Home
last modified time | relevance | path

Searched +full:codec +full:- +full:gpio2 (Results 1 – 11 of 11) sorted by relevance

/Documentation/devicetree/bindings/pinctrl/
Dcirrus,lochnagar.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - patches@opensource.cirrus.com
14 Smart CODEC and Amp devices. It allows the connection of most Cirrus
15 Logic devices on mini-cards, as well as allowing connection of various
26 [2] Pinctrl: ../pinctrl/pinctrl-bindings.txt
29 [3] include/dt-bindings/pinctrl/lochnagar.h
37 - cirrus,lochnagar-pinctrl
39 gpio-controller: true
[all …]
Dcirrus,madera.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - patches@opensource.cirrus.com
19 between CODECs so refer to the datasheet for the CODEC for further information
30 Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt
33 pinctrl-0:
38 pinctrl-names:
43 pin-settings:
50 '-pins$':
[all …]
/Documentation/devicetree/bindings/sound/
Dmt2701-cs42448.txt1 MT2701 with CS42448 CODEC
4 - compatible: "mediatek,mt2701-cs42448-machine"
5 - mediatek,platform: the phandle of MT2701 ASoC platform
6 - audio-routing: a list of the connections between audio
7 - mediatek,audio-codec: the phandles of cs42448 codec
8 - mediatek,audio-codec-bt-mrg the phandles of bt-sco dummy codec
9 - pinctrl-names: Should contain only one value - "default"
10 - pinctrl-0: Should specify pin control groups used for this controller.
11 - i2s1-in-sel-gpio1, i2s1-in-sel-gpio2: Should specify two gpio pins to
12 control I2S1-in mux.
[all …]
Dpcm1789.txt3 PCM1789 is a simple audio codec that can be connected via
8 - compatible: "ti,pcm1789"
12 - reg: the I2C address
13 - reset-gpios: GPIO to control the RESET pin
17 audio-codec@4c {
20 reset-gpios = <&gpio2 14 GPIO_ACTIVE_LOW>;
21 #sound-dai-cells = <0>;
Drt5660.txt1 RT5660 audio CODEC
7 - compatible : "realtek,rt5660".
9 - reg : The I2C address of the device.
13 - clocks: The phandle of the master clock to the CODEC
14 - clock-names: Should be "mclk"
16 - realtek,in1-differential
17 - realtek,in3-differential
18 Boolean. Indicate MIC1/3 input are differential, rather than single-ended.
20 - realtek,poweroff-in-suspend
21 Boolean. If the codec will be powered off in suspend, the resume should be
[all …]
Drt5668.txt1 RT5668B audio CODEC
7 - compatible : "realtek,rt5668b"
9 - reg : The I2C address of the device.
13 - interrupts : The CODEC's interrupt output.
15 - realtek,dmic1-data-pin
17 1: using GPIO2 pin as dmic1 data pin
20 - realtek,dmic1-clk-pin
24 - realtek,jd-src
28 - realtek,ldo1-en-gpios : The GPIO that controls the CODEC's LDO1_EN pin.
43 interrupt-parent = <&gpio>;
[all …]
Dnokia,rx51.txt4 - compatible: Should contain "nokia,n900-audio"
5 - nokia,cpu-dai: phandle for the McBSP node
6 - nokia,audio-codec: phandles for the main TLV320AIC3X node and the
8 - nokia,headphone-amplifier: phandle for the TPA6130A2 node
9 - tvout-selection-gpios: GPIO for tvout selection
10 - jack-detection-gpios: GPIO for jack detection
11 - eci-switch-gpios: GPIO for ECI (Enhancement Control Interface) switch
12 - speaker-amplifier-gpios: GPIO for speaker amplifier
17 compatible = "nokia,n900-audio";
19 nokia,cpu-dai = <&mcbsp2>;
[all …]
Drt5682.txt1 RT5682 audio CODEC
7 - compatible : "realtek,rt5682" or "realtek,rt5682i"
9 - reg : The I2C address of the device.
13 - interrupts : The CODEC's interrupt output.
15 - realtek,dmic1-data-pin
17 1: using GPIO2 pin as dmic1 data pin
20 - realtek,dmic1-clk-pin
24 - realtek,jd-src
28 - realtek,ldo1-en-gpios : The GPIO that controls the CODEC's LDO1_EN pin.
30 - realtek,btndet-delay
[all …]
Drt5677.txt1 RT5677 audio CODEC
7 - compatible : "realtek,rt5677".
9 - reg : The I2C address of the device.
11 - interrupts : The CODEC's interrupt output.
13 - gpio-controller : Indicates this device is a GPIO controller.
15 - #gpio-cells : Should be two. The first cell is the pin number and the
20 - realtek,pow-ldo2-gpio : The GPIO that controls the CODEC's POW_LDO2 pin.
21 - realtek,reset-gpio : The GPIO that controls the CODEC's RESET pin. Active low.
23 - realtek,in1-differential
24 - realtek,in2-differential
[all …]
Drt5640.txt1 RT5640/RT5639 audio CODEC
7 - compatible : One of "realtek,rt5640" or "realtek,rt5639".
9 - reg : The I2C address of the device.
11 - interrupts : The CODEC's interrupt output.
15 - clocks: The phandle of the master clock to the CODEC
16 - clock-names: Should be "mclk"
18 - realtek,in1-differential
19 - realtek,in2-differential
20 - realtek,in3-differential
21 Boolean. Indicate MIC1/2/3 input are differential, rather than single-ended.
[all …]
/Documentation/sound/hd-audio/
Dmodels.rst2 HD-Audio Codec-Specific Models
8 3-jack in back and a headphone out
9 3stack-digout
10 3-jack in back, a HP out and a SPDIF out
12 5-jack in back, 2-jack in front
13 5stack-digout
14 5-jack in back, 2-jack in front, a SPDIF out
16 6-jack in back, 2-jack in front
17 6stack-digout
18 6-jack with a SPDIF out
[all …]