Searched full:encodes (Results 1 – 25 of 47) sorted by relevance
12
| /Documentation/virt/kvm/devices/ |
| D | arm-vgic-v3.rst | 41 - index encodes the unique redistributor region index
43 - base field encodes bits [51:16] of the guest physical base address
45 - count encodes the number of redistributors in the region. Must be
80 The attr field of kvm_device_attr encodes two values::
174 The attr field of kvm_device_attr encodes two values::
179 The mpidr field encodes the CPU ID based on the affinity information in the
185 The instr field encodes the system register to access based on the fields
252 The attr field of kvm_device_attr encodes the following values::
280 The mpidr field encodes the CPU ID based on the affinity information in the
|
| D | arm-vgic-its.rst | 68 encodes the ABI revision.
90 The attr field of kvm_device_attr encodes the offset of the
105 - GITS_IIDR. The Revision field encodes the table layout ABI revision.
|
| D | arm-vgic.rst | 50 The attr field of kvm_device_attr encodes two values::
84 The attr field of kvm_device_attr encodes two values::
|
| /Documentation/devicetree/bindings/arm/amlogic/ |
| D | analog-top.txt | 5 "metal revision" (which encodes the "minor version") of the SoC.
|
| D | amlogic,meson-gx-ao-secure.yaml | 37 A firmware register encodes the SoC type, package and revision
|
| /Documentation/devicetree/bindings/gpio/ |
| D | gpio-ts4900.txt | 4 TS-4900's FPGA encodes the GPIO state on 3 bits, whereas the TS-7970's FPGA
|
| D | mediatek,mt7621-gpio.txt | 15 the second encodes the trigger flags encoded as described in
|
| /Documentation/vm/ |
| D | z3fold.rst | 26 handle which encodes actual location of the allocated object.
|
| D | zsmalloc.rst | 28 Instead, it returns an opaque handle (unsigned long) which encodes actual
|
| D | memory-model.rst | 85 `flags` field of the `struct page` encodes the node number of the
151 The classic sparse encodes the section number of a page in page->flags
|
| /Documentation/networking/caif/ |
| D | linux_caif.rst | 104 - CFCTRL CAIF Control layer. Encodes and Decodes control messages
112 External Interface). This layer encodes/decodes VEI frames.
115 traffic), encodes/decodes Datagram frames.
|
| /Documentation/devicetree/bindings/spi/ |
| D | spi-nxp-fspi.txt | 17 This encodes to which bus and CS the flash is connected:
|
| D | spi-fsl-qspi.txt | 18 This encodes to which bus and CS the flash is connected:
|
| /Documentation/devicetree/bindings/memory-controllers/ |
| D | atmel,ebi.txt | 25 The first cell encodes the CS.
31 - ranges: Encodes CS to memory region association.
|
| /Documentation/devicetree/bindings/mtd/ |
| D | cadence-nand-controller.txt | 10 - #address-cells: should be 1. The cell encodes the chip select connection.
|
| /Documentation/devicetree/bindings/pwm/ |
| D | pwm.txt | 43 pwm-specifier typically encodes the chip-relative PWM number and the PWM
|
| /Documentation/devicetree/bindings/display/bridge/ |
| D | ite,it6505.yaml | 20 also encodes and transmits up to 8 channels of I2S digital audio,
|
| /Documentation/filesystems/ |
| D | squashfs.rst | 122 by a 48-bit number which encodes the location of the compressed metadata block
222 name and value field. The type field encodes the xattr prefix
223 ("user.", "trusted." etc) and it also encodes how the name/value fields
|
| /Documentation/userspace-api/media/v4l/ |
| D | ext-ctrls-fm-rx.rst | 27 Gets RDS Programme Type field. This encodes up to 31 pre-defined
|
| D | ext-ctrls-fm-tx.rst | 33 Sets the RDS Programme Type field for transmission. This encodes up
|
| /Documentation/devicetree/bindings/interrupt-controller/ |
| D | mti,gic.yaml | 28 GIC interrupt number. The 3d cell encodes the interrupt flags setting up
|
| /Documentation/bpf/ |
| D | btf.rst | 8 BTF (BPF Type Format) is the metadata format which encodes the debug info
88 Note that the type section encodes debug info, not just pure types.
148 type. For example, a 4-bit bitfield encodes ``BTF_INT_BITS()`` equals to 4.
257 ``BTF_INT_BITS()`` encodes the bitfield size.
633 The .BTF.ext section encodes func_info and line_info which needs loader
697 The .BTF_ids section encodes BTF ID values that are used within the kernel.
|
| /Documentation/ABI/testing/ |
| D | sysfs-driver-wacom | 76 byte chunk encodes the image data for two consecutive lines on
|
| /Documentation/devicetree/bindings/mux/ |
| D | mux-controller.txt | 37 mux-ctrl-specifier typically encodes the chip-relative mux controller number.
|
| /Documentation/devicetree/bindings/i3c/ |
| D | i3c.txt | 90 + first cell : encodes the static I2C address. Should be 0 if the device does
|
12