Searched full:push (Results 1 – 25 of 66) sorted by relevance
123
/Documentation/devicetree/bindings/watchdog/ |
D | aspeed-wdt.txt | 44 - aspeed,ext-push-pull: If aspeed,external-signal is present, set the pin's 45 drive type to push-pull. The default is open-drain. 47 is configured as push-pull, then set the pulse
|
/Documentation/devicetree/bindings/net/ |
D | smsc911x.txt | 19 - smsc,irq-push-pull : Indicates the IRQ type is push-pull 42 smsc,irq-push-pull;
|
D | ti,k3-am654-cpts.yaml | 20 - hardware timestamp push inputs (HWx_TS_PUSH) 25 - external hardware timestamp push inputs (HWx_TS_PUSH) timestamping 80 Number of hardware timestamp push inputs (HWx_TS_PUSH)
|
/Documentation/devicetree/bindings/i2c/ |
D | i2c-mt65xx.txt | 34 - mediatek,use-push-pull: IO config use push-pull mode.
|
D | allwinner,sun6i-a31-p2wi.yaml | 7 title: Allwinner A31 P2WI (Push/Pull 2 Wires Interface) Device Tree Bindings
|
/Documentation/devicetree/bindings/net/can/ |
D | sja1000.txt | 35 <0x06> : TX0 push-pull 39 <0x30> : TX1 push-pull
|
/Documentation/devicetree/bindings/mfd/ |
D | st,stmfx.yaml | 72 drive-push-pull: true 116 drive-push-pull;
|
/Documentation/arm/keystone/ |
D | knav-qmss.rst | 21 queue pool management (allocation, push, pop and notify) and descriptor 25 allocate descriptor pools, map the descriptors, push/pop to queues etc. For
|
/Documentation/devicetree/bindings/input/ |
D | max77650-onkey.yaml | 32 The system's button is a slide switch, not the default push button.
|
D | cap11xx.txt | 33 high push-pull output.
|
/Documentation/networking/device_drivers/ethernet/amazon/ |
D | ena.rst | 140 - Low Latency Queue (LLQ) mode or "push-mode". 273 - Populates ena_buf for the push buffer (if the driver and device are 274 in push mode.) 284 * This function also copies the ENA descriptors and the push buffer 285 to the Device memory space (if in push mode.)
|
/Documentation/powerpc/ |
D | qe_firmware.rst | 128 | | push command | given by the application, the software must | 129 | | | assert a special host command (push command)| 135 | | push command | command (push command) and immediately | 150 | 3 | General push | Indicates that the s/w has to initialize | 156 | 4 | General push | Indicates that after issuing Ethernet TX |
|
/Documentation/accounting/ |
D | cgroupstats.rst | 15 The current model for cgroupstats is a pull, a push model (to post
|
/Documentation/devicetree/bindings/pinctrl/ |
D | qcom,pmic-gpio.txt | 199 - drive-push-pull: 202 Definition: The specified pins are configured in push-pull mode. 264 drive-push-pull;
|
D | pinctrl-sx150x.txt | 47 - drive-push-pull: drive actively high and low
|
D | st,stm32-pinctrl.yaml | 165 drive-push-pull: 253 drive-push-pull;
|
/Documentation/maintainer/ |
D | pull-requests.rst | 126 Now that you have a local signed tag, you need to push it up to where it 129 git push origin char-misc-4.15-rc1 155 a handy way to remember to actually push it to a public location.
|
/Documentation/devicetree/bindings/leds/ |
D | pca963x.txt | 7 - nxp,totem-pole : use totem pole (push-pull) instead of open-drain (pca9632 defaults
|
/Documentation/devicetree/bindings/soc/ti/ |
D | keystone-navigator-qmss.txt | 15 queue pool management (allocation, push, pop and notify) and descriptor 41 - Queue Management/Queue Proxy region for queue Push. 47 - Queue Management/Queue Proxy region for queue Push/Pop.
|
/Documentation/process/ |
D | 7.AdvancedTopics.rst | 90 So, once you push a set of changes to your publicly-available server, those 92 you try to push changes which do not result in a fast-forward merge 147 sure that you have remembered to push those changes to the public server.
|
/Documentation/devicetree/bindings/sound/ |
D | rt5682.txt | 31 The debounce delay for push button.
|
/Documentation/devicetree/bindings/iio/imu/ |
D | bosch,bmi160.yaml | 38 open drain. If not set, defaults to push-pull.
|
/Documentation/devicetree/bindings/power/supply/ |
D | bq2515x.yaml | 18 push-button controller.
|
/Documentation/nvdimm/ |
D | maintainer-entry-profile.rst | 41 to push back on the proliferation of NVDIMM command sets, so do strongly
|
/Documentation/admin-guide/ |
D | bug-hunting.rst | 229 push %ebp 230 push %edi 231 push %esi 232 push %ebx
|
123