| D | radio-cardlist.rst | 23 radio-shark Griffin radioSHARK USB radio receiver
24 shark2 Griffin radioSHARK2 USB radio receiver
25 radio-si470x-common Silicon Labs Si470x FM Radio Receiver
42 radio-si470x-usb Silicon Labs Si470x FM Radio Receiver support with USB
|
| D | dvb-usb-vp7045-cardlist.rst | 15 * - DigitalNow TinyUSB 2 DVB-t Receiver
17 * - Twinhan USB2.0 DVB-T receiver (TwinhanDTV Alpha/MagicBox II)
|
| /Documentation/userspace-api/media/rc/ |
| D | lirc-set-wideband-receiver.rst | 13 LIRC_SET_WIDEBAND_RECEIVER - enable wide band receiver.
29 enable = 1 means enable wideband receiver, enable = 0 means disable
30 wideband receiver.
35 Some receivers are equipped with special wide band receiver which is
39 This might be useful of receivers that have otherwise narrow band receiver
40 that prevents them to be used with some remotes. Wide band receiver might
46 Wide band receiver might be implictly enabled if you enable
48 carrier reports. Trying to disable wide band receiver while carrier
|
| /Documentation/devicetree/bindings/media/ |
| D | gpio-ir-receiver.txt | 1 Device-Tree bindings for GPIO IR receiver
4 - compatible: should be "gpio-ir-receiver".
15 ir: ir-receiver {
16 compatible = "gpio-ir-receiver";
|
| D | meson-ir.txt | 1 * Amlogic Meson IR remote control receiver
16 ir-receiver@c8100480 {
|
| /Documentation/driver-api/media/ |
| D | csi2.rst | 23 provide the CSI-2 receiver with information on the CSI-2 bus
30 The V4L2_CID_LINK_FREQ control is used to tell the receiver driver the
32 V4L2_CID_PIXEL_RATE is may be used by the receiver to obtain the pixel
74 effectively leaving the current frame unfinished. The receiver driver
78 Receiver drivers
81 Before the receiver driver may enable the CSI-2 transmitter by using
|
| /Documentation/devicetree/bindings/gnss/ |
| D | gnss.txt | 1 GNSS Receiver DT binding
3 This documents the binding structure and common properties for GNSS receiver
6 A GNSS receiver node is a node named "gnss" and typically resides on a serial
|
| D | mediatek.txt | 1 Mediatek-based GNSS Receiver DT binding
3 Mediatek chipsets are used in GNSS-receiver modules produced by several
|
| D | sirfstar.txt | 1 SiRFstar-based GNSS Receiver DT binding
3 SiRFstar chipsets are used in GNSS-receiver modules produced by several
|
| /Documentation/devicetree/bindings/sound/ |
| D | spdif-receiver.txt | 1 Device-Tree bindings for dummy spdif receiver
8 codec: spdif-receiver {
|
| D | fsl-sai.txt | 41 receiver will send and receive data by following
42 receiver's bit clocks and frame sync clocks.
46 means both transmitter and receiver will send and
63 transmitter and receiver will send and receive data by following clocks
|
| D | xlnx,i2s.txt | 7 "xlnx,i2s-receiver-1.0" for capture
18 compatible = "xlnx,i2s-receiver-1.0";
|
| /Documentation/driver-api/md/ |
| D | md-cluster.rst | 153 sender receiver receiver
159 sender receiver receiver
179 receiver get CR on "message"
180 receiver read LVB
181 receiver processes the message
183 receiver releases "ack"
184 receiver tries to get PR on "message"
186 sender receiver receiver
202 receiver upconvert to PR on "message"
203 receiver get CR of "ack"
[all …]
|
| /Documentation/userspace-api/media/cec/ |
| D | cec-pin-error-inj.rst | 199 as soon as the receiver NACKs a byte the transmit will stop, but the
205 This setting can be used to test how well a receiver deals with
211 without ever sending an EOM. This can be used to test how a receiver
218 and not for the final byte. The receiver should ignore the last byte in
220 same reason the whole message is typically ignored. The receiver should be
230 This command can be used to test buffer overflows in the receiver. E.g.
236 two bytes long. The receiver should ignore messages that are too short.
245 than is allowed and the receiver should respond with a Low Drive
249 because the receiver also looks for an Arbitration Lost condition in
262 a receiver will do. It might just accept it, or it might time out and
[all …]
|
| /Documentation/ABI/testing/ |
| D | sysfs-class-gnss | 6 The GNSS receiver type. The currently identified types reflect
7 the protocol(s) supported by the receiver:
|
| /Documentation/infiniband/ |
| D | tag_matching.rst | 10 * User tag - wild card may be specified by the receiver
11 * Source rank – wild car may be specified by the receiver
21 When a message is sent from the sender to the receiver, the communication
36 and perhaps a portion of data when first notifying the receiver. When the
|
| /Documentation/devicetree/bindings/hsi/ |
| D | client-devices.txt | 9 - hsi-rx-mode: Receiver Bit transmission mode ("stream" or "frame")
12 the transmission mode is the same for receiver and
|
| /Documentation/devicetree/bindings/media/i2c/ |
| D | ov7740.txt | 8 be used to specify link to the image data receiver. The OV7740 device
24 - remote-endpoint: A phandle to the bus receiver's endpoint node.
|
| /Documentation/userspace-api/media/v4l/ |
| D | ext-ctrls-dv.rst | 14 the receiver or transmitter subdevice that implements them, so they are
53 transmitter can sense that the receiver is ready to receive video).
60 When the transmitter sees the hotplug signal from the receiver it
126 Detects whether the receiver receives power from the source (e.g.
130 corresponds to an input pad on the receiver. If an input pad
|
| D | ext-ctrls-fm-rx.rst | 6 FM Receiver Control Reference
9 The FM Receiver (FM_RX) class includes controls for common features of
32 static display on a receiver. It is the primary aid to listeners in
|
| /Documentation/networking/ |
| D | ipsec.rst | 13 policy check on receiver.
46 will skip policy checking on receiver side.
|
123456