Searched full:connects (Results 1 – 25 of 65) sorted by relevance
123
| /Documentation/devicetree/bindings/iio/adc/ |
| D | renesas,gyroadc.txt | 41 of each MB88101A connects to a shared input pin of
51 connects to a shared input pin of the GyroADC.
60 connects to a shared input pin of the GyroADC.
|
| /Documentation/devicetree/bindings/net/wireless/ |
| D | esp,esp8089.txt | 5 that connects the device to the system.
|
| D | brcm,bcm43xx-fmac.txt | 5 connects the device to the system.
|
| D | ti,wlcore.txt | 5 connects the device to the system.
|
| D | marvell-8xxx.txt | 6 connects the device to the system.
|
| /Documentation/devicetree/bindings/clock/ |
| D | renesas,rcar-usb2-clock-sel.txt | 12 Case 1: An external clock connects to R-Car SoC
19 Case 2: An oscillator connects to R-Car SoC
|
| D | arm,syscon-icst.yaml | 25 connects the low 8 bits of the VDW (missing one bit), hard-wires RDW to
|
| /Documentation/devicetree/bindings/sound/ |
| D | cs53l30.txt | 26 the hardware design connects both SDOUT1 and SDOUT2
|
| /Documentation/spi/ |
| D | spi-sc18is602.rst | 18 This driver provides connects a NXP SC18IS602/603 I2C-bus to SPI bridge to the
|
| /Documentation/devicetree/bindings/display/hisilicon/ |
| D | dw-dsi.txt | 12 The input port connects to ADE output port with the reg value "0".
|
| /Documentation/devicetree/bindings/timer/ |
| D | sifive,clint.yaml | 16 interrupts. It directly connects to the timer and inter-processor interrupt
|
| /Documentation/devicetree/bindings/arm/ |
| D | coresight-cpu-debug.txt | 7 and eventually the debug module connects with CPU for debugging. And the
|
| /Documentation/networking/device_drivers/hamradio/ |
| D | baycom.rst | 49 for handling the HDLC protocol. The modem connects to a serial port,
58 The PC then empties the shift register in a burst. This modem connects
69 EPP This is a high-speed modem adaptor that connects to an enhanced parallel
|
| /Documentation/devicetree/bindings/phy/ |
| D | rockchip-mipi-dphy-rx0.yaml | 14 The Rockchip SoC has a MIPI D-PHY bus with an RX0 entry which connects to
|
| /Documentation/devicetree/bindings/arm/stm32/ |
| D | st,mlahb.yaml | 14 These bindings describe the STM32 SoCs ML-AHB interconnect bus which connects
|
| /Documentation/hwmon/ |
| D | intel-m10-bmc-hwmon.rst | 21 Cards (PAC). It connects to a set of sensor chips to monitor the
|
| /Documentation/devicetree/bindings/input/ |
| D | pxa27x-keypad.txt | 21 tells the level of pins that connects to the direct keyes.
|
| /Documentation/i2c/ |
| D | summary.rst | 34 Using the terminology from the official documentation, the I2C bus connects
|
| /Documentation/devicetree/bindings/net/ |
| D | qcom-emac.txt | 5 connects the MAC node to its corresponding internal phy node. Another
|
| /Documentation/sound/soc/ |
| D | machine.rst | 62 /* corgi digital audio interface glue - connects codec <--> CPU */
|
| /Documentation/devicetree/bindings/interrupt-controller/ |
| D | sifive,plic-1.0.0.yaml | 13 specification. The PLIC connects all external interrupts in the system to all
|
| /Documentation/devicetree/bindings/bus/ |
| D | socionext,uniphier-system-bus.yaml | 10 The UniPhier System Bus is an external bus that connects on-board devices to
|
| /Documentation/filesystems/nfs/ |
| D | rpc-server-gss.rst | 76 This upcall mechanism uses the kernel rpc client and connects to the gssproxy
|
| /Documentation/driver-api/mei/ |
| D | iamt.rst | 90 2) Intel MEI iAMT watchdog driver - connects to the watchdog feature,
|
| /Documentation/devicetree/bindings/usb/ |
| D | amlogic,meson-g12a-usb-ctrl.yaml | 18 A glue connects the DWC3 core to USB2 PHYs and optionally to an USB3 PHY.
|
123