Searched full:counting (Results 1 – 25 of 78) sorted by relevance
1234
| /Documentation/ABI/testing/ |
| D | sysfs-bus-iio-timer-stm32 | 107 When counting up the counter starts from 0 and fires an
109 When counting down the counter start from preset value
123 counting direction is set by in_count0_count_direction
130 Counting is enabled when connected trigger signal
131 level is high else counting is disabled.
134 Counting is enabled on rising edge of the connected
149 counting direction is set by in_count0_count_direction
|
| D | sysfs-bus-iio-counter-104-quad-8 | 25 Counting is continuous in either direction.
31 counter freezes at count = preset when counting up, and
32 at count = 0 when counting down. At either of these
33 limits, the counting is resumed only when the count
45 counting up, while the counter is set to the preset
46 value at count = 0 when counting down; the counter does
|
| D | sysfs-bus-counter | 30 Counting is continuous in either direction.
37 count = ceiling when counting up, and at count = floor
38 when counting down. At either of these limits, the
39 counting is resumed only when the count direction is
52 counting up, while the counter is set to the Count Y
53 ceiling value at count = floor when counting down; the
76 their counting. For example, quadrature encoding counters can
|
| D | sysfs-class-net | 322 32-bit unsigned integer counting the number of times the link has
330 32-bit unsigned integer counting the number of times the link has
338 32-bit unsigned integer counting the number of times the link has
|
| /Documentation/arm64/ |
| D | perf.rst | 61 must enable/disable counting on the entry and exit to the guest. This is
83 able to eliminate counters counting host events on the boundaries of guest
84 entry/exit when counting guest events by filtering out EL2 for
|
| /Documentation/devicetree/bindings/arc/ |
| D | archs-pct.txt | 3 The ARC HS can be configured with a pipeline performance monitor for counting
|
| D | pct.txt | 3 The ARC700 can be configured with a pipeline performance monitor for counting
|
| /Documentation/devicetree/bindings/perf/ |
| D | nds32v3-pmu.txt | 3 NDS32 core have a PMU for counting cpu and cache events like cache misses.
|
| /Documentation/misc-devices/ |
| D | apds990x.rst | 55 RW - enable / disable chip. Uses counting logic
109 RW - enable / disable proximity - uses counting logic
|
| D | bh1770glc.rst | 57 Uses counting logic
110 Uses counting logic
|
| /Documentation/devicetree/bindings/watchdog/ |
| D | gpio-wdt.txt | 11 - level: Low or high level starts counting WDT timeout,
|
| D | atmel-sama5d4-wdt.txt | 18 watchdog not counting when the CPU is in idle state, therefore the
|
| D | atmel-wdt.txt | 31 watchdog not counting when the CPU is in idle state, therefore the
|
| /Documentation/admin-guide/perf/ |
| D | imx-ddr.rst | 13 interrupt is raised. If any other counter overflows, it continues counting, and
70 counting the number of bytes (as opposed to the number of bursts) from DDR
|
| D | arm_dsu_pmu.rst | 7 allows counting the various events related to the L3 cache, Snoop Control Unit
|
| D | hisi-pmu.rst | 18 Each device PMU has separate registers for event counting, control and
|
| /Documentation/devicetree/bindings/rtc/ |
| D | renesas,sh-rtc.yaml | 33 # first (if it exists). Additionally, potential clock counting sources
|
| /Documentation/admin-guide/device-mapper/ |
| D | dm-flakey.rst | 56 Counting starts at 1, to replace the first byte.
|
| /Documentation/core-api/ |
| D | pin_user_pages.rst | 45 uses a different reference counting technique.
59 GUP_PIN_COUNTING_BIAS scheme is not used. Instead, an exact form of pin counting
63 This approach for compound pages avoids the counting upper limit problems that
267 dump_page() has been enhanced slightly, to handle these new counting fields, and
|
| D | local_ops.rst | 98 Counting chapter
101 Counting is done on all the bits of a signed long.
|
| /Documentation/RCU/ |
| D | rcuref.rst | 16 Reference counting on elements of lists which are protected by traditional
157 reference counting of struct pid, while the pattern in listing B is used by
|
| /Documentation/devicetree/bindings/arm/ |
| D | pmu.yaml | 14 ARM cores often have a PMU for counting cpu and cache events like cache misses
|
| /Documentation/admin-guide/sysctl/ |
| D | user.rst | 33 This recursive counting of created objects ensures that creating a
|
| /Documentation/filesystems/nfs/ |
| D | pnfs.rst | 2 Reference counting in pnfs
|
| /Documentation/driver-api/ |
| D | basics.rst | 75 Reference counting
|
1234