Searched full:debounce (Results 1 – 25 of 50) sorted by relevance
12
| /Documentation/devicetree/bindings/sound/ |
| D | nau8825.txt | 63 - nuvoton,short-key-debounce: Button short key press debounce time.
69 - nuvoton,jack-insert-debounce: number from 0 to 7 that sets debounce time to 2^(n+2) ms
70 - nuvoton,jack-eject-debounce: number from 0 to 7 that sets debounce time to 2^(n+2) ms
98 nuvoton,short-key-debounce = <2>;
99 nuvoton,jack-insert-debounce = <7>;
100 nuvoton,jack-eject-debounce = <7>;
|
| D | nau8824.txt | 59 - nuvoton,short-key-debounce: Button short key press debounce time.
64 - nuvoton,jack-eject-debounce: Jack ejection debounce time.
86 nuvoton,short-key-debounce = <0>;
87 nuvoton,jack-eject-debounce = <1>;
|
| D | cs42l42.txt | 30 - cirrus,ts-dbnc-rise : Debounce the rising edge of TIP_SENSE_PLUG. With no
31 debounce, the tip sense pin might be noisy on a plug event.
42 - cirrus,ts-dbnc-fall : Debounce the falling edge of TIP_SENSE_UNPLUG.
43 With no debounce, the tip sense pin might be noisy on an unplug event.
|
| D | da7218.txt | 58 - dlg,jack-debounce : Number of debounce measurements taken for jack detect
98 dlg,jack-debounce = <2>;
|
| /Documentation/devicetree/bindings/gpio/ |
| D | gpio-eic-sprd.txt | 6 controller contains 4 sub-modules: EIC-debounce, EIC-latch, EIC-async and
7 EIC-sync. But the PMIC EIC controller contains only one EIC-debounce sub-
10 The EIC-debounce sub-module provides up to 8 source input signal
11 connections. A debounce mechanism is used to capture the input signals'
15 automatically to reduce power dissipation. Moreover the debounce range
32 "sprd,sc9860-eic-debounce",
49 compatible = "sprd,sc9860-eic-debounce";
|
| D | gpio-max3191x.txt | 25 - maxim,db0-gpios: GPIO pins to configure debounce of each chip.
28 - maxim,db1-gpios: GPIO pins to configure debounce of each chip.
|
| /Documentation/devicetree/bindings/input/ |
| D | lpc32xx-key.txt | 12 - nxp,debounce-delay-ms: Debounce delay in ms
31 nxp,debounce-delay-ms = <3>;
|
| D | pxa27x-keypad.txt | 7 - marvell,debounce-interval : How long time the key will be
9 is debounce interval for direct key and bit[15:0] is debounce
59 marvell,debounce-interval = <0x001e001e>;
|
| D | brcm,bcm-keypad.txt | 29 - col-debounce-filter-period: The debounce period for the Column filter.
40 - status-debounce-filter-period: The debounce period for the Status filter.
102 col-debounce-filter-period = <5>;
|
| D | gpio-matrix-keypad.txt | 24 - debounce-delay-ms: debounce interval in milliseconds
33 debounce-delay-ms = <5>;
|
| D | stmpe-keypad.txt | 8 - debounce-interval : Debouncing interval time in milliseconds
19 debounce-interval = <64>;
|
| D | qcom,pm8xxx-pwrkey.txt | 25 - debounce:
44 debounce = <15625>;
|
| D | ti,palmas-pwrbutton.txt | 20 - ti,palmas-pwron-debounce-milli-seconds: Duration in milliseconds
33 ti,palmas-pwron-debounce-milli-seconds = <15>;
|
| D | qcom,pm8941-pwrkey.txt | 24 - debounce:
50 debounce = <15625>;
|
| D | nvidia,tegra20-kbc.txt | 29 - nvidia,debounce-delay-ms: delay in milliseconds per row scan for debouncing
45 nvidia,debounce-delay-ms = <640>;
|
| D | qcom,pm8xxx-keypad.txt | 54 - debounce:
87 debounce = <15>;
|
| /Documentation/devicetree/bindings/power/supply/ |
| D | lp8727_charger.txt | 9 - debounce-ms: interrupt debounce time. (u32)
28 debounce-ms = <300>;
|
| /Documentation/devicetree/bindings/input/touchscreen/ |
| D | ads7846.txt | 53 ti,debounce-tol Tolerance used for filtering (u16).
54 ti,debounce-rep Additional consecutive good readings
56 ti,pendown-gpio-debounce Platform specific debounce time for the
82 ti,debounce-max Max number of additional readings per
|
| D | fsl-mx25-tcq.txt | 14 - fsl,pen-debounce-ns: Pen debounce time in nanoseconds.
|
| /Documentation/devicetree/bindings/extcon/ |
| D | extcon-palmas.txt | 17 - debounce-delay-ms: debounce delay for GPIO ID pin in milliseconds.
|
| /Documentation/devicetree/bindings/power/reset/ |
| D | qcom,pon.txt | 37 debounce = <15625>;
45 debounce = <15625>;
|
| /Documentation/devicetree/bindings/mfd/ |
| D | tc3589x.txt | 49 - debounce-delay-ms : debounce interval in milliseconds
83 debounce-delay-ms = <4>;
|
| /Documentation/devicetree/bindings/display/ |
| D | ht16k33.txt | 9 - debounce-delay-ms: Debouncing interval time in milliseconds.
24 debounce-delay-ms = <50>;
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | atmel,at91-pinctrl.txt | 104 DEBOUNCE (1 << 16): indicate this pin needs debounce.
105 DEBOUNCE_VAL (0x3fff << 17): debounce value.
|
| /Documentation/devicetree/bindings/phy/ |
| D | ti,phy-j721e-wiz.yaml | 66 typec-dir-debounce-ms:
72 If not specified, the default debounce of 100ms will be used.
73 Type-C spec states minimum CC pin debounce of 100 ms and maximum
|
12