Searched full:logic (Results 1 – 25 of 264) sorted by relevance
1234567891011
| /Documentation/devicetree/bindings/bus/ |
| D | arm,integrator-ap-lm.yaml | 7 title: Integrator/AP Logic Module extension bus
13 site for stacking up to four logic modules (LM) designed specifically for
15 determine if a logic module is connected at index 0, 1, 2 or 3. The logic
16 module connector is described in this binding. The logic modules per se
18 as subnodes under this logic module extension bus.
36 description: Nodes on the Logic Module bus represent logic modules
61 /* The Logic Modules sees the Core Module 0 RAM @80000000 */
|
| /Documentation/devicetree/bindings/hwmon/ |
| D | cirrus,lochnagar.yaml | 7 title: Cirrus Logic Lochnagar Audio Development Board
13 Lochnagar is an evaluation and development board for Cirrus Logic
15 Logic devices on mini-cards, as well as allowing connection of various
|
| D | adt7475.yaml | 55 the pwm uses a logic low output for 100% duty cycle. If set to 1 the pwm
56 uses a logic high output for 100% duty cycle.
|
| /Documentation/devicetree/bindings/sound/ |
| D | cirrus,lochnagar.yaml | 7 title: Cirrus Logic Lochnagar Audio Development Board
13 Lochnagar is an evaluation and development board for Cirrus Logic
15 Logic devices on mini-cards, as well as allowing connection of various
|
| D | cs4271.txt | 1 Cirrus Logic CS4271 DT bindings
37 - vl-supply: Logic power
|
| D | davinci-mcasp-audio.txt | 35 2 : logic low
36 3 : logic high
37 Defaults to 'logic low' when the property is not present
|
| /Documentation/devicetree/bindings/extcon/ |
| D | extcon-ptn5150.yaml | 7 title: PTN5150 CC (Configuration Channel) Logic device
13 PTN5150 is a small thin low power CC logic chip supporting the USB Type-C
14 connector application with CC control logic detection and indication
|
| /Documentation/driver-api/media/ |
| D | dtv-core.rst | 10 implement the digital demux logic (either in software or in hardware);
14 - A tuner driver that implements the logic which commands the part of
19 - A demodulator driver (a.k.a "demod") that implements the logic which
|
| /Documentation/misc-devices/ |
| D | bh1770glc.rst | 22 interface and interrupt logic. In principle they can run on their own,
25 ALS produces 16 bit lux values. The chip contains interrupt logic to produce
57 Uses counting logic
110 Uses counting logic
|
| /Documentation/driver-api/media/drivers/ |
| D | pvrusb2.rst | 76 pvrusb2-audio.[ch] - This is glue logic that resides between this
101 pvrusb2-eeprom.[ch] - This is glue logic that resides between this
107 device. It is a crude echo of corresponding logic in ivtv,
125 pvrusb2-hdw.c - This module implements all the various bits of logic
130 pvrusb2-i2c-chips-\*.c - These modules implement the glue logic to
134 implement just the logic that makes sense for a pure V4L
156 glue logic which is coordinated by pvrusb2-hdw, doled out by
180 pvrusb2-tuner.[ch] - This is glue logic that resides between this
194 pvrusb2-video-\*.[ch] - This is glue logic that resides between this
|
| /Documentation/devicetree/bindings/regulator/ |
| D | wlf,arizona.yaml | 7 title: Cirrus Logic/Wolfson Microelectronics Arizona/Madera class audio SoCs
18 and for Cirrus Logic Madera codecs ../mfd/madera.txt
|
| /Documentation/devicetree/bindings/clock/ |
| D | cirrus,lochnagar.yaml | 7 title: Cirrus Logic Lochnagar Audio Development Board
13 Lochnagar is an evaluation and development board for Cirrus Logic
15 Logic devices on mini-cards, as well as allowing connection of various
|
| /Documentation/watchdog/ |
| D | mlx-wdt.rst | 11 Mellanox watchdog device is implemented in a programmable logic device.
36 with new programmer logic device.
