Searched full:multiplex (Results 1 – 24 of 24) sorted by relevance
/Documentation/devicetree/bindings/interrupt-controller/ |
D | fsl,intmux.yaml | 23 Should contain the parent interrupt lines (up to 8) used to multiplex
|
D | fsl,irqsteer.yaml | 25 should contain the up to 8 parent interrupt lines used to multiplex
|
/Documentation/devicetree/bindings/phy/ |
D | qcom,usb-8x16-phy.txt | 54 controlled by GPIO to de/multiplex D+/D- USB lines
|
D | ti,phy-am654-serdes.txt | 42 function. See #phy-cells above to see the multiplex values.
|
/Documentation/devicetree/bindings/pinctrl/ |
D | renesas,rzn1-pinctrl.yaml | 68 These identifiers collapse the IO Multiplex Configuration Level 1
|
D | st,stm32-pinctrl.yaml | 16 also provides ability to multiplex and configure the output of various
|
D | samsung-pinctrl.txt | 5 and also provides ability to multiplex and configure the output of various
|
/Documentation/devicetree/bindings/usb/ |
D | msm-hsusb.txt | 56 SPDT USB Switch, witch is cotrolled by GPIO to de/multiplex
|
/Documentation/devicetree/bindings/dma/ |
D | fsl-edma.txt | 3 The eDMA channels have multiplex capability by programmble memory-mapped
|
/Documentation/userspace-api/media/v4l/ |
D | vidioc-enumstd.rst | 339 multiplex. (NICAM system) 344 DQPSK modulated with a 728 kbit/s sound and data multiplex able to
|
/Documentation/devicetree/bindings/memory-controllers/ |
D | omap-gpmc.txt | 110 - gpmc,wr-data-mux-bus-ns: In address-data multiplex mode, specifies
|
/Documentation/driver-api/ |
D | pinctl.rst | 23 can control PINs. It may be able to multiplex, bias, set load capacitance, 818 multiplex 822 whether the pin is used for GPIO or not. If you multiplex a GPIO onto a 850 multiplex 857 possible that the GPIO, pin config and pin multiplex registers are placed into
|
/Documentation/infiniband/ |
D | opa_vnic.rst | 98 belongs to. On the receive side, this field is used to de-multiplex the
|
/Documentation/networking/ |
D | gtp.rst | 185 The TEID in the GTP-U header is used to de-multiplex traffic
|
D | can.rst | 900 Broadcast Manager Multiplex Message Receive Filter 903 To filter for content changes in multiplex message sequences an array of more 909 Up to 257 CAN frames (multiplex filter bit mask CAN frame plus 256 CAN 957 When using CAN FD frames for multiplex filtering the MUX mask is still
|
D | rxrpc.rst | 325 AF_RXRPC makes use of control messages in sendmsg() and recvmsg() to multiplex
|
/Documentation/vm/ |
D | cleancache.rst | 139 multiplex physical resources across the varying demands of multiple
|
D | frontswap.rst | 117 multiplex physical resources across the varying demands of multiple
|
/Documentation/hid/ |
D | hid-transport.rst | 95 multiplex all four on a single physical channel. However, in this document we
|
/Documentation/virt/uml/ |
D | user_mode_linux_howto_v2.rst | 448 multiplex connections as each GRE tunnel is terminated directly on 522 no way to multiplex connections as each L2TPv3 tunnel is terminated
|
/Documentation/powerpc/ |
D | hvcs.rst | 436 Q: How do I multiplex a console that I grab through hvcs so that other
|
/Documentation/scsi/ |
D | ChangeLog.megaraid | 561 multiplex command to low level RAID module(s).
|
/Documentation/driver-api/gpio/ |
D | legacy.rst | 158 that board setup code probably needs to multiplex that pin as a GPIO,
|
/Documentation/admin-guide/ |
D | devices.txt | 46 master multiplex (/dev/ptmx) to acquire a PTY on 156 2 = /dev/ptmx PTY master multiplex 173 they are redirected through the parport multiplex layer.
|