Searched full:multiplexing (Results 1 – 25 of 56) sorted by relevance
123
| /Documentation/devicetree/bindings/pinctrl/ |
| D | cortina,gemini-pinctrl.txt | 4 see further arm/gemini.txt. It is a purely group-based multiplexing pin
12 Subnodes of the pin controller contain pin control multiplexing set-up
15 Please refer to pinctrl-bindings.txt for generic pin multiplexing nodes
|
| D | pinmux-node.yaml | 7 title: Generic pin multiplexing node schema
23 pin multiplexing nodes:
80 For hardware where pin multiplexing configurations have to be specified for
91 a single pin multiplexing configuration.
100 how pin IDs and pin multiplexing configuration are defined and assembled
|
| D | renesas,rzn1-pinctrl.yaml | 23 - description: GPIO Multiplexing Level1 Register Block
24 - description: GPIO Multiplexing Level2 Register Block
48 A pin multiplexing sub-node describes how to configure a set of (or a
55 Integer array representing pin number and pin multiplexing
|
| D | brcm,bcm2835-gpio.txt | 46 The BCM2835 pin configuration and multiplexing supports the generic bindings.
60 Legacy pin configuration and multiplexing binding:
61 *** (Its use is deprecated, use generic multiplexing and configuration
|
| D | pinctrl-zx.txt | 6 controllers work together to control pin multiplexing and configuration in
39 TOP_PMM and AON_IOCFG blocks, as the available multiplexing functions for
|
| D | renesas,rza2-pinctrl.yaml | 16 Pin multiplexing and GPIO configuration is performed on a per-pin basis.
52 A pin multiplexing sub-node describes how to configure a set of
|
| D | ste,nomadik.txt | 22 pin multiplexing node layout from the standard pin control bindings
25 Required pin multiplexing subnode properties:
29 group that will be combined with the function to form a multiplexing
|
| D | renesas,rza1-ports.yaml | 16 Pin multiplexing and GPIO configuration is performed on a per-pin basis
73 A pin multiplexing sub-node describes how to configure a set of (or a
92 Integer array representing pin number and pin multiplexing
|
| D | mscc,ocelot-pinctrl.txt | 16 The ocelot-pinctrl driver uses the generic pin multiplexing and generic pin
|
| D | intel,lgm-io.yaml | 13 Pinmux & GPIO controller controls pin multiplexing & configuration including
|
| D | pinctrl-bindings.txt | 3 Hardware modules that control pin multiplexing or configuration parameters
142 == Generic pin multiplexing node content ==
|
| D | nxp,lpc1850-scu.txt | 9 The lpc1850-scu driver uses the generic pin multiplexing and generic pin
|
| D | pinctrl-st.txt | 4 PIO multiplexing block. Each pin supports GPIO functionality (ALT0)
11 ST pinctrl driver controls PIO multiplexing block and also interacts with
|
| D | actions,s500-pinctrl.yaml | 14 Pinmux & GPIO controller manages pin multiplexing & configuration including
25 - description: Multiplexing Control
|
| /Documentation/driver-api/serial/ |
| D | n_gsm.rst | 5 This line discipline implements the GSM 07.10 multiplexing protocol
82 Note that after closing the physical port the modem is still in multiplexing
85 a disconnect command frame manually before initializing the multiplexing mode
|
| /Documentation/devicetree/bindings/misc/ |
| D | eeprom-93xx46.txt | 12 each access to the EEPROM (e.g. for SPI bus multiplexing)
|
| /Documentation/devicetree/bindings/i2c/ |
| D | i2c-mux-pinctrl.txt | 3 This binding describes an I2C bus multiplexer that uses pin multiplexing to
4 route the I2C signals, and represents the pin multiplexing configuration
|
| D | i2c-demux-pinctrl.txt | 3 This binding describes an I2C bus demultiplexer that uses pin multiplexing to
4 route the I2C signals, and represents the pin multiplexing configuration using
|
| /Documentation/networking/device_drivers/cellular/qualcomm/ |
| D | rmnet.rst | 10 rmnet driver is used for supporting the Multiplexing and aggregation
17 Multiplexing allows for creation of logical netdevices (rmnet devices) to
|
| /Documentation/devicetree/bindings/memory-controllers/ |
| D | omap-gpmc.txt | 124 - gpmc,mux-add-data Address and data multiplexing configuration.
126 multiplexing mode and 2 for address-data
127 multiplexing mode.
|
| /Documentation/devicetree/bindings/fsi/ |
| D | fsi-master-gpio.txt | 12 - mux-gpios = <gpio-descriptor>; : GPIO for pin multiplexing with other
|
| D | fsi-master-ast-cf.txt | 14 - mux-gpios = <gpio-descriptor>; : GPIO for pin multiplexing with other
|
| /Documentation/driver-api/media/ |
| D | dtv-core.rst | 27 .. [#f1] Some standards use TCP/IP for multiplexing data, like DVB-H (an
|
| /Documentation/devicetree/bindings/ata/ |
| D | cortina,gemini-sata-bridge.txt | 16 - cortina,gemini-ata-muxmode: tell the desired multiplexing mode for
|
| /Documentation/driver-api/80211/ |
| D | mac80211-advanced.rst | 150 Spatial Multiplexing Powersave (SMPS)
154 :doc: Spatial multiplexing power save
|
123