Searched full:choosing (Results 1 – 25 of 29) sorted by relevance
12
64 Choosing a higher number gives better performance but85 Choosing a higher number gives better performance but
32 (Note: Choosing the 56channel mode for transmission or as40 Note: Choosing the 56-channel mode for49 Choosing the 56-channel mode for225 Choosing the Input, optical or coaxial. If Safe-mode is active,
377 - for instance choosing 0x05 (16bits 96kHz) will fail back to 0x09 since 382 - choosing b2 will prepare all interfaces for 24bits/96kHz but you'll
42 - Boot to EFI shell and invoke elilo choosing the kernel image built
17 - mode-gpios: phandle of the gpio for choosing the mode of the display
43 control the antenna subsystem, selecting the polarization and choosing
26 specific callbacks. The specific SoC version is selected by choosing
29 | The driver can be enabled by choosing CONFIG_MLX5_CORE=y/m in kernel config.35 | Choosing this option will allow basic ethernet netdevice support with all of the standard rx/t…
38 choosing. Expressive, dynamic filters provide further options down this339 They might work. For example, on some kernels, choosing a syscall
146 choosing drivers to probe(). The thread doing new device processing checks
108 Driver contains SVGALib compatibility code. It is turned on by choosing textual409 to think twice before choosing videomode (for example twice 1880x1440x32bpp430 to think twice before choosing videomode.
152 Choosing between 1. and 2. is a matter of trading off flexibility and
90 performance but that shouldn't matter since you are choosing this mode over plain-L3
28 For a brief introduction to CCIDs and suggestions for choosing a CCID to match
187 Remember the MBus controller allows a great deal of flexibility for choosing
36 unexpectedly between polls. Choosing the right polling delays shall avoid
223 R'G'B' to limited range Y'CbCr. So choosing full range as the default306 R'G'B' to limited range Y'CbCr. So choosing full range as the default
101 and allow the kernel modules to be signed with a key of your choosing.
45 1. Don't use eHCA Infiniband hardware, instead choosing hardware
49 choosing to use ST wq for polling PIOs and accepting an unnecessary
52 The biggest reason for choosing a kernel-based implementation rather
5 have the liberty of choosing these. These combinations are called Operating
289 choosing the target file and the timing. The user can do manual875 This disables the automatic compression and gives the user discretion of choosing the
161 which choosing that state become the most energy efficient option. A good
54 - Choosing a single interface to describe the abstraction between a platform