Searched full:goes (Results 1 – 25 of 195) sorted by relevance
12345678
17 sleep mode when the DQ line goes low for greater19 line goes high.
32 stays active until the temperature goes above temp1_max.35 output pin becomes active when the temperature goes above temp1_max and stays
44 goes above it, and an alarm is also produced when the value goes below
157 - Generated if the CEC pin goes from a high voltage to a low voltage.164 - Generated if the CEC pin goes from a low voltage to a high voltage.171 - Generated if the HPD pin goes from a high voltage to a low voltage.180 - Generated if the HPD pin goes from a low voltage to a high voltage.189 - Generated if the 5V pin goes from a high voltage to a low voltage.198 - Generated if the 5V pin goes from a low voltage to a high voltage.
34 interface goes up::42 interface goes down::
16 Channel Y low voltage threshold. If sensor input voltage goes lower then35 Channel Y high voltage threshold. If sensor input voltage goes higher then
19 recorded here (the hcall will retry until -EBUSY goes away).
27 pages_to_scan: how many present pages to scan before ksmd goes
12 The intent is to provide enough detail that if something goes
30 goes through every event and calls generic_handle_irq() for event32 counter so interrupt goes away (eventually).
44 by hardware when the system specified by sleep mode goes into deep47 means when PUBCP system goes into deep sleep mode, this pin will be set53 when the PUBCP system goes into deep sleep mode. Thus we introduce
34 Sets the DP83822 to detect a link drop condition when the signal goes35 high. If not set then link drop will occur when the signal goes low.
27 of the device. On many systems this is wired high so the device goes
4 # only goes back to 1.6. So here's a wrapper layer to keep around for
17 two CbCr pairs and eight Y's. The first CbCr pair goes with the first18 four Y's, and the second CbCr pair goes with the other four Y's. The Cb
7 the decompressor (the real mode entry point goes to the same 32bit
22 compression ratio goes to around 2.7x while zbud's one is around 1.7x.
15 it goes to maximum backlight then you can set the level of backlight
11 PHY index goes from 0 to 7
14 retrieve the DMA request or channel information that goes from a
10 The penirq pin goes to low when the panel is touched.
29 If one of the user ports leave the bridge, the ports goes back to the initial
19 the enable signal goes low. This GPIO is used to actively discharge
25 the :kbd:`HOME` key goes back
10 communication. The driver goes under drives/nfc/ and is compiled as a