66 Programmable logic device registers have little-endian order.
|
| /Documentation/devicetree/bindings/usb/ |
| D | dwc3-st.txt | 1 ST DWC3 glue logic
4 This driver controls the glue logic used to configure the dwc3 core on
9 - reg : glue logic base address and USB syscfg ctrl register offset
|
| /Documentation/devicetree/bindings/media/i2c/ |
| D | tvp7002.txt | 25 Under normal operation, the field ID output is set to logic 1 for an odd field
26 (field 1) and set to logic 0 for an even field (field 0).
|
| /Documentation/hwmon/ |
| D | gl518sm.rst | 6 * Genesys Logic GL518SM release 0x00
12 * Genesys Logic GL518SM release 0x80
34 This driver supports the Genesys Logic GL518SM chip. There are at least
|
| /Documentation/networking/dsa/ |
| D | bcm_sf2.rst | 84 hardware contains logic which will assert/de-assert link states accordingly for
101 - disabling packet processing logic
105 - turning off RGMII data processing logic when the link goes down
111 MAC controller wake-on logic. Whenever Wake-on-LAN is requested, an intersection
|
| /Documentation/devicetree/bindings/pinctrl/ |
| D | cirrus,madera.yaml | 7 title: Cirrus Logic Madera class audio CODECs pinctrl driver
13 The Cirrus Logic Madera codecs provide a number of GPIO functions for
14 interfacing to external hardware and to provide logic outputs to other devices.
|
| /Documentation/devicetree/bindings/arm/ |
| D | coresight-cpu-debug.txt | 25 mandatory. The interface between the debug logic and the
35 binding to turn on the debug logic if it has own dedicated
|
| /Documentation/networking/device_drivers/ethernet/cirrus/ |
| D | cs89x0.rst | 4 Cirrus Logic LAN CS8900/CS8920 Ethernet Adapters
9 This document was contributed by Cirrus Logic for kernel 2.2.5. This version
24 1.0 CIRRUS LOGIC LAN CS8900/CS8920 ETHERNET ADAPTERS
52 6.1 Contacting Cirrus Logic's Technical Support
59 1. Cirrus Logic LAN CS8900/CS8920 Ethernet Adapters
66 The CS8900-based ISA Ethernet Adapters from Cirrus Logic follow
111 * Cirrus Logic LAN (CS8900/20-based) Ethernet ISA Adapter
172 CS8900-based adapters shipped from Cirrus Logic have been configured
193 CS8920-based adapters are shipped from Cirrus Logic configured as Plug
575 6.1. Contacting Cirrus Logic's Technical Support
[all …]
|
| /Documentation/driver-api/gpio/ |
| D | intro.rst | 39 several dozen of them. Programmable logic devices (like FPGAs) can easily
56 input de-glitch/debounce logic, sometimes with software controls.
99 logic (low=true) perspective this is a "wire-OR".
115 The same logic can be applied to emulate open source signaling, by driving the
|
| /Documentation/devicetree/bindings/iio/adc/ |
| D | adi,ad7606.yaml | 46 This logic input is used to initiate conversions on the analog
78 this pin is tied to a logic high, the analog input range is ±10V for
79 all channels. If this pin is tied to a logic low, the analog input range
|
| /Documentation/networking/device_drivers/ethernet/altera/ |
| D | altera_tse.rst | 39 developer wishes to support their own soft DMA logic and driver support. Any
85 interrupt is driven by the transmit DMA logic. The driver handles the transmit
91 The driver will post receive buffers to the receive DMA logic during driver
93 underlying DMA logic (MSGDMA is able queue receive buffers, SGDMA is not able
94 to queue receive buffers to the SGDMA receive logic). When a packet is
95 received, the DMA logic generates an interrupt. The driver handles a receive
96 interrupt by obtaining the DMA receive logic status, reaping receive
|
| /Documentation/devicetree/bindings/net/ |
| D | cirrus,cs89x0.txt | 1 * Cirrus Logic CS8900/CS8920 Network Controller
|
| /Documentation/devicetree/bindings/power/supply/ |
| D | tps65090.txt | 8 while the default logic is to stop charging.
|
1234567891011