Searched full:denotes (Results 1 – 25 of 38) sorted by relevance
12
| /Documentation/devicetree/bindings/dma/ |
| D | qcom_adm.txt | 7 - #dma-cells: must be <2>. First cell denotes the channel number. Second cell
8 denotes CRCI (client rate control interface) flow control assignment.
|
| D | nvidia,tegra210-adma.txt | 19 - #dma-cells : Must be 1. The first cell denotes the receive/transmit
|
| /Documentation/ABI/testing/ |
| D | sysfs-devices-consumer | 6 links where this device is the supplier. <consumer> denotes the
|
| D | sysfs-devices-supplier | 6 links where this device is the consumer. <supplier> denotes the
|
| D | sysfs-driver-hid-logitech-lg4ff | 19 contains an abstract item "native" which always denotes the
|
| D | sysfs-class-extcon | 10 One extcon device denotes a single external connector
|
| /Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,smsm.txt | 57 Definition: must be 1 - denotes bit number
68 Definition: must be 2 - denotes bit number and IRQ flags
|
| /Documentation/devicetree/bindings/interrupt-controller/ |
| D | aspeed,ast2400-i2c-ic.txt | 12 - interrupt-controller : denotes that the controller receives and fires
|
| /Documentation/devicetree/bindings/net/ |
| D | fsl-tsec-phy.txt | 70 - rx-stash-len : Denotes the number of bytes of a received buffer to stash
72 - rx-stash-idx : Denotes the index of the first byte from the received
|
| D | ti,dp83867.yaml | 91 This denotes the fact that the board has RX_DV/RX_CTRL pin strapped in
99 This denotes which SGMII configuration is used (4 or 6-wire modes).
|
| /Documentation/devicetree/bindings/phy/ |
| D | brcm,sr-pcie-phy.txt | 8 - #phy-cells: Must be 1, denotes the PHY index
|
| /Documentation/userspace-api/media/v4l/ |
| D | vidioc-enum-framesizes.rst | 86 In the structs below, *IN* denotes a value that has to be filled in by
87 the application, *OUT* denotes values that the driver fills in. The
|
| D | vidioc-enum-frameintervals.rst | 96 In the structs below, *IN* denotes a value that has to be filled in by
97 the application, *OUT* denotes values that the driver fills in. The
|
| D | vidioc-dqevent.rst | 176 associated with it. The ``changes`` bitfield denotes what has
|
| /Documentation/admin-guide/sysctl/ |
| D | fs.rst | 111 The value in file-max denotes the maximum number of file-
133 This denotes the maximum number of file-handles a process can
145 The value in inode-max denotes the maximum number of inode
325 This denotes the maximum number of mounts that may exist
|
| /Documentation/devicetree/bindings/leds/ |
| D | leds-lp50xx.yaml | 65 This property denotes the LED module number(s) that is used on the
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | qcom,pmic-mpp.txt | 48 second denotes the flags for this MPP
|
| D | qcom,pmic-gpio.txt | 57 second denotes the flags for this gpio
|
| /Documentation/devicetree/bindings/media/xilinx/ |
| D | xlnx,csi2rxss.yaml | 49 This denotes the CSI Data type selected in hw design.
|
| /Documentation/devicetree/bindings/mmc/ |
| D | mmc-controller.yaml | 118 When specified, denotes that 1.8V card voltage is not supported
327 subnode describes. A value of 0 denotes the memory SD
|
| /Documentation/accounting/ |
| D | taskstats.rst | 80 containing a u32 pid or tgid in the attribute payload. The pid/tgid denotes
|
| /Documentation/admin-guide/kdump/ |
| D | vmcoreinfo.rst | 338 The HUGETLB_PAGE_DTOR flag denotes hugetlbfs pages. Makedumpfile
411 Denotes whether physical address extensions are enabled. It has the cost
|
| /Documentation/bpf/ |
| D | ringbuf.rst | 162 - producer counter denotes amount of data reserved by all producers.
|
| /Documentation/devicetree/bindings/pci/ |
| D | nvidia,tegra194-pcie.txt | 67 - cell 1 denotes the upper 32 address bits and should be 0
|
| /Documentation/powerpc/ |
| D | transactional_memory.rst | 46 The 'tbegin' instruction denotes the start point, and 'tend' the end point.
|
12