Searched full:comparing (Results 1 – 25 of 44) sorted by relevance
12
64 temp1_max_alarm Chip temperature high alarm. Set by comparing67 temp1_crit_alarm Chip temperature critical high alarm. Set by comparing
77 temp1_max_alarm Chip temperature high alarm. Set by comparing80 temp1_crit_alarm Chip temperature critical high alarm. Set by comparing
67 temp1_max_alarm Chip temperature high alarm. Set by comparing70 temp1_crit_alarm Chip temperature critical high alarm. Set by comparing
263 tempX_min_alarm Chip temperature low alarm. Set by comparing266 tempX_max_alarm Chip temperature high alarm. Set by comparing269 tempX_lcrit_alarm Chip temperature critical low alarm. Set by comparing272 tempX_crit_alarm Chip temperature critical high alarm. Set by comparing
44 The format of device ID structures and the semantics for comparing51 comparing the device IDs the driver supports with the device ID of a
29 supports. The format and semantics for comparing IDs is bus-specific.
47 of these structures and the semantics for comparing device IDs are
337 The format of the device IDs, and the semantics for comparing them are
42 Linux kernel computes NUMA distance between two domains by recursively comparing45 comparing domains.
30 can be identified by comparing this driver to the i2c-ali15x3 driver. For
25 Specifies the value of threshold that the device is comparing
30 A touch input may be determined by comparing the raw capacitance measurement to
133 An application can detect if scaling is performed by comparing the width
14 record matches the device being updated. This requires comparing the record
20 limited comparing to the range if acceleration is disabled (see list
66 How many frame interval measurements to average before comparing against
74 10 COMPs, comparing the same file on the SCSI hard drive, i.e. "COMP
5 * should we have HOWTO engineer a correct matrix for a new device (without comparing to a different…
87 - Be very careful about comparing pointers obtained from90 substitute the pointer you are comparing against for the pointer
113 comparing the stack traces can often help determine where the stall
37 precisely which pages are mapped (or in swap) and comparing mapped
118 firmware makes the decision over which firmware will be loaded by comparing
148 boot, the measurement can be verified by comparing it to what the guest owner
52 - When comparing performance with other filesystems, it's always55 filesystems do well compared to others. When comparing versus ext3,
125 name it's comparing to with its code page (850). These could never match. Is